Contents17 sections
This guide was first published in German on handgetestet.de.
Almost any inverter will do for the laptop power supply in a van. For the coffee maker in the motorhome, it will not. If you want 230 volts from a 12-volt battery, plan the cables, fuse and battery first and only then pick the device. For occasional loads up to 1,000 watts, we consider the heicko HighPowerSinus HPLS1000-12 with pure sine wave output the most sensible purchase; if you leave the inverter on for days, the more economical Victron Phoenix 12/800 serves you better.
Pure or modified sine wave: does it really make a difference?
Yes. heicko writes in its own manual that devices with sensitive electronics do not run on modified sine wave power, citing measuring instruments, coffee pod machines and electronically controlled charging stations as examples. Typical signs are humming, unusual heat or the device failing. With pure sine wave, according to heicko, no restrictions on the type of load are known. That is why our selection includes only pure sine wave inverters.
How much power do I need, continuous or peak?
Continuous power is what counts. It has to carry all the devices running at the same time. Peak power only helps at switch-on: heicko specifies it for about 0.3 seconds, Ective for the SI series at twice the rated power for 2 seconds. According to heicko, refrigerators, compressors and pumps need two to eight times their rated power when starting up.
Victron calculates in volt-amperes. The Phoenix 12/800 delivers 800 VA, which according to the data sheet is 650 watts at 25 degrees and only 560 watts at 40 degrees. In a heated-up panel van, it is the second figure that counts. And one piece of advice up front: a compressor cooler (in German) runs directly on 12 volts. Taking the detour through an inverter, you lose 10 to 15 percent with each conversion.
Why is the cigarette lighter socket not enough?
Because, according to heicko, it is usually fused at 8 to 20 amps. At 10 amps, that leaves about 120 watts. From 150 watts, the manufacturer recommends connecting directly to the battery. You can estimate the current on the 12-volt side by dividing the power by 12. For the HPLS1000-12, heicko specifies a rated input current of 98 amps, and for the HPLS2000-12 as much as 196 amps. These are currents at which a cable that is too thin gets hot.
Which cable cross-section, which fuse?
Stick to the manufacturers‘ tables. For the 12/800, Victron requires 16 mm² up to 1.5 meters of cable length and 25 mm² up to 3 meters; if the cable is longer than 1.5 meters, an additional fuse belongs close to the battery. For the SI 10 at 12 volts, Ective specifies 16 mm² at one meter, 35 mm² at two and 50 mm² at three meters, plus a 175-amp fuse in the positive cable. So the cross-section grows faster than the length. That is why the inverter sits as close to the battery as possible.
Larger devices are connected with two cable sets. For the SI 15 and TSI 15, Ective explicitly warns of a cable fire if only one set is installed; heicko says the same for devices from 1,500 watts and allows only the supplied cables or equivalent replacements. Permanent installation in a vehicle or on a boat belongs in the hands of a qualified electrician. Victron requires this for its devices, and heicko refers to the German standard DIN VDE 0100 Part 717.
Is my battery big enough, and what does idle draw eat up?
Ective specifies minimum capacities: for the SI 10 at 12 volts, at least 160 Ah with lead-acid, gel or AGM batteries, or 90 Ah with lithium iron phosphate. Below that, the voltage collapses. heicko works through an example in its manual: 60 Ah, a 70-watt load, just under nine hours on paper. In practice, the manufacturer recommends dividing the result by three. So just under three hours.
If the inverter is connected to the starter battery, heicko says the engine should run every one to two hours so that it will still start later. While driving, a heicko inverter clamped directly to the battery must not remain connected. How your battery is doing is covered in the car battery guide (in German) and the guide to the battery charger (in German).
Idle draw is often underestimated. heicko specifies up to 1.5 amps for the HPLS series; over 24 hours, that is 36 Ah without any device running. Ective specifies about 0.7 amps for the SI 10. Victron’s 12/800 comes to 6.5 watts, and about 1 watt in ECO mode. In a camper, you notice that on day three.
