Contents12 sections
This guide was first published in German on handgetestet.de.
The cleanest edge is usually created not by the robot mower but in the ground. A flush-laid paving strip solves the problem with almost any model. Where that is not possible, along walls, fences and steps, our suggestion among the machines compared here is the Ecovacs GOAT A1600 LiDAR PRO with a side string trimmer, despite the noise and wear parts. If you read „0 mm“ on a box, though, you should keep reading.
How much grass really remains at the edge?
The German consumer testing organization Stiftung Warentest reports a sobering figure: along the edges and around the charging station, strips of lawn up to 20 centimeters wide were left standing in its test, depending on the model.
Along a 30-meter flower bed, 20 centimeters already adds up to 6 square meters of manual work. On top of that comes the distance manufacturers prescribe. For its iMOW, STIHL requires 28 centimeters from any edge higher than 1 centimeter when laying the wire, while next to surfaces the mower can drive onto, the wire may run directly along the border. That one centimeter therefore decides almost 30 centimeters of edge.
What is behind „0 mm“?
Ecovacs advertises the GOAT A series with a cut to about 0 mm from the edge. The footnote states that the figure comes from its own lab and can vary depending on operating conditions. We know of no independent measurement. Worx is even vaguer with Cut-to-Zero and promises a cut right up to the lawn edge, without a number. For Trim-to-Edge, Gardena only writes „close to fixed edges.“
More helpful than the advertising figure is the Ecovacs manual. It distinguishes three cases. Along walls and fences over 5 centimeters high, you steer the machine as close as possible while mapping. With steps of 2 to 5 centimeters and lowered edges, you should keep a distance of about 10 centimeters. With level surfaces the mower can drive onto, the track may be shifted slightly outward. So right there, at the 2 to 5 centimeters, a gap is likely to remain even with the trimmer model. Many bed edgings fall into this category.
Trimmer, blade disc or mowing strip?
A side string trimmer reaches vertical obstacles that no blade disc can get to. It is loud, uses up material and should not run at night. An offset disc like the one from Worx works without string, but the manufacturer does not state its reach. Finally, the mowing strip takes work once and then needs no technology at all.
For the strip, the rule is: flush with the turf, a step of less than 1 centimeter, and as wide as the strip of grass your robot leaves standing. With the figure from the Stiftung Warentest report, you end up at 20 centimeters. The wheel rolls on the stone, and the blade reaches the last blades of grass. Which profiles exist and why mowing strips for robots lie flat is explained in our lawn edging guide (in German). Bed edging set upright, on the other hand, does not help the robot.
In an existing garden, that is a weekend project per bed. In new landscaping, it can be done along the way. So plan the edge first, and buy the mower after that.
Five machines, five answers to the edge
| Model | Edge technology | Edge claim | Area according to the manufacturer | For whom |
|---|---|---|---|---|
| Ecovacs GOAT A1600 LiDAR PRO | side string trimmer, 18 cm | to about 0 mm (lab figure) | 1,600 m² | lots of walls and fences |
| Ecovacs GOAT O800 RTK | edge run without trimmer | no figure for the edge | 800 m² | lawns with paving strips |
| Worx Landroid Vision Cloud WR303E | offset blade disc (WA0925 module, accessory) | no figure | 300 m² | lawns up to about 200 m², no string wanted |
| Worx Landroid Vision Cloud 4WD WR344E | offset blade disc, module included | no figure | 4,000 m² | slopes plus edges |
| Gardena smart SILENO free | Trim-to-Edge along fixed edges | no figure | 1,200 m² | short lawns, Gardena system |
Ecovacs GOAT A1600 LiDAR PRO
The trimmer module sits on the side and is 18 centimeters wide. In the app, you select individual edges, including the boundaries of no-go zones, and a separate edge pass also follows the area mowing. The drawbacks are in the manual. The sound power level rises from 62 to 82 dB(A) when trimming. String and brush should be replaced every 4 to 8 weeks, the blades every 4 to 6. Trimming at night is off-limits, and people should keep a distance of at least 2 meters. You must exclude delicate plants or objects along the edge from the trimming routes. The size suits lawns up to about 1,000 m².
Ecovacs GOAT O800 RTK
Here, the name TruEdge stands for edge driving, not for a trimmer. Neither the data sheet nor the shop page mentions a string trimmer. The manual offers a dedicated edge mode that mows along the boundary. If you already have paving strips, you get a small, affordable machine for 800 m² that also handles passages as narrow as 0.7 meters. Along walls, touch-up work remains. Ecovacs measured the comparison figure of 5 versus 40 centimeters of distance to obstacles itself, against unnamed competing models. That is all it is.
Worx Landroid Vision Cloud WR303E
The smallest machine in the range: 300 m², 30 percent slope, 30 to 60 millimeters cutting height. At Worx, the offset blade disc is not part of the basic set; it is an accessory, the WA0925 module. So look for a deal that includes the module. According to the manual, it sits on the side of the machine, works with a flexible auxiliary blade and is meant to get as close as possible to edges and obstacles. No string is needed. The manual does not give a figure for the remaining edge either. With some reserve, this is a machine for around 200 m².
