Contents14 sections
This guide was first published in German on handgetestet.de.
If you are torn between Ecovacs and Roborock, you probably end up comparing pascal figures. That leads you astray. Both brands now sell roller mops, the stations of the models covered here wash with warm water, and the suction figures come from the manufacturers themselves. What makes the difference is privacy, software and height. For a typical apartment with hard floors and a few rugs, we therefore consider the Roborock Qrevo Curv 2 Flow the more sensible choice: Roborock had it certified to the European security standard for connected devices, and Ecovacs‘ list of vulnerabilities weighs heavily. Ecovacs remains interesting if you want the station to run without bags or the robot to deliberately soak dried-on stains. General questions about mopping are answered in our guide to robot vacuums with a mopping function (in German).
Do both brands mop the same way now?
Almost. The Ecovacs models covered here all mop with a roller: 27 centimeters on the X12 and the T90 PRO, the older version on the T80S. Roborock takes two routes. The Flow models have a roller, while the Qrevo Curv 2 Pro or Saros 20 Sonic rely on mop pads or vibration. So if you want a specific technology, you have to look more closely at Roborock, and in return you get the wider choice.
Technically, the X12 and Curv 2 Flow are very similar. According to the manufacturers, both clean the roller while driving, both lift it by 15 millimeters on carpet and slide a cover in front of it. The difference is in the details. According to Ecovacs, the X12 detects dried-on stains and sprays diluted cleaning solution onto them. Roborock does not mention a spray function like this for the Curv 2 Flow. It does, however, use up cleaning solution on an ongoing basis. For households with children and a kitchen floor, that can pay off. For the hallway, probably not.
That mopping remains the weak spot of the entire category is shown by Stiftung Warentest (the German consumer testing organization): according to the freely accessible part of its June 2026 report, many devices are weakest precisely there. The new models from both brands mentioned there are different from the ones covered here.
What do 30,000 pascals and 15 newtons really tell you?
Not much, as long as nobody measures the same way. Ecovacs states up to 30,000 Pa for the T90 PRO and 24,800 Pa for the T80S, but „up to 0.22 bar“ for the X12, which is 22,000 Pa, plus an airflow figure. Roborock states 20,000 Pa for the Curv 2 Flow and at least discloses in a footnote that the figure comes from internal tests in the strongest mode with a full battery. For mopping pressure, Roborock calculates in newtons (up to 15 N, also internal), Ecovacs in pascals. A direct comparison fails at the unit alone.
The same goes for temperatures. According to the footnote, Roborock’s 75 degrees apply at the outlet of the heating element, not at the roller. For the T90 PRO, the noise reduction figures in the shop even carry the note „to be confirmed“. Take figures like these as a direction, not as a result.
Which brand can I trust more with the camera and maps?
This is where our decision is made. In November 2026, the US vulnerability database NVD lists 16 entries under the keyword Ecovacs and none under the keyword Roborock. They include serious issues: missing certificate validation in robots and app, keys for firmware updates that can be derived, and a flaw that allowed logged-in attackers to bypass the PIN for the live video. Some of this was reported by the researchers Dennis Giese and Braelynn Luedtke. Ecovacs has published security advisories, for example on certificate validation, with a fix from app version 3.0.0. That advisory names series such as X1, X2 and T10. Whether the current models were ever affected is not clear from it.
Zero entries does not mean zero vulnerabilities. An entry is only created when someone reports something, and the fact that Ecovacs discloses flaws publicly also speaks for the brand. Roborock, on the other hand, provides more evidence: according to the manufacturer, the Curv 2 Flow is certified by TÜV (the German testing and certification organization) to ETSI EN 303 645, the camera functions are off by default, and according to the Trust Center, video calls require a button press on the device plus a gesture password. On the shop pages for the X12 and T90 PRO, Ecovacs mentions nothing comparable. Are these manufacturer claims? Yes. But they are more verifiable than none at all.
