Contents13 sections
This guide was first published in German on handgetestet.de.
8.2 centimeters of clearance under the sofa, 8.1 centimeters in the data sheet: that fits on paper and can still go wrong. Among the mopping robots compared here, we consider the DEEBOT T50 PRO OMNI Gen3 the most sensible buy as soon as there are 8.6 centimeters of clearance at the lowest point of your furniture. Below that, you are left with little more than a vacuum-only robot. And if you measure less than 7.8 centimeters, you are better off skipping the robot for that spot entirely.
Measure where it really gets tight
The front edge of the sofa tells you little. It usually gets tight further back: at the crossbar, the center leg, the bed frame or the fabric lining that sags in the middle. Lie down on the floor with a flashlight and a folding ruler and measure several points. Even faster is a stack of cardboard or books at the height of the robot you want, pushed once all the way across under the furniture. If it gets stuck, the robot will get stuck too.
If there is a rug under the bed, measure from the top of the pile. For a sofa, what counts is the loaded state, meaning with someone sitting on it, because cushions and webbing give way. Forget that and your measurement will be too generous.
How much margin do you need? In the T50 manual, Ecovacs writes that the robot may get stuck if the clearance roughly equals its own height. That is the crucial sentence, because it means the brochure figure does not promise free passage. None of the manufacturers in this comparison states a safety margin in millimeters. Our rule of thumb is 5 millimeters above the manufacturer’s figure, and the table below is calculated that way. The value is ours, not from any standard.
How much height the laser turret costs
On many robot vacuums, the round laser turret on top is the highest point. Roborock lists 119 millimeters for the Qrevo Curv 2 Flow, and Ecovacs 95 millimeters for the T90 MAX, explaining this with a built-in sensor instead of a turret. On the T50, according to the manufacturer, the laser module sits entirely inside the housing, hence the 81 millimeters. Between the two extremes lie 3.8 centimeters. Under a sofa, that can make all the difference.
Read the terms carefully. For the RVC 3, Kärcher simply gives the height of the device, 97 millimeters. Roborock speaks of clearance height for the Saros 20 Neo, Ecovacs of under-furniture height, and neither explains whether anything gives way or is lowered in the process. Be careful with marketing lines, too: according to the shop, the DEEBOT mini 2 fits under almost any piece of furniture, but the reason given is its 28.6-centimeter diameter. The data sheet lists a height of 99.8 millimeters. It is narrow, not low.
What you give up for the low-profile design
A comparison within one brand shows it. According to the data sheet, the T50 carries 70 milliliters of water on board, the T90 MAX 110. The T50’s pads lift by 9 millimeters on carpet, the roller of the T90 MAX by 15. Ecovacs does not say whether this is due to the height alone. What counts for you is the result, and that means: if you go down to 8 centimeters just for a single sofa, you may be making compromises across the whole household.
So do the math on the floor area. How much floor really lies under low furniture? With one sofa and two dressers, the canister vacuum (in German) can take care of those strips once a month, and the robot can be taller. Under a large double bed, it is a different story. That quickly adds up to four square meters that nobody else keeps clean.
Six low-profile robot vacuums by height and margin
| Model | Height according to manufacturer | Mopping | Clearance needed | Best for |
|---|---|---|---|---|
| DEEBOT T50 PRO OMNI Gen3 | 8.1 cm | two pads, 9 mm lift | 8.6 cm | bed and sofa, full dock |
| Roborock Saros 20 Neo | 7.95 cm clearance height | with warm water, design not specified here | 8.45 cm | when a few millimeters are missing |
| eufy Omni C20 | 8.5 cm | two pads, 6 N | 9 cm | small apartment, narrow dock |
| Roborock Saros 20 Flow Complete | 8.98 cm | roller | 9.5 cm | roller under 10 cm |
| DEEBOT T90 MAX OMNI | 9.5 cm | 27 cm roller, 15 mm lift | 10 cm | taller furniture, quiet operation |
| eufy C10