What does a transfer switch do?
At a campsite with shore power, a shore power transfer switch passes the grid power through to the socket. If it drops out, the battery takes over. With the Ective TSI 15, this takes less than 16 milliseconds according to the manufacturer. Ective therefore speaks of an uninterruptible power supply. In ECO mode, the TSI reverses the order and uses the battery first until a minimum voltage is reached. Victron solves this with a separate switch called Filax. What you must never do: connect the output of an inverter to another power source or the household grid. Ective and heicko both stress this.
Do I have to ground it, do I need an RCD?
That depends on the device, and the manuals differ. heicko only permits operation indoors and in closed vehicles. If a device is used outside the vehicle, heicko requires an all-pole residual current device (RCD) with 30 mA between inverter and load and a ground connection of at least 6 mm². Ective supplies a so-called IT system and requires the ground terminal to be connected to a protective earth in every case. Victron requires the housing to be grounded; whether a grounded neutral is needed should be decided by a qualified electrician according to local regulations. heicko and Ective also exclude vehicles in which the positive terminal is connected to the chassis.
Which inverters are worth considering?
| Model | Continuous / peak according to the manufacturer | Idle draw according to the manufacturer | Best for |
|---|---|---|---|
| heicko HighPowerSinus HPLS1000-12 | 1,000 W / 2,000 W (0.3 s) | under 1.5 A | occasional coffee, tools, laptop |
| heicko HighPowerSinus HPLS2000-12 | 2,000 W / 4,000 W (0.3 s) | under 1.5 A | hair dryer, electric kettle, large house battery |
| Victron Phoenix 12/800 VE.Direct | 650 W at 25 °C / 1,500 W | 6.5 W, ECO about 1 W | continuous use in a camper or boat |
| Ective SI 10 | 1,000 W / 2,000 W (2 s) | approx. 0.7 A | permanent installation with remote control |
| Ective TSI 15 | 1,500 W / 3,000 W (2 s) | approx. 0.9 A | campers with shore power |
| Ective SI 5 | 500 W / 1,000 W (2 s) | approx. 0.6 A | small loads, smaller battery |
heicko HighPowerSinus HPLS1000-12
According to ELV (German retailer), the inverter delivers 1,000 watts of continuous power and protects itself against overload, short circuit, overheating and deep discharge. The cables for bolting it firmly to the battery are included. For occasional users, that is convenient. There are weaknesses too: 85 percent efficiency, up to 1.5 amps of idle draw, no app. So switch it off after use.
heicko HighPowerSinus HPLS2000-12
The big brother manages 2,000 watts of continuous power and weighs about six kilos. Two pairs of battery cables are included, and both must be connected. The device only makes sense with a powerful house battery, because almost 200 amps flow at full load.
Victron Phoenix 12/800 VE.Direct
Less power, but economical. According to Victron, ECO mode puts the inverter on standby until a load draws power again. Cut-off voltage and alarms can be adjusted, even on your phone via a Bluetooth adapter. Victron gives a five-year warranty. It is not enough for a hair dryer or electric kettle.
Ective SI 10
The counterpart to the heicko with the same continuous power but a longer peak: 1,500 watts for ten seconds, 2,000 watts for two. Ective specifies 86 to 90 percent efficiency and a three-year manufacturer’s warranty, and a remote control is available as an accessory. You have to buy the battery cables separately.
Ective TSI 15
The only inverter in this list with a built-in shore power transfer switch. If you regularly plug into a shore power post, it saves you a separate switch. For 12 volts, Ective recommends two cable sets and at least 250 Ah of lead-acid or 125 Ah of lithium capacity.
Ective SI 5
The entry-level model with 500 watts. It is enough for a laptop, battery chargers and lights, and according to Ective it manages with as little as 100 Ah of lead-acid or 50 Ah of lithium capacity. A coffee maker is not on the list.
When is a portable power station the smarter choice?