Regardless of the brand, the BSI (the German Federal Office for Information Security) recommends a separate guest network on your Wi-Fi and a look at the privacy settings. Before buying, also ask how long updates will be provided. A robot can be operated without internet, but according to the BSI it often loses features.
Which software integrates better?
For smart home tinkerers, there is a clear difference, and it is documented not by the manufacturer but by Home Assistant. Its Roborock integration controls most vacuums locally on the home network and only needs the cloud for setup and as a fallback. The Ecovacs integration runs via the cloud; a self-hosted server is possible but comes with limitations. Roborock has also announced Matter for the Curv 2 Flow, though only via a later update, and according to the manufacturer supports up to four floors. You need an account with both.
What about spare parts?
In its online shop, Ecovacs assigns filters, brushes and solution to each model and offers a quarterly accessory kit for the X12. That helps with planning. The T90 PRO and the T80S need dust bags; the X12 collects bagless in a 1.6-liter container. Roborock states up to 65 days without emptying for the Curv 2 Flow and emphasizes that the roller, scraper and tank can be removed quickly. Since summer 2026, however, a right to repair applies to robot vacuums, according to Stiftung Warentest. So if something breaks, ask the manufacturer before buying a new one. None of these robots cleans stairs. For that, a cordless vacuum (in German) or a canister vacuum (in German) stays in the closet.
Six models, three brands
| Model | Mopping system according to the manufacturer | Height | Station | Best for |
|---|---|---|---|---|
| Roborock Qrevo Curv 2 Flow | Roller 27 cm, up to 15 N | 11.9 cm | Roller washing 75 °C, drying 55 °C | When privacy and smart home matter |
| DEEBOT X12 OmniCyclone | Roller 27 cm, stain sprayer | 9.8 cm | Bagless 1.6 l, water 3.5 l | Stains, no bags |
| DEEBOT T90 PRO OMNI | Roller 27 cm | 9.5 cm | Bag, water 4 l | Low profile, large tank |
| DEEBOT T80S OMNI | Older roller, 3,800 Pa | 9.8 cm | Bag, water 4 l, drying 63 °C | Entry point at Ecovacs |
| Roborock Qrevo Edge 2 Flow | Roller | 8.98 cm | Self-cleaning with water pressure | Low furniture |
| Narwal Flow 2 | Flat roller, 12 N | Not specified | Hot water supply during operation | Alternative to both brands |
Roborock Qrevo Curv 2 Flow
The package with the fewest open questions. Roller, carpet protection, 200 recognizable obstacle categories according to the manufacturer, and the certification described above. The downside is its height of 11.9 centimeters, which means it does not fit under many sofas. The station measures 45 by 45 by 45 centimeters, and so far the Matter update has only been promised.
DEEBOT X12 OmniCyclone
The strongest reason for Ecovacs: the stain function and the bagless station. A roller reach of 2.58 centimeters toward the edge sounds good, and according to Ecovacs it can climb thresholds of 2.4 centimeters. Against it are the open privacy question and the ongoing cost of cleaning solution.
DEEBOT T90 PRO OMNI
At 9.5 centimeters, the lowest Ecovacs here, plus 4 liters of fresh water. Navigation uses mini ToF instead of the dToF sensor in the X12. Bags add to the running costs.
DEEBOT T80S OMNI
The lowest of the three Ecovacs tiers. The roller is the older version, and the edge reach is 1.5 centimeters. If you want a roller and hot-air drying and do not need every new feature, it will do the job. The same privacy question applies as with its siblings.
Roborock Qrevo Edge 2 Flow
The answer to the sofa problem. At 8.98 centimeters, it is almost three centimeters lower than the Curv 2 Flow and is still a roller model. Roborock states 35,000 Pa. Check the space the station needs before buying.
Narwal Flow 2
If you distrust both brands, look here. Narwal promises a flat roller mop with 12 newtons of contact pressure and a constant supply of fresh hot water. It comes with two cameras, so the privacy question arises here too.
