Contents12 sections
This guide was first published in German on handgetestet.de.
In stores, „kids‘ bed“ means pretty much anything between 70 by 140 and 140 by 200 cm, and that is exactly what makes buying one confusing. So do not ask about design first, but about your child’s age and what they can already do. For children who are outgrowing the crib, we consider the PAIDI LITTLE FLO the best-documented solution, because it stays low, grows with the child and the range carries the Blue Angel, Germany’s eco-label. The Home affaire Wenke is a cheaper option and comes with a slatted base included.
Bedside crib, kids‘ bed, loft bed: three stages of life
A newborn usually does not need a kids‘ bed yet. For babies, the German consumer magazine ÖKO-TEST names bedside cribs that are firmly attached to the parents‘ bed. What matters there is covered in our guide to the bedside crib.
At the other end is the loft bed. The Swiss Council for Accident Prevention, bfu, recommends avoiding one until at least the age of six, and ÖKO-TEST likewise recommends loft beds only from six. Toddlers still lack the coordination for it. Bunk and loft beds should comply with their own standard, DIN EN 747; more on this in our guide to loft beds for children.
In between lies the subject of this article: the floor-level or standard-height bed for children from about two years old into school age. The bfu does not give a fixed age for the switch. It goes by ability. As soon as a child can climb over the bars, the side or two bars should come out and the mattress should be set as low as possible. Climbing decides, not the birthday.
What DIN EN 716 and DIN EN 1725 cover and what they do not
Many listings adorn themselves with standards, so it is worth looking at the scope. DIN EN 716-1 applies to children’s cots for domestic use with an internal length of more than 900 mm up to a maximum of 1,400 mm. That is the 70 by 140 cm class. The current edition is from June 2019, and the test methods are in Part 2. Since the 2017 version, a warning against a second mattress in the bed has also been part of it.
A bed with a 200 cm sleeping surface does not fall under it simply because of its length, at least that is how we read the published scope. DIN EN 1725, in turn, was revised in 2024 and, according to its wording, is aimed at beds used by adults, tested for people up to 110 kg. Bunk and loft beds are excluded. For the classic 90 by 200 cm kids‘ bed with fall protection, neither scope explicitly mentions use by children. That does not make such beds unsafe. It just means that „tested“ without naming the standard and the test lab says little. Ask.
How much the standard matters in practice is shown by an ÖKO-TEST test from its 2017 toddler yearbook. Ten beds were measured against DIN EN 716. Bar spacing was fine everywhere, yet two beds had safety-relevant defects, and three lacked mandatory warnings. A thin MDF strip in the slatted base broke at just 300 newtons. The test is several years old and concerns other models, but the types of defects remain instructive.
Still in the 70 by 140 bed? This checklist helps
The bfu has published a useful list for cribs. It comes from Switzerland and dates from 2016, but refers to EN 716.
- Bar spacing 4.5 to 6.5 cm.
- Side extends at least 50 cm above the mattress, and at least 20 cm in the highest base position.
- Gap between mattress and frame no more than 3 cm.
- Slats of the base no more than 6 cm apart.
- No crossbars that invite climbing.
Incidentally, ÖKO-TEST specifies a stricter 60 cm from the mattress to the top edge for bed sides. When in doubt, go with the higher value. The most important step comes after the purchase. As soon as the child sits up, the base has to go down, warns tester Norbert Vogt from Kiel University. Otherwise, even large stuffed animals become a climbing aid.
Fall protection, base and bedding
Fall protection is meant to stop a child from rolling out during sleep, not to prevent climbing. That is why the sleeping height is at least as important as the height of the side. If a child falls out of a low bed, the drop is short, and according to ÖKO-TEST a rug in front of it cushions the worst. Check on every model whether the guard is firmly mounted and how long it is. At PAIDI, it is a separate part for the Little Flo that closes the entry opening.
In the bed itself, less is more for the youngest. The bfu recommends a baby sleeping bag instead of a blanket and warns against cords, ribbons and hanging fabrics. The PAIDI beds come without slatted base and mattress, so factor in both. Our mattress guide helps with the choice. For the slatted base, the lesson from the test above applies: sturdy slats rather than thin fiberboard. And the wardrobe next to it? It should be anchored to the wall, advises Das Sichere Haus.
Five kids‘ beds at a glance
| Model | Sleeping surface | Slatted base | Load capacity | Seals and certifications | For whom |
|---|---|---|---|---|---|
| PAIDI LITTLE FLO | 90, 120 or 140 × 200 cm | not included | not specified | Blue Angel; GS, Golden M, emission class A according to retailer | Toddler to teenager |
| PAIDI STIENE | 90, 120 or 140 × 200 cm | not included | 120 kg | Blue Angel | School-age child, wider sleeping surface |
| YUNY by PAIDI CUTIE LEA | 90 × 200 cm | not included | 120 kg | Blue Angel | Overnight guests, storage space |
| Home affaire Wenke | 90 × 140 to 200 cm | included | 90 kg | FSC according to retailer | Tight budget |
| Vipack Junior | 70 × 140 cm | roll-up base included | 40 kg | no standard specified | Transition in a small format |
PAIDI LITTLE FLO
PAIDI describes a Montessori-inspired floor bed with raised edges on all four sides and an opening through which the child can crawl in and out on their own. In the evening, the opening can be closed with the fall guard. By rebuilding, the Little version becomes the Middle and finally a daybed for teenagers; according to PAIDI, the parts for this are included from the start. According to PAIDI, the bed is 508 mm high and sits only 8 mm above the floor. Budget some reserve for the cost of base and mattress.
