Contents13 sections
This guide was first published in German on handgetestet.de.
An ultrasonic bath gets a pair of glasses cleaner in three minutes than any cleaning cloth. It can, however, ruin the ring with an opal, the pearl necklace and the automatic watch. If you know that before buying, you don’t need a large device: for glasses, a wedding ring and a stainless steel bracelet, a tank with just over half a liter of working volume is enough. Our pick is the EMAG Emmi-08STH, because it combines a stainless steel housing, a timer of up to 15 minutes and heating that can be switched off in a compact format.
What actually happens in the bath
Under the stainless steel tank sits a transducer that sets the water in motion tens of thousands of times per second. This creates tiny bubbles that collapse again immediately. The process is called cavitation, and it loosens dirt from crevices no brush can reach: skin oil in the hinge of your glasses, soap residue under a setting, dust between the links of a watch bracelet.
Clear water alone is often not enough. Elma, a manufacturer of professional equipment, explains that surfactants lower surface tension and thus promote cavitation. According to the Sanitas instructions, a drop of mild dish soap is enough. For its EM-080 universal concentrate, EMAG specifies a dilution of 1 to 5 percent and explicitly excludes contact lenses and coated glasses.
Frequency: a figure that separates less than it promises
The boxes say 35, 40 or 45 kHz. Elma classifies the entire range from 25 to 40 kHz as low frequency, which produces large, high-energy bubbles. It only gets truly gentle at 80 to 130 kHz, in other words in laboratory equipment. We therefore would not choose a device based on 35 versus 45 kHz. What matters more is whether the power can be adjusted and whether a basket is included that keeps the items off the bottom of the tank.
Tank size: measure instead of guessing
This is where the real buying decision lies. The manufacturer states the tank capacity, but you only fill up to the mark. On the Emmi-04D, the tank holds 0.6 liters, while the working fill volume is 0.4 liters. Length is what matters anyway. Place your folded glasses on a ruler and compare with the inside dimensions of the tank. Only the ruler will tell you whether 16 or 18 cm is enough.
Measure first, then order.
Two liters sound like a reserve. For a single pair of glasses, that just means more water, longer heating and a device that permanently takes up space on the shelf. The large tank makes sense if watch straps, cutlery or bicycle parts are going in too.
Heating: helpful with grease, not with glasses
Warm water dissolves grease and polishing paste faster; Elma counts temperature, along with cleaning agent and time, among the decisive factors. For glasses, the opposite applies: in the instructions for its ultrasonic cleaner, Sanitas says to use only cold or lukewarm water. EMAG points out that the ultrasound itself can heat the water considerably and that the heating should only run together with the ultrasound, otherwise the tank may discolor. Heating therefore makes sense if it can be finely adjusted or switched off completely.
For glasses, it stays off.
What does not belong in an ultrasonic bath
Here even the manufacturers contradict each other. In its instructions, EMAG lists pearls and emeralds as examples for ultrasonic cleaning. Sanitas explicitly warns against pearls, mother-of-pearl, emerald, opal, coral, turquoise, lapis lazuli, malachite, black onyx and tiger’s eye. The Gemological Institute of America (GIA) is clearly on the cautious side: pearls should never go into an ultrasonic or steam cleaner. The GIA also names organic materials such as amber, coral and tortoiseshell, filled diamonds and emeralds, as well as star rubies and star sapphires, as unsuitable. We follow that line. A second danger concerns set stones. The vibration can loosen stones, and the GIA advises checking the settings before and after every cleaning. If you have an heirloom ring with an unknown history, take it to a jeweler instead.
With glasses, according to EMAG and Sanitas, the lens coating can come off. EMAG recommends checking with your optician first, and the lenses must not touch the bottom of the tank. We would place the glasses in the basket lenses up and limit it to one cycle of 90 seconds to three minutes.
Watches are the third borderline case. Sanitas only allows water-resistant quartz watches with a metal strap, rated for at least 30 meters of water depth. Older watches can start leaking and should be checked beforehand. Mechanical watches with automatic winding are off-limits because the hairspring can become magnetized, after which the watch runs inaccurately. If you own an automatic watch (in German), put only the removed metal bracelet in the bath. What the rating in meters means is explained in our guide to the dive watch (in German).
Five ultrasonic cleaners at a glance
| Model | Tank / fill volume | Frequency and power | Heating | Best for |
|---|---|---|---|---|
| EMAG Emmi-04D | 0.6 l / 0.4 l | approx. 45 kHz, 40 W | none | Glasses and rings, little space |
| EMAG Emmi-08STH | 0.8 l / 0.6 l | approx. 40 kHz, up to 60 W | 20 to 80 °C, 140 W | Glasses, jewelry, watch strap |
| EMAG Emmi-D21 | 2.0 l / 1.5 l | approx. 35 kHz, 80 W | up to 60 °C, 100 W | larger items, plastic housing |
| EMAG Emmi-20HC | 2.0 l / 1.5 l | approx. 40 kHz, 120 W, adjustable | 20 to 80 °C, 200 W | Workshop and household |
| Allpax Palssonic Basic 2 Liter | 2 l | 40 kHz, 60 W | 20 to 80 °C, 100 W | tall items, continuous operation |
All specifications according to the manufacturer.
EMAG Emmi-04D
The smallest device in the lineup. The stainless steel tank measures 160 × 90 × 50 mm inside, the housing is plastic, and the timer goes up to seven minutes. That works well for rings, stud earrings and narrow glasses. There is no heating, which is not a drawback for glasses. Measure wide sunglasses beforehand.
