Black Friday Woche ab 19.11.: unsere Wahl je Ratgeber
Independent buying adviceEvery claim with a sourceNo paid verdicts1,731 guides and reviews in German How we test
handgetestet

Deutsch

Buying Stair Lighting with a Motion Sensor 2026

Stair lighting with a motion sensor: light strip, step light or night light, with batteries, rechargeable battery or 230 volts. Six solutions compared.

handgetestet editorial team · Updated November 16, 2026
Contents11 sections

This guide was first published in German on handgetestet.de.

At three in the morning, nobody wants to be dazzled on the stairs. What’s needed is light that comes on before the first step, shows the step edges and disappears again shortly afterward. For a typical indoor staircase in a single-family home, we therefore recommend a light strip with two sensors, top and bottom, such as Paulmann’s LED Stair Strip Sensor Set. It runs on batteries or permanently on a USB-C power adapter and doesn’t need an electrician. If you’re renovating and have flush-mounted boxes in the stairwell wall, permanently wired step lights are more convenient in the long run.

Look at the staircase first, then the light

The most important question sounds trivial. Where does the power come from? Battery and rechargeable lights are stuck or screwed on and mounted in ten minutes, but require regular charging or new cells. A light strip with a USB-C port can do both: batteries to start with, continuous power from a plug-in adapter as soon as there’s an outlet nearby. Step lights for flush-mounted boxes, by contrast, are permanently connected to the 230-volt mains, never need maintenance and are the cleanest solution if the wiring is already in place anyway. Technology that works without renovation is covered in more detail in the guide Smart home for renters (in German).

  • Sensors at both ends. A staircase is entered from the top and the bottom. A single sensor at the foot of the stairs is of little help when going down.
  • Dusk sensor. Without it, the light also comes on at midday and drains the batteries.
  • Adjustable run-on time. The light has to stay on until even the slowest family member has reached the top.
  • Light color. Warm white at 2,700 to 3,000 kelvin feels calmer at night than neutral white light at 4,000 kelvin.
  • Read lumens correctly. A 10-lumen night light marks a step. It can’t light the staircase.

Sensors that can do more than switch lights, such as alarms or heating, are presented in the guide Smart motion sensors (in German).

What accident prevention says about stairs

According to the German home safety initiative Aktion Das Sichere Haus (DSH), trips and falls on stairs are among the most common accidents in the home. The initiative recommends lighting stairs brightly and glare-free and additionally marking the first and last steps, for example with a luminous strip. The light should fall downward. The DSH explicitly calls lamps with a motion sensor, light sensor and battery operation practical, and for motion sensors on paths around the house, it recommends a generously set timer.

Lights for flush-mounted boxes involve work on the electrical installation. Under the German standard DIN VDE 0105-100, laypeople may only take part in installing and modifying electrical systems under the direction and supervision of a qualified electrician. So plan the tradesperson in from the start.

Six solutions side by side

ModelPowerSensor (manufacturer information)LightBest for
Paulmann LED Stair Strip Sensor Set 711208 × AA or USB-C (5 V)2 infrared sensors with dusk sensor, up to 4.5 m, 120°5 m strip, 3,000 K, can be cut every 10 cmIndoor stairs without wiring
Paulmann Tsaro (Lead 80002/80003/80004)230 V, 68 mm flush-mounted boxHF sensor with dusk sensor, up to 3 m, controls followers by radio80 lm per light, 2,700 KNew builds and renovations
Ledvance Nightlux Stair3 × AAA (included)Infrared and light sensor, Auto/On/Off switch10 lm, 4,000 K, IP54Marking individual steps
Ledvance Linear LED Mobile USB 200Rechargeable battery 1,800 mAh, USB-CInfrared, 0 to 3 m, 120°, threshold 30 lx69 lm, 4,000 KLanding, hallway
Paulmann LED Strip 78900mains-independent, USB portInfrared with dusk sensor, up to 4 m, 100°1 m, 140 lm, 3,000 KShort stairs, dark corners
Philips Hue Motion Sensor2 × AAA0 to 5 m, daylight threshold via appswitches existing Hue lampsHouseholds with a Hue Bridge

Paulmann LED Stair Strip Sensor Set: one strip, two guards

Five meters of warm white strip, plus two wired motion sensors with dusk sensor: that’s how the set covers both ends of the stairs. According to Paulmann, the sensors detect up to 4.5 meters at an angle of 120 degrees, and the light duration and trigger threshold can be adjusted. The strip sticks under the steps or on the stair stringer and can be cut every 10 centimeters. Power comes from eight AA batteries or permanently from a USB-C port. The manufacturer doesn’t state a protection rating, so the set belongs indoors. For the ordinary indoor staircase, we consider this the most coherent solution.