PAIDI STIENE
The listing calls it a youth bed and daybed, with up to 140 cm width and a load capacity of 120 kg. The headboard measures 80 cm, the footboard 40 cm. The listing does not mention fall protection, so we would not choose it for three-year-olds. From school age on, however, it grows with the child for a long time. The STIENE range is listed in the Blue Angel annex.
YUNY by PAIDI CUTIE LEA
A daybed with a bed drawer that, according to the listing, pulls out into a second sleeping surface. The dimensions therefore vary between 96 and 126 cm in width. If you often have overnight visitors, this saves you a guest bed. Fall protection, base and mattress are only available as accessories, and the pulled-out surface needs extra space in the room.
Home affaire Wenke
Solid FSC pine, extendable from 140 to 200 cm, fall protection on both sides and a built-in slatted base included. That is a lot for the entry-level price, although the information comes only from the retailer. The listing names no emissions seal or standard. When extending, check which mattress solution is intended, because a sleeping surface of variable length needs a suitable mattress.
Vipack Junior
The small format for children who already get up on their own. According to the listing, it measures 70 by 140 cm, with all-round fall protection, a choice of entry on the right or left, and a roll-up slatted base with eleven slats. With a load capacity of 40 kg and a length of 140 cm, its useful life is limited. The listing gives no information on DIN EN 716, even though the size falls exactly within its scope. Ask about it before buying.
Which bed for which child?
- Toddler after the crib, long use: PAIDI LITTLE FLO.
- Tight budget, length that grows: Home affaire Wenke.
- Small room, transitional solution: Vipack Junior.
- School-age child, wide sleeping surface: PAIDI STIENE.
- Frequent guests: YUNY CUTIE LEA.
For a changing station in the same room, height, surface area and wall anchoring matter; the dimensions are compared in our guide to the changing table.
Frequently asked questions
When does a child need a kids' bed instead of a crib?
The Swiss accident prevention advisory bfu does not give a fixed age; it goes by ability. As soon as a child can climb over the bars, the side or two bars should come out and the mattress should be set as low as possible. Climbing decides, not the birthday. After that comes the floor-level or standard-height kids' bed.
From what age is a loft bed safe?
The Swiss advisory center bfu recommends avoiding a loft bed until at least age six, and the German consumer magazine ÖKO-TEST likewise recommends it only from six. Toddlers lack the coordination for it. Bunk and loft beds should comply with the standard DIN EN 747.
What does DIN EN 716 mean for kids' beds?
It applies to children's cots with an internal length of more than 900 mm up to a maximum of 1,400 mm, in other words the 70 by 140 cm class. A bed with a 200 cm sleeping surface does not fall under it. "Tested" without naming the standard and test lab therefore says little, so ask.
What should you look for in a crib?
The bfu specifies bars spaced 4.5 to 6.5 cm apart, a side at least 50 cm above the mattress, a gap of no more than 3 cm between mattress and frame, and no crossbars for climbing. ÖKO-TEST specifies a stricter 60 cm side height; when in doubt, go with the higher value.
What is not included with kids' beds?
The PAIDI beds come without slatted base and mattress, so factor in both. With the slatted base, sturdy slats count rather than thin fiberboard. The Home affaire Wenke includes a built-in slatted base, the Vipack Junior a roll-up slatted base. With the YUNY CUTIE LEA, fall protection, base and mattress are only available as accessories.
Which kids' bed fits if you often have overnight guests?
The YUNY by PAIDI CUTIE LEA has a bed drawer that, according to the listing, pulls out into a second sleeping surface. That saves you a guest bed. As a result, the width varies between 96 and 126 cm, and the pulled-out surface needs extra space in the room.
Sources
- DIN: DIN EN 716-1 (edition 2019-06)
- DIN: DIN EN 716-1 (edition 2017-08, scope)
- DIN Media: DIN EN 1725:2024-02
- bfu: Toddler beds, product fact sheet (2016)
- ÖKO-TEST: Kids‘ beds tested (toddler yearbook 2017)
- ÖKO-TEST: Setting up a nursery
- Aktion Das Sichere Haus: Anchoring furniture securely
- Blue Angel: contract annex PAIDI
- Blue Angel: contract annex YUNY by PAIDI
- PAIDI: Little Flo range
- PAIDI: Little Flo floor bed
- Retailer information LITTLE FLO (BAUR, German retailer)
- Retailer information STIENE
- Retailer information CUTIE LEA
- Retailer information Wenke
- Retailer information Vipack Junior
Where to buy
- PAIDI LITTLE FLOView at OTTOAvailable in Germany: OTTO
- Home affaire WenkeView at OTTOAvailable in Germany: OTTO
- PAIDI STIENEView at OTTOAvailable in Germany: OTTO
- YUNY by PAIDI CUTIE LEAView at OTTOAvailable in Germany: OTTO
- Vipack JuniorView at OTTOAvailable in Germany: OTTO

