Black Friday Woche ab 19.11.: unsere Wahl je Ratgeber
Independent buying adviceEvery claim with a sourceNo paid verdictsIn 36 countries1,734 guides and reviews in German How we test
handgetestet

Deutsch

Buying Dining Chairs 2026: Seat Height, Padding, Upholstery

Buying dining chairs: which seat height suits your table, cantilever or four-leg frame, microfiber or synthetic leather, and how much load capacity you need.

handgetestet editorial team · Updated November 17, 2026
Contents13 sections

This guide was first published in German on handgetestet.de.

A dining chair can be softly padded and beautifully upholstered and still not fit, because it is three centimeters too high for the table. So measure the table height first and subtract around 30 cm: at a 75 cm table you end up at about 45 cm seat height, at a 78 cm table at 48 cm. After that, load capacity decides. We recommend models for which the manufacturer states at least 120 kg, such as the Capri cantilever chair from Niehoff or the 2133 model from Mayer Sitzmöbel (a German seating manufacturer), both sold through specialist furniture retailers.

How high can the chair be in relation to the table?

In its dining table guide, IKEA gives a guideline of about 30 cm between the seat and the top of the table. That is a rule of thumb, not a law. Taller people prefer a little more clearance, shorter people less.

With upholstered chairs, the catalog figure is misleading. Niehoff explains in its glossary that the upholstery construction leads to different nominal seat heights, and that under average load the actual height is about 46 to 47 cm. A chair listed at 48 or 49 cm on the spec sheet therefore sits lower than the number suggests. A wooden chair at 45 cm, on the other hand, stays at 45 cm.

The typical bad buy happens at tables with a wide apron. The top is 75 cm high, but underneath runs a frame of eight or ten centimeters. Then your thighs bump into it. So measure the underside as well, especially if you like a chair with armrests. If you are still looking for the table, you will find the right dimensions in our dining table guide.

Cantilever, four legs or swivel base?

A cantilever chair stands on a continuous runner and gives slightly when you lean back. Many people find that comfortable during long evenings at the table. On parquet, though, you should take a close look: Niehoff points out that cantilever chairs have soft plastic glides that are only partly suitable for solid wood floors, and advises checking suitability or using protective mats.

Four legs are the calmer choice. The chair does not flex, and felt glides for parquet are easy to stick on underneath. Mayer Sitzmöbel offers a third option: the 2133 model is available with a cantilever frame or with a swiveling star base with automatic return, so the chair turns back by itself after you stand up. Handy at a corner bench. Unusual for anyone who likes to sit still while eating.

Which upholstery can take what?

Synthetic leather can be wiped with a damp cloth and therefore seems family-friendly. But it ages differently from leather. Niehoff describes synthetic leather as made of polyurethane, which wears out sometimes faster, sometimes slower due to hydrolysis. Microfiber feels soft, does not pill according to Niehoff and keeps its shape, but it is sensitive to strong sunlight. If the table stands by a south-facing window, that is a real argument.

With fabrics, ask about the rub count. The value describes how much abrasion an upholstery fabric withstands in a standardized test; Niehoff classifies values above 20,000 as highly durable. And before buying, find out whether the cover is removable. According to the manufacturers, on the IKEA KRYLBO and the Woodkings models it is fixed and not washable, so stains have to be treated on the chair.

How much space does each chair need?

IKEA allows 55 cm of table width per person. Between the table edge and a wall or cabinet, IKEA recommends the chair depth plus 30 cm so that nobody gets wedged in when standing up. A slim chair like the 46 cm wide Mayer 2008 fits well into this grid. The Woodkings Wingston, at 69 cm, is considerably wider: at a 180 cm table, only two of them fit per long side where three would otherwise have room.

Six dining chairs compared

ModelFrame and upholsterySeat heightLoad capacityBest for
Niehoff Capri SchwingstuhlCantilever, brushed stainless steel or black iron, microfiber48 cm142 kgCantilever fans with a specialist retailer nearby
Mayer Sitzmöbel 2133Cantilever or swiveling star base, black powder-coated, fully upholstered47 cm150 kgHouseholds with a corner bench or changing guests
Mayer Sitzmöbel 2008Four legs, cantilever or star base, black or stainless steel look, fully upholstered48 cm120 kgSmall dining nooks
IKEA KRYLBOFour steel legs, fixed polyester cover49 cmtested for 110 kgHigher tables from about 78 cm
Woodkings KentonCantilever with handle, suede-look fabric48 cm100 kgLighter users, sold as a set of 2
Woodkings Wingston XXLFour steel legs, synthetic leather, 67 cm seat width47 cm250 kgHeavier people and anyone who wants to sit wide

Niehoff Capri: cantilever chair with reserves

For the Capri with cantilever frame (Schwingstuhl means cantilever chair), Niehoff states a load capacity of 142 kg, and the seat height is 48 cm. It is upholstered in microfiber, and the frame comes in brushed stainless steel or black iron. It is delivered partially assembled. You buy it through furniture retailers; the dealer locator is on the manufacturer’s website.