Worx Landroid Vision Cloud 4WD WR344E
Here, the Cut-to-Zero module is included; for smaller 4WD models, there is the WA0928 retrofit part. According to Worx, the module cuts at 50, 60 or 70 millimeters. If you mow shorter, you should therefore find out beforehand what the edge will look like. The machine is intended for angular hillside gardens with slopes of up to 84 percent, not for the front yard.
Gardena smart SILENO free
Gardena describes the edge function only for fixed edges such as walls and fences. With a cutting height of 25 to 45 millimeters, the machine is designed for short lawns, and its area tops out at 1,200 m². A gateway is included in the set.
What is left after the robot
Very few gardens get by without any touch-ups at all. Around trees, at the station and along steps, something usually remains. A lightweight cordless grass trimmer (in German) takes care of it in minutes; for tall, dense growth, a brushcutter (in German) is the better choice. When mowing by hand, STIHL advises cutting the edges first. With a robot, that order no longer applies, since it drives according to plan anyway.
One thing you should not forget. In summer, hedgehogs like to sleep during the day in tall grass along sheltered edges. Stiftung Warentest advises cutting such spots in two steps: first down to about 20 centimeters, then search the grass, then cut to the desired height. With a robot mower, it is therefore better to set dense corners along hedges as no-go zones and trim them by hand.
Which solution suits which edge
- Lawn runs out onto paving or a patio: no trimmer needed, the Ecovacs GOAT O800 RTK is enough, and for lawns up to about 200 m² the Worx Landroid Vision Cloud WR303E as well.
- Lots of walls, fences and house walls: Ecovacs GOAT A1600 LiDAR PRO, provided 82 dB(A) is not an issue in your neighborhood.
- Beds with edging of 2 to 5 centimeters: rebuild the edge first, then think about the machine.
- Slope and edges at the same time: Worx Landroid Vision Cloud 4WD WR344E.
Expensive replacement blades do not necessarily last longer: in our review of the lohag robot mower blades with titanium carbide, they were noticeably worn after two passes.
Frequently asked questions
How much grass does a robot mower leave at the edge?
According to the German consumer testing organization Stiftung Warentest, strips up to 20 centimeters wide were left standing along edges and around the charging station, depending on the model. Along a 30-meter flower bed, that already adds up to 6 square meters of manual work. On top of that come the distances manufacturers prescribe when laying the boundary wire.
How wide should a mowing strip for a robot mower be?
As wide as the strip of grass your robot leaves standing, so 20 centimeters based on the Stiftung Warentest figure. The strip sits flush with the turf, with a step of less than 1 centimeter. Then the wheel rolls on the stone and the blade reaches the last blades of grass. Bed edging set upright does not help.
What does "0 mm" mean for edge cutting?
For the GOAT A series, Ecovacs advertises a cut to about 0 mm, according to a footnote a figure from its own lab. Worx promises a cut right up to the edge with Cut-to-Zero but gives no number, and Gardena only writes "close to fixed edges." We are not aware of any independent measurement.
Trimmer or blade disc: which is better at the edge?
A side string trimmer reaches vertical obstacles that no blade disc can get to, but it is loud, uses up material and should not run at night. The offset disc from Worx works without string, but the manufacturer does not state its reach. A mowing strip, once laid, needs no technology at all.
Which robot mower is enough for a lawn with a paved border?
If the lawn runs out onto paving or a patio, no trimmer is needed. Then the Ecovacs GOAT O800 RTK is enough, and for lawns up to about 200 m² the Worx Landroid Vision Cloud WR303E as well. With the Worx, look for a deal that includes the WA0925 module; it is an accessory.
What should you watch out for regarding hedgehogs when mowing along hedges?
In summer, hedgehogs like to sleep during the day in tall grass along sheltered edges. Stiftung Warentest advises first cutting such spots down to about 20 centimeters, then searching them and only then mowing to the desired height. With a robot mower, it is better to set dense corners along hedges as no-go zones.
Sources
- Stiftung Warentest: Robot mowers tested (freely accessible part)
- Stiftung Warentest: No night mowing for robot mowers, 7 tips
- Ecovacs: GOAT A1600 LiDAR PRO
- Ecovacs: GOAT A1600 and A3000 LiDAR PRO manual (PDF)
- Ecovacs: GOAT O800 RTK
- Ecovacs: GOAT O600 and O800 RTK manual (PDF)
- Worx: Landroid Vision Cloud 300 m² WR303E
- Worx: WR303E, WR305E, WR308E manual (PDF, in English)
- Worx: Landroid Vision Cloud 4WD WR344E
- Worx: Cut-to-Zero module WA0928
- Gardena: smart SILENO free 1,200 m²
- STIHL: iMOW quick guide RMI 5 (PDF)
- STIHL: Cutting lawn edges
Where to buy
- Ecovacs GOAT A1600 LiDAR PROView at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- Ecovacs GOAT O800 RTKView at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- Worx Landroid Vision Cloud WR303ECheck price at Amazon.deAvailable in Germany: Amazon.de
- Worx Landroid Vision Cloud 4WD WR344ECheck price at Amazon.deAvailable in Germany: Amazon.de
- Gardena smart SILENO freeCheck price at Amazon.deAvailable in Germany: Amazon.de