Which brand suits whom
- A microphone and camera in the living room worry you, or you run Home Assistant: Roborock Qrevo Curv 2 Flow.
- The robot has to fit under a low piece of furniture: Roborock Qrevo Edge 2 Flow, or the T90 PRO if things are tighter.
- Dried-on stains in the kitchen, no dust bags: DEEBOT X12 OmniCyclone.
- A roller at a lower price within the Ecovacs range: DEEBOT T80S OMNI.
- You are sticking with Ecovacs despite everything: set up a guest network, keep the firmware up to date, and turn off the camera functions as far as the app allows.
More on cameras and the cloud is in the guide Robot vacuums and privacy, and the comparison with eufy is at Ecovacs or eufy (in German).
Frequently asked questions
What is the difference between Ecovacs and Roborock when it comes to mopping?
It is smaller than you might think. The Ecovacs models covered here all mop with a roller; Roborock offers rollers, mop pads and vibration, and therefore more choice. The X12 and Curv 2 Flow are very similar: both lift the roller by 15 millimeters on carpet. Only the X12 sprays cleaning solution onto dried-on stains, according to Ecovacs.
Can the suction power of Ecovacs and Roborock be compared?
Hardly. Ecovacs states up to 30,000 Pa for the T90 PRO and a figure in bar for the X12; Roborock states 20,000 Pa from internal tests for the Curv 2 Flow. Roborock measures mopping pressure in newtons, Ecovacs in pascals. Manufacturer figures like these are useful as a direction, not as a result.
Which brand is more trustworthy on privacy?
In November 2026, the NVD lists 16 entries under the keyword Ecovacs and none for Roborock, including missing certificate validation and a video PIN that could be bypassed. Zero entries does not mean zero vulnerabilities. But Roborock provides more evidence: TÜV certification, camera functions off by default and video calls only with a button press on the device.
Which robot vacuum integrates better with Home Assistant?
Roborock. According to Home Assistant, its integration controls most Roborock vacuums locally on the home network and only needs the cloud for setup and as a fallback. The Ecovacs integration runs via the cloud; a self-hosted server comes with limitations. Roborock has announced Matter for the Curv 2 Flow only via a later update.
Which robot vacuum fits under low furniture?
At 8.98 centimeters, the Roborock Qrevo Edge 2 Flow is almost three centimeters lower than the Curv 2 Flow and is still a roller model. At Ecovacs, the T90 PRO is the lowest at 9.5 centimeters. At 11.9 centimeters, the Curv 2 Flow does not fit under many sofas.
What about spare parts and running costs?
In its online shop, Ecovacs assigns filters, brushes and solution to each model and offers a quarterly accessory kit for the X12. The T90 PRO and T80S need dust bags; the X12 collects bagless but uses cleaning solution on an ongoing basis. Roborock states up to 65 days without emptying for the Curv 2 Flow.
Sources
- Roborock: Qrevo Curv 2 Flow
- Roborock: Robot vacuums at a glance
- Roborock: Trust Center
- Ecovacs: DEEBOT X12 OmniCyclone
- Ecovacs: DEEBOT T90 PRO OMNI
- Ecovacs: DEEBOT T80S OMNI
- Ecovacs: Security advisory on certificate validation
- National Vulnerability Database: entries for Ecovacs
- National Vulnerability Database: entries for Roborock
- BSI: Using robot vacuums safely
- Stiftung Warentest: Robot vacuums tested
- Home Assistant: Roborock integration
- Home Assistant: Ecovacs integration
- Narwal: Home page with Flow 2
Where to buy
- Roborock Qrevo Curv 2 FlowCheck price at Amazon.deAvailable in Germany: Amazon.de
- DEEBOT X12 OmniCycloneView at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- DEEBOT T90 PRO OMNIView at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- DEEBOT T80S OMNIView at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- Roborock Qrevo Edge 2 FlowCheck price at Amazon.deAvailable in Germany: Amazon.de
- Narwal Flow 2Check price at Amazon.deAvailable in Germany: Amazon.de