Mayer Sitzmöbel 2133: one chair, two frames

According to Mayer, the upholstered chair from Redwitz, Germany, supports up to 150 kg, the highest rating among the specialist retail models here. Seat and back are fully upholstered. You choose between a cantilever frame and a swiveling star base, both black powder-coated. The cover comes from three fabric price groups.

Mayer Sitzmöbel 2008: slim enough for the kitchen

With an overall width of 46 cm, the 2008 is one of the slimmest chairs in the comparison; Mayer describes it as suitable for smaller kitchen tables. The seat height is 48 cm, the load capacity 120 kg. Four legs, cantilever and star base are available, each in black powder coating or a stainless steel look.

IKEA KRYLBO: high and firmly padded

At 49 cm, the KRYLBO sits higher than the other models; at a 72 cm table, things get tight. IKEA states that the chair is tested for 110 kg and meets the durability and safety requirements of EN 12520 and EN 1022. The seat consists of foam with a density of 25 kg/m³ on plywood. It is available from IKEA.

Woodkings Kenton: cantilever chair with a limit

The Kenton comes as a set of 2, with suede-look fabric upholstery, a black runner frame and an integrated handle for moving it. Woodkings states a seat height of 48 cm and a load capacity of up to 100 kg. That is tight. For adults over 90 kg, we would not choose it.

Woodkings Wingston XXL: wide and sturdy

Woodkings designs the Wingston for 250 kg, with a steel frame, synthetic leather upholstery and 10 cm thick foam padding. The seat measures 67 cm in width, and the seat height is 47 cm. It has no armrests. It solves a real problem but needs a lot of space at the table in return.

How we would decide

  • Cantilever chair for everyday use: Niehoff Capri, because load capacity and seat height suit a 76 cm table.
  • Corner bench and several guests: Mayer 2133 with star base, if nobody minds the swiveling.
  • Small kitchen: Mayer 2008 with four legs; it needs the least width.
  • High table from 78 cm: IKEA KRYLBO, provided 110 kg is enough.
  • People over 120 kg: Woodkings Wingston XXL, if the table is long enough.
  • Lighter users who want to order online: Woodkings Kenton as a set of 2.

Different rules apply on the patio. Outdoors, weather resistance and the frame are what matter; more on that in our guide to the garden dining set (in German).

Frequently asked questions

How high should a dining chair be in relation to the table?

IKEA gives a guideline of about 30 cm between the seat and the top of the table. With upholstered chairs, the catalog figure is misleading: according to Niehoff, the actual height under average load is about 46 to 47 cm. Also measure the underside of the table apron, or your thighs will bump into it.

Is a cantilever chair suitable for parquet?

Only with caution. Niehoff points out that cantilever chairs have soft plastic glides that are only partly suitable for solid wood floors, and advises checking suitability or using protective mats. With four-leg chairs, felt glides are easy to stick on underneath.

Synthetic leather or microfiber: which upholstery holds up better?

Synthetic leather can be wiped with a damp cloth but, according to Niehoff, wears out sometimes faster, sometimes slower due to hydrolysis. Microfiber does not pill and keeps its shape but is sensitive to strong sunlight. With fabrics, ask about the rub count; Niehoff classifies values above 20,000 as highly durable.

How much space does a dining chair need at the table?

IKEA allows 55 cm of table width per person and recommends the chair depth plus 30 cm between the table edge and the wall. The 46 cm wide Mayer 2008 fits this grid well. Of the 69 cm wide Woodkings Wingston, only two fit per long side at a 180 cm table.

Which dining chair supports heavy people?

According to the manufacturer, the Woodkings Wingston XXL is designed for 250 kg, with a steel frame and a 67 cm seat width, but it needs a lot of space at the table. Among the models from specialist retailers, the Mayer 2133 supports up to 150 kg according to Mayer. The Woodkings Kenton, rated at 100 kg, has little margin.

Sources

Where to buy

Shop in:

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.