Black Friday Woche ab 19.11.: unsere Wahl je Ratgeber
Independent buying adviceEvery claim with a sourceNo paid verdictsIn 36 countries1,734 guides and reviews in German How we test
handgetestet

Deutsch

Retrofitting H7 LED Bulbs: Approval, Adapters and Vehicle List

Retrofitting H7 LEDs: when LED bulbs are allowed in halogen headlights in Germany, how to read the vehicle list, and why adapters and CAN bus modules are needed.

handgetestet editorial team · Updated November 17, 2026
OSRAM LEDriving Adapter DA08Image: ELV (Pressebild)
Contents16 sections

This guide was first published in German on handgetestet.de.

In Germany, an LED in a halogen headlight is only allowed if bulb, headlight and vehicle appear together on the bulb manufacturer’s list. If your car is on it, we recommend the Osram Night Breaker LED Speed H7 450. According to Osram, it is built like a halogen bulb and therefore needs neither adapter nor cap in many listed cars. Where the list requires accessories for the less expensive Osram bulbs, you will find the matching holders further down.

Can I simply plug an LED into my H7 headlight?

No. A headlight is matched to the light source it was tested with. According to ADAC, the German automobile club, the first legal H7 LED, an Osram Night Breaker, received a German general type approval (Allgemeine Bauartgenehmigung, ABG for short) in fall 2020. It applies only to vehicles whose headlights were tested with exactly this LED. According to ADAC, the approved bulbs are tested by TÜV, the German testing organization, and approved by Germany’s Federal Motor Transport Authority (Kraftfahrt-Bundesamt).

In ADAC’s assessment, fitting an LED in a car that is not approved risks voiding the vehicle’s operating permit. Even with brand-name manufacturers, not every LED is meant for the road. Philips, for example, says it does not sell its Ultinon Pro5000 and Pro9000 in Germany at all, and outside Germany only for use off public roads.

How do I find out whether my car is on the list?

What matters is not the model in the vehicle registration, but the approval number of the headlight. It is on the lens or the housing: an E, a number in a circle and four to five further digits. With this number, you go to the compatibility list from Osram or Philips. Osram also offers an online tool for this; the printed list from July 2026 runs to more than 70 pages.

A look inside shows how different the solutions are. On the Golf 7 with headlight E9 6765, the Speed 450 manages without accessories, while the Smart and Start need the 64210DA05 adapter. On the Ford Kuga 2 it is the DA09, on the Peugeot 208 up to 2015 the DA10. For a fourth-generation Ford Focus, the Start even requires an adapter and a cap together.

If your vehicle is not on the list, there is no approval. Period.

Why adapters and caps?

According to Osram, the adapter is what makes mounting the LED bulb in the respective headlight possible at all. The cap replaces the original cover so that the bulb sits precisely and the headlight stays sealed. If such a part is on the list, it is mandatory. Without it, the approval does not apply, and according to Osram, only original Osram accessories are approved. Incidentally, with the DA05 and DA08 adapters, the bulb sits slightly rotated on purpose.

ELV (German retailer) does not carry the H7 bulbs themselves, but it does carry the Osram adapters. That is why we refer you to Amazon for the bulbs and to ELV for the accessories. Only order the accessories once you know the number from the list. A wrong adapter does not fit.

What if the car reports a bulb fault?

Some onboard computers report a defective bulb after the conversion. Osram writes in its list: if an error message appears, a CAN bus module is mandatory, otherwise the control unit can be damaged. The recommendations are the LEDSC02-1 for H7 vehicles from VW, Audi, Skoda and Seat, the LEDSC03-1 for BMW and the LEDSC01 for all others. Simply having the message programmed out at a garage is not an alternative, according to Osram. Philips states that no such messages have occurred with the vehicles on its list and that no CAN bus adapter is needed.

Does the headlight need to be readjusted?

Osram and ADAC both recommend having the alignment checked at a garage after installation. In ADAC’s test setup, the cutoff line was at the same height as with halogen, but the beam range rose from 130 to 170 meters. Even so, a headlight that aims a few millimeters higher after the swap dazzles oncoming traffic. A tip from ADAC for the installation itself: photograph the inside of the headlight housing beforehand.

Which documents belong in the glove compartment?

The ABG. You download it via the code on the package. Osram requires a printout of the main part and the page from Annex 1 on which your vehicle is listed. According to Osram, the sticker for the engine compartment is not required.

Abroad, the law of the country in which the car is registered applies. In countries that drive on the left, such as the United Kingdom, you have to switch back to halogen, according to Osram.

