Contents11 sections
This guide was first published in German on handgetestet.de.
If you only hang a mirror in the bathroom, you are giving away storage space. And if you choose a mirror cabinet on looks alone, you risk discovering during installation that the cable comes out of the wall in the wrong place. For most bathrooms with a 60 to 80 centimeter wide vanity, we consider a mirror cabinet with a built-in outlet and LED strip the most sensible solution, specifically the KHX 80, which Amazon lists under the name Sieper. A plain illuminated mirror is the choice where every centimeter of depth counts. And anti-fog? A nice convenience, but no reason to compromise on light and electrics.
First the wall, then the design
An illuminated bathroom mirror is a piece of electrical equipment in a room where water splashes. That is why installation in Germany is governed by the standard DIN VDE 0100-701. It divides the bathroom into protection zones. Zone 0 is the inside of the bathtub or shower tray. Zone 1 lies above it, up to a height of 2.25 meters or up to the highest permanently mounted water outlet. Zone 2 extends 60 centimeters to the side. Permanently installed devices with at least IPX4 are allowed there, but 230-volt outlets are not. The only exceptions are special shaver outlets. That is how the German trade portal Baunetz Wissen sums it up.
This affects every mirror cabinet with a standard (Schuko) outlet inside. If the vanity is right next to the shower, that very outlet may end up in zone 2. In addition, all circuits in the bathroom need a residual current device (RCD) rated at no more than 30 milliamperes. Since June 2025, a new edition of the standard has applied in which, according to DIN Media, the previous exceptions to this protection requirement have been dropped, among other things, and a separate zone 0 has been introduced for showers without a tray.
The consequence is simple. The connection and position of the outlet are planned by a qualified electrician, not by the online shop. The Swiss manufacturer Schneider also states explicitly that bathroom mirrors and mirror cabinets should be installed by an electrician. For the height, Schneider gives a practical guideline: bottom edge about 120 centimeters above the floor, adjusted accordingly for very tall or short people.
What the numbers on the data sheet reveal
Watts say little about brightness. The luminous flux in lumens, measured at the light source, is more meaningful; the higher the value, the brighter the source. The range is wide: according to the manufacturer, Jokey’s small Saphir cabinet reaches 540 lumens, the Batu 80 1,700 lumens. That is a good three times as much.
As for light color, almost all models in this comparison are at 4,000 kelvin, i.e., neutral white. Schneider describes neutral white (stated there as 4,500 K) as suitable for makeup because colors look true. The manufacturer names daylight white at 6,500 K for shaving and skincare. Adjustable light colors are a convenience. For a family bathroom, we consider a good neutral white sufficient.
And the protection rating? The IP code according to DIN EN 60529 has two digits. The first stands for protection against contact and foreign objects, the second for protection against water. For water, IP44 means protected against splashing water. That is exactly what the standard requires for permanently installed devices in zone 2. If no protection rating is given in the data sheet, the device belongs on a wall outside zones 1 and 2. Jokey does not state an IP rating for its mirror cabinets on the product pages; you should clarify this before buying, with your floor plan in mind.
Fog-free: the heating in the mirror
With Emco, Keuco and Schneider, mirror heating keeps the glass from fogging up. In its round PURE+ mirrors, Emco installs an integrated infrared mirror heater which, according to the installation instructions, switches on and off automatically with the light. Keuco and Schneider offer their own models with heating. This is practical in small bathrooms without a window. With a window and an exhaust fan, we consider it dispensable.
According to the manufacturers, none of the five models in our table has mirror heating. If you do not want to do without anti-fog, ask specifically for the heating information in the data sheet and check whether it is linked to the light or has its own switch.
Five mirrors and cabinets with documented data
| Model | Dimensions (W × H × D) | Light and electrics according to the manufacturer | Who it suits |
|---|---|---|---|
| Sieper/Jokey KHX 80 | 80.4 × 74 × 14.2 cm | LED strip, 825 lm, 4,000 K, outlet with light switch | Family bathroom with an 80 cm vanity |
| Jokey Batu 80 | 80 × 71.4 × 15.2 cm | 2 LED strips, 1,700 lm, 4,000 K, outlet with light switch | Anyone who wants lots of light at the sink |
| Jokey Saphir 60 | 60 × 51 × 18 cm | LED light strip, 540 lm, 4,000 K, outlet with light switch | Guest toilet, small basin |
| Kiamami Valentina 80 × 60 Touch | 80 × 60 × 2.5 cm | Backlit, 19 W, 4,200 K, touch switch, IP44 | Flat solution without storage |
| Kiamami Valentina 90 × 70 | 90 × 70 × 2.2 cm | All-round lighting, 15 W, 1,625 lm, 4,000 K, IP44, no switch | Hardwired via the room switch |
Sieper KHX 80: the solid standard
Jokey documents the KHX 80 with three crystal mirror doors with soft close, six adjustable glass shelves and an outlet with a light switch. The LED strip delivers 825 lumens at 4,000 kelvin and, according to the manufacturer, is replaceable. We weight this detail heavily. If the light source is permanently installed, a defect after a few years quickly turns into the question of whether the entire cabinet has to be replaced. At around 19.6 kilograms, it needs a load-bearing wall. The depth of 14.2 centimeters remains pleasantly unobtrusive above the basin.
Jokey Batu 80: twice as much light
Same width, similar features, but two LED strips with a combined 1,700 lumens. If you do your makeup at the mirror and the ceiling light hangs far back, you will benefit. According to Jokey, the three doors have a 3D effect, and inside there are six adjustable glass shelves. The manufacturer does not mention soft close here.
Jokey Saphir 60: small and light
A plastic cabinet 51 centimeters tall and weighing only 4.5 kilograms. Three mirror doors, two drawers, outlet with switch. At 540 lumens, the light is more for orientation than for working. That is enough for the guest toilet; for the main bathroom, we would choose one of the two 80 cm cabinets.
Kiamami Valentina 80 × 60 Touch: flat instead of storage
The Italian manufacturer states IP44, 19 watts and 4,200 kelvin for this backlit mirror. It is switched via a touch switch on the side and can be mounted horizontally or vertically. At 2.5 centimeters deep, it fits into narrow bathrooms where a cabinet door would catch on a sloping ceiling or a window sash. Kiamami Valentina does not give a lumen figure for this model.
Kiamami Valentina 90 × 70: without its own switch
A mirror with all-round lighting, 1,625 lumens, 4,000 kelvin and IP44 according to the manufacturer. What matters for planning is what is missing: it has neither an outlet nor a switch and is hardwired to the household wiring via a flat cable; the LED power supply is included. So it is switched on via a wall switch. That is a clean solution if there is already a light outlet on the wall. If not, it becomes a job for the electrician.
How we would decide
- Main bathroom with an 80 centimeter wide vanity: the KHX 80, because light, storage and outlet go well together and the LED strip can be replaced.
- Lots of light for makeup: the Batu 80 with twice the luminous flux, but without soft close.
- Guest toilet or rented apartment with a small basin: the Saphir 60. No more, but also no less than necessary.
- Little depth available: one of the two Kiamami mirrors; the shelf for toothbrushes will then have to go elsewhere.
For the width, Schneider gives a simple rule of thumb: the mirror cabinet follows the vanity, so a 60 cm cabinet fits a 65 centimeter wide basin. If you are also looking for a magnifying mirror, you will find it in our guide to makeup mirrors. If you are refitting the bathroom anyway, it is also worth looking at our guide to heated towel rails (in German). If the hair dryer is to be plugged into the outlet in the mirror cabinet from now on, our hair dryer guide will help you choose.
Which protection rating applies where and what heated mirrors can do is explained in our guide to infrared heating in the bathroom (in German).
Frequently asked questions
Where may a mirror cabinet with an outlet be installed in the bathroom?
The German standard DIN VDE 0100-701 divides the bathroom into protection zones. Zone 2 extends 60 centimeters to the side of the bathtub or shower; permanently installed devices with at least IPX4 are allowed there, but 230-volt outlets are not. If the vanity is right next to the shower, the outlet in the cabinet may end up exactly there.
How bright should a bathroom mirror be?
The luminous flux in lumens is more meaningful than watts. The range is wide: according to the manufacturer, the small Jokey Saphir reaches 540 lumens, the Batu 80 1,700 lumens. A guest toilet needs little light; if you do your makeup at the mirror, you benefit from more luminous flux.
Which light color makes sense in the bathroom?
Almost all models in the comparison are at 4,000 kelvin, i.e., neutral white. Schneider describes neutral white as suitable for makeup because colors look true, and names daylight white for shaving and skincare. Adjustable light colors are a convenience; for a family bathroom, a good neutral white is enough.
Does a bathroom mirror need mirror heating?
It is practical in small bathrooms without a window; with a window and an exhaust fan, it is considered dispensable. According to the manufacturers, none of the five models in the comparison has heating. If you want anti-fog, ask specifically about it and check whether the heating is linked to the light or has its own switch.
At what height should a mirror cabinet be hung?
Schneider gives a guideline of about 120 centimeters from the floor to the bottom edge, adjusted accordingly for very tall or short people. As for width: the mirror cabinet follows the vanity, so a 60 cm cabinet fits a 65 centimeter wide basin. According to Schneider, it should be installed by an electrician.
What does IP44 mean for bathroom mirrors?
The IP code according to DIN EN 60529 has two digits; the second stands for protection against water. IP44 means protected against splashing water, which the standard requires for permanently installed devices in zone 2. If the rating is missing, as with the Jokey cabinets, the device belongs on a wall outside zones 1 and 2.
Sources
- Jokey: KHX 80 mirror cabinet
- Jokey: Batu 80 mirror cabinet
- Jokey: Saphir mirror cabinet
- Kiamami Valentina (KV Store): LED mirror 80 × 60 with touch sensor
- Kiamami Valentina (KV Store): Bathroom mirror 90 × 70 with LED
- Baunetz Wissen: Electrical installation in rooms with a bathtub or shower
- Baunetz Wissen: Protection ratings and IP code
- DIN Media: DIN VDE 0100-701:2025-06
- Schneider: Mirror cabinets, installation and sizing notes
- Schneider: FAQ on mirror heating and light colors
- Emco: PURE+ LED illuminated mirror with mirror heating
Where to buy
- Sieper/Jokey KHX 80Check price at Amazon.de
- Jokey Spiegelschrank Batu 80Check price at Amazon.de
- Jokey Spiegelschrank Saphir 60View at OTTOCheck price at Amazon.de
- Kiamami Valentina 80 × 60 TouchCheck price at Amazon.de
- Kiamami Valentina 90 × 70Check price at Amazon.de