When there is no house battery, when you only rent the vehicle or do not want to install anything permanently. A portable power station combines battery, inverter and charging electronics in one housing and needs no 25 mm² cables. Which size is enough for a vacation is shown in our guide to portable power stations for camping (in German).
Which inverter suits which use?
- Occasional coffee, drill charger or laptop in a car or van: heicko HPLS1000-12, bolted firmly to the battery.
- Inverter runs all day in a camper or on a boat: Victron Phoenix 12/800 because of its low idle draw.
- Hair dryer or electric kettle with a large lithium battery: heicko HPLS2000-12, only with professional installation.
- Frequent shore power at the campsite: Ective TSI 15.
- Only small loads and a small battery: Ective SI 5.
How the house battery is charged properly while driving is explained in the guide to the DC-DC charger for motorhomes (in German).
Different rules apply on board: more on that in the guide portable power stations on a boat (in German).
Frequently asked questions
Pure or modified sine wave: does it make a difference?
Yes. heicko writes that devices with sensitive electronics do not run on modified sine wave power, such as measuring instruments, coffee pod machines or electronically controlled charging stations. Signs are humming, unusual heat or failure. With pure sine wave, heicko says no restrictions are known.
Can I run an inverter from the cigarette lighter socket?
Only for small loads. According to heicko, the socket is usually fused at 8 to 20 amps; at 10 amps, that leaves about 120 watts. From 150 watts, the manufacturer recommends connecting directly to the battery. You can estimate the current on the 12-volt side by dividing the power by 12.
What cable cross-section does an inverter need?
Stick to the manufacturers' tables. For the 12/800, Victron requires 16 mm² up to 1.5 meters of cable length and 25 mm² up to 3 meters. For the SI 10, Ective even specifies 50 mm² at three meters. The cross-section grows faster than the length, which is why the inverter sits close to the battery.
How much power does an inverter draw at idle?
More than many people think. heicko specifies up to 1.5 amps for the HPLS series; over 24 hours, that is 36 Ah without any device running. Victron's 12/800 comes to 6.5 watts, and about 1 watt in ECO mode.
How long does the battery last on an inverter?
heicko gives an example: 60 Ah and a 70-watt load work out to just under nine hours on paper. In practice, the manufacturer recommends dividing the result by three, so just under three hours. Ective also specifies minimum capacities, for the SI 10 for example 160 Ah lead-acid or 90 Ah lithium.
May I permanently install an inverter myself?
Permanent installation in a vehicle or on a boat belongs in the hands of a qualified electrician. Victron requires this for its devices, and heicko refers to the German standard DIN VDE 0100 Part 717. Never connect the output of an inverter to the household grid or another power source.
Sources
- ELV: heicko HighPowerSinus HPLS1000-12 (retailer information)
- ELV: heicko HighPowerSinus HPLS2000-12 (retailer information)
- heicko: Operating manual for SL, CL, HPL, CLS, HPLS inverters (PDF)
- heicko: User manual Classic and HighPower Line (PDF)
- Victron Energy: Inverter VE.Direct
- Victron Energy: Data sheet Inverter VE.Direct 250 VA to 1600 VA (PDF)
- Victron Energy: Manual Inverter VE.Direct 230 V (PDF)
- Ective: SI 10
- Ective: SI 5
- Ective: TSI 15
- Ective: Operating manual SI and TSI series (PDF)
Where to buy
- heicko HighPowerSinus HPLS1000-12View at ELVAvailable in Germany: ELV
- heicko HighPowerSinus HPLS2000-12View at ELVAvailable in Germany: ELV
- Victron Phoenix 12/800 VE.DirectCheck price at Amazon.deAvailable in Germany: Amazon.de
- Ective SI 10Check price at Amazon.deAvailable in Germany: Amazon.de
- Ective TSI 15Check price at Amazon.deAvailable in Germany: Amazon.de
- Ective SI 5Check price at Amazon.deAvailable in Germany: Amazon.de