Paulmann Tsaro: for the flush-mounted box

Tsaro is a system. The Lead lights (80002 white, 80003 chrome, 80004 black) carry a high-frequency sensor with a dusk switch that, according to the manufacturer, detects movement up to three meters and then switches all Follower lights on the same frequency by radio. The run-on time can be set between 30 seconds and five minutes. Each light sits in a standard 68-millimeter flush-mounted box and runs directly on 230 volts, without a transformer. Followers can also be operated on their own via a normal light switch. If you don’t already have the boxes in the wall, you’re facing chiseling work, and then the effort only pays off during a renovation.

Ledvance Nightlux Stair: orientation, not illumination

Small, flat, with three AAA batteries in the box. The light shines down onto the step and has an infrared sensor, a light sensor, and a switch for automatic or continuous operation. At 10 lumens and 4,000 kelvin, it’s a marker light. Despite the IP54 protection rating, Ledvance states a temperature range of 0 to 25 degrees Celsius, so it isn’t intended for an outdoor staircase in winter. It’s mounted with adhesive tape or screws.

Ledvance Linear LED Mobile USB: rechargeable instead of batteries

The 20-centimeter aluminum bar has a built-in 1,800 mAh battery that, according to Ledvance, charges via USB-C in three and a half hours. The infrared sensor responds up to three meters at an angle of 120 degrees and only below 30 lux, so really only when it’s dark. The light is neutral white. It suits the landing or the hallway outside the bedroom well, but a single unit isn’t enough for the whole staircase.

Paulmann LED Strip 78900: one meter for corners

A self-adhesive strip one meter long, with a built-in motion sensor including dusk sensor and warm white light. According to Paulmann, the sensor detects up to four meters at 100 degrees, and at full brightness the strip shines for three hours at a stretch. It’s intended for three or four steps down to the basement or for the bend in the stairwell. For a long staircase, the 71120 set with two sensors is the more coherent choice.

Philips Hue Motion Sensor: if Hue lamps are already installed

The sensor doesn’t make light itself. It switches Hue lamps that are already installed in the stairwell or hallway, and it needs a Hue Bridge for that. Philips states a detection range of up to five meters, protection rating IP20 and two AAA batteries; you set the daylight threshold in the app. The appeal is that no additional light has to go on the wall. Without Hue lamps, it’s the wrong purchase. Which lamps go with it is covered in the guide Smart lamps.

Which solution suits which house

  • Indoor staircase with twelve or more steps, no wiring in the wall: Paulmann LED Stair Strip Sensor Set 71120, ideally on a USB-C power adapter.
  • Renovation or new build with flush-mounted boxes: Paulmann Tsaro, one Lead light at each end of the stairs, Followers in between. Connection by a qualified electrician.
  • Just make the first and last steps visible: two Ledvance Nightlux Stair. They don’t give more light than that.
  • Landing, hallway to the bathroom: Ledvance Linear LED Mobile USB. If you hate changing batteries, take the rechargeable one.
  • Hue system in place: Philips Hue Motion Sensor at the top and bottom, plus the lamps that are already installed.

Our final advice: better to have the sensors trigger too early than too late. A light that only comes on at the third step is almost as good as none at night.

For the front entrance and driveway outside, different rules apply regarding protection rating and range; see the guide to outdoor motion sensors (in German).

Besides light, the tread surface also makes a staircase safer. What well-adhered stair treads achieve and what matters when measuring is covered in the stair treads guide (in German).

Frequently asked questions

What should you look for in stair lighting with a motion sensor?

Sensors at both ends, because a staircase is entered from the top and the bottom. Plus a dusk sensor so the light doesn't come on at midday, an adjustable run-on time, and warm white light at 2,700 to 3,000 kelvin, which feels calmer at night.

Batteries, rechargeable battery or hardwired: which makes more sense?

Battery and rechargeable lights are mounted in ten minutes but require charging or new cells. A light strip with USB-C can do both. Step lights for flush-mounted boxes are permanently connected to the 230-volt mains, never need maintenance and are the cleanest solution if the wiring is already in place.

Can I connect flush-mounted step lights myself?

Under the German standard DIN VDE 0105-100, laypeople may only take part in installing and modifying electrical systems under the direction and supervision of a qualified electrician. So with lights like Paulmann Tsaro, plan the tradesperson in from the start.

Is a 10-lumen night light enough for the stairs?

It marks a step, but it can't light the staircase. The Ledvance Nightlux Stair is such a marker light. Two of them make the first and last steps visible; they don't give more light than that.

What does accident prevention recommend for stairs?

The German home safety initiative Aktion Das Sichere Haus recommends lighting stairs brightly and glare-free and additionally marking the first and last steps, for example with a luminous strip. The light should fall downward. It explicitly calls lights with a motion sensor, light sensor and batteries practical.

Is the Philips Hue Motion Sensor worth it for the stairs?

Only if Hue lamps are already installed in the stairwell or hallway and a Hue Bridge is available. The sensor doesn't make light itself; it switches the existing lamps. According to Philips, it detects up to five meters. Without Hue lamps, it's the wrong purchase.

Sources

Where to buy

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.