Four bulbs, three adapters

ModelTypeData according to manufacturerFor whom
OSRAM NIGHT BREAKER LED SPEED H7 450Bulb in halogen format16 W, 1,550 lm, 6,000 K, 5 + 1 years warrantylisted cars, ideally without accessories
OSRAM NIGHT BREAKER LED SMART H7Bulb16 W, 1,550 lm, 6,000 K, 5 years warrantycars for which the list names the Smart
OSRAM NIGHT BREAKER LED START H7Bulb16 W, 6,000 K, 3 years warrantyEntry level, often with adapter
Philips Ultinon Pro6000 H7-LEDBulbapproved by the German KBA, 2 years warrantycars on the Philips list
OSRAM LEDriving Adapter DA08Bulb holder15 g, 41.9 mm longe.g. VW Scirocco 3, Seat Alhambra 2 with Smart or Start
OSRAM LEDriving Adapter 64210DA09Bulb holderOriginal accessory for H7 LEDe.g. Ford Kuga 2 with Smart or Start
OSRAM LEDriving Adapter LEDCAP03Headlight cap87 mm diameter, 42 ge.g. Audi A1 from 2018 with Start

OSRAM NIGHT BREAKER LED SPEED H7 450

Our main recommendation, because it sidesteps the accessory problem most often. Osram cites up to 450 percent more brightness, measured against the minimum requirement of the ECE regulation, and a beam range of up to 240 meters. The manufacturer specifies a service life of 3,000 hours. In the Osram list, it appears in more H7 entries than the Smart and Start, and almost always without an adapter. Drawback: for some cars, the list still requires a CAN bus module in case of a fault.

OSRAM NIGHT BREAKER LED SMART H7

The middle tier, with up to 330 percent more brightness according to Osram. For a good share of the entries on the list, it only works with an adapter or cap. So factor in the accessories right away.

OSRAM NIGHT BREAKER LED START H7

The entry level, with up to 230 percent more brightness and a three-year warranty. In many entries on the list, it needs the same accessories as the Smart.

Philips Ultinon Pro6000 H7-LED

The alternative if your car is listed by Philips and not by Osram. Philips cites up to 230 percent more brightness and a service life of 3,000 hours. For the vehicles on its own list, according to Philips, it needs neither accessories nor a CAN bus adapter. It is approved mainly for low beam, and for high beam only on some models.

OSRAM LEDriving Adapter DA08

The holder that the Osram list prescribes for the Scirocco 3 and Alhambra 2, among others, when a Smart or Start is installed. Osram gives a three-year warranty.

OSRAM LEDriving Adapter 64210DA09

Mandatory on the Ford Kuga 2 with headlight E9 16222 as soon as a Smart or Start is to go in. For the Peugeot 208 of the early years, ELV offers the very similarly named 64210DA10. Do not mix the two up.

OSRAM LEDriving Adapter LEDCAP03

A replacement cap for the headlight, intended by Osram as a system component for legal operation. The list names it, for example, for the Audi A1 from 2018 with the Start. For the fourth-generation Focus, the LEDCAP02 is specified together with the DA04 adapter.

Which bulb for which car?

  • Car listed by Osram, Speed possible without accessories: Osram Night Breaker LED Speed H7 450.
  • Speed not listed, but Smart is: Smart plus the adapter from the list.
  • Only listed by Philips: Ultinon Pro6000 H7-LED.
  • Not on any list: stay with halogen.

If you are working on your car anyway, we also have a guide to the car battery (in German). A backup camera (in German) gives you better visibility when maneuvering, and for bikes, separate rules apply to bicycle lighting (in German).

Frequently asked questions

Can you install an LED in an H7 headlight?

Only with approval. Approved bulbs have a German general type approval (Allgemeine Bauartgenehmigung) that applies only to vehicles whose headlights were tested with exactly this LED. According to ADAC, the German automobile club, fitting an LED in a car that is not approved risks voiding the vehicle's operating permit.

How do I find out whether my car is on the LED list?

Via the approval number of the headlight, not the model in the vehicle registration. It is on the lens or the housing: an E, a number in a circle and further digits. Use this number to check the compatibility list from Osram or Philips.

Why do H7 LEDs need adapters and caps?

According to Osram, the adapter is what makes mounting in the respective headlight possible at all, and the cap replaces the original cover so that everything stays sealed. If the list names such a part, it is mandatory. According to Osram, only original accessories are approved, and a wrong adapter does not fit.

What should you do if the car reports a bulb fault after the conversion?

According to Osram, a CAN bus module is then mandatory, otherwise the control unit can be damaged. Having the message programmed out at a garage is not an alternative, according to Osram. Philips states that no CAN bus adapter is needed for the vehicles on its list.

Does the headlight need adjusting after installing the LED?

Osram and ADAC recommend having the alignment checked at a garage. In ADAC's test setup, the cutoff line stayed the same, but the beam range rose from 130 to 170 meters. A headlight that aims slightly higher after the swap dazzles oncoming traffic.

Which documents do you need for an LED retrofit bulb?

The general type approval belongs in the glove compartment. Osram requires a printout of the main part and the page from Annex 1 on which your vehicle is listed. You can download it via the code on the package. A sticker for the engine compartment is not required.

Sources

Where to buy

Shop in:

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.