EMAG Emmi-08STH
Housing and tank are made of 1.4301 stainless steel, and the tank measures 180 × 90 × 50 mm inside. EMAG specifies a working fill volume of 0.6 liters, around 40 kHz and a maximum of 60 W ultrasonic power. The heating can be set from 20 to 80 °C, and the timer runs from one to 15 minutes or continuously. For glasses and jewelry, the heating stays off; for a greasy watch strap, it can run. That range makes it our pick.
EMAG Emmi-D21
Two liters in a light plastic housing. According to the instructions, the D21 heats to a maximum of 60 °C and switches the heating off by itself after 45 minutes. The timer only offers 5, 10 and 15 minutes. Short cycles of one to three minutes are therefore not possible. The D21 makes more sense for cutlery, combs or tools.
EMAG Emmi-20HC
For a jewelry box, the Emmi-20HC is already a serious tool. 120 W ultrasonic power, 200 W heating, timer up to 60 minutes. Its advantage is the power control with 50, 75 and 100 percent. This lets you dial back the intensity for more delicate items. If you only clean glasses, you are bringing reserves into the bathroom that you will never need.
Allpax Palssonic Basic 2 Liter
At 15 × 14 × 10 cm, the tank is deep rather than long, which accommodates tall objects such as mugs or threaded parts better than a pair of glasses. Allpax specifies 60 W at 40 kHz, 100 W heating from 20 to 80 °C and a timer from one to 20 minutes or continuous operation. The stainless steel housing is protected to IPX4, and the device weighs 3.2 kg. Allpax recommends wearing gloves and tight-fitting safety goggles while working.
How we would decide
- Only glasses and rings, little space in the bathroom: EMAG Emmi-04D, after measuring your glasses.
- Glasses, jewelry and occasionally a watch strap: EMAG Emmi-08STH, heating only for grease.
- Cutlery, tools, combs: EMAG Emmi-D21.
- If you also clean workshop parts and want to adjust the power: EMAG Emmi-20HC.
- Tall objects and long run times: Allpax Palssonic Basic 2 Liter.
A few rules apply to every device. Fresh tap water contains air; EMAG recommends running the device empty for a few minutes before putting the items in. Don’t place anything directly on the bottom of the tank; use the basket. Sanitas advises starting no more than three cycles in a row and then letting the device cool down for about five minutes. Denatured alcohol, petroleum spirit or isopropanol never belong in the bath because of the risk of explosion. And after cleaning, rinse briefly under running water so that loosened dirt does not dry back on.
We tried one retail device ourselves: in our review of the Grundig UC 6620, no cleaning effect was visible on the watch strap, glasses or necklace.
Frequently asked questions
What should not go into an ultrasonic cleaner?
The GIA advises never putting pearls in an ultrasonic bath, nor amber, coral, filled diamonds and emeralds, or star rubies and star sapphires. Sanitas also warns against opal, turquoise, lapis lazuli and malachite. Because the vibration can loosen set stones, check the settings before and after cleaning.
Can I clean my glasses in an ultrasonic bath?
Yes, but carefully. According to EMAG and Sanitas, the lens coating can come off, so EMAG recommends checking with your optician first. The lenses must not touch the bottom of the tank, and Sanitas specifies only cold or lukewarm water. One cycle of 90 seconds to three minutes is enough.
How large should the tank of an ultrasonic cleaner be?
Length matters, not the liter figure. Place your folded glasses on a ruler and compare with the inside dimensions of the tank. Two liters only make sense if watch straps, cutlery or bicycle parts are going in; for a pair of glasses, it just means more water.
Does the frequency matter?
Less than the boxes promise. Elma classifies the entire range from 25 to 40 kHz as low frequency; it only gets gentle at 80 to 130 kHz, in laboratory equipment. What matters more is whether the power can be adjusted and whether a basket is included.
Do I need an ultrasonic cleaner with heating?
Warm water dissolves grease and polishing paste faster, so for a greasy watch strap the heating can run. For glasses, it stays off. Heating that can be finely adjusted or switched off completely makes sense, as on the EMAG Emmi-08STH from 20 to 80 °C.
Can a watch go into an ultrasonic bath?
Sanitas only allows water-resistant quartz watches with a metal strap, rated for at least 30 meters of water depth. Mechanical watches with automatic winding are off-limits because the hairspring can become magnetized. With an automatic watch, only the removed metal bracelet goes into the bath.
Sources
- EMAG: Emmi-08STH, technical data
- EMAG: Emmi-04D, technical data
- EMAG: User manual 04D, 05P, 07D, D21 (PDF)
- EMAG: Product catalog with technical data (PDF)
- Allpax: Palssonic Basic ultrasonic cleaner 2 liters
- Sanitas: Instructions for use, ultrasonic cleaner SUR 42 (PDF)
- Elma: Ultrasonic cleaning, frequency and cleaning chemistry
- GIA: Ultrasonic Cleaners for Gems
- GIA: Pearl Care and Cleaning Guide
Where to buy
- EMAG Emmi-08STHCheck price at Amazon.deAvailable in Germany: Amazon.de
- EMAG Emmi-04DCheck price at Amazon.deAvailable in Germany: Amazon.de
- EMAG Emmi-D21Check price at Amazon.deAvailable in Germany: Amazon.de
- EMAG Emmi-20HCCheck price at Amazon.deAvailable in Germany: Amazon.de
- Allpax Palssonic Basic 2 LiterCheck price at Amazon.deAvailable in Germany: Amazon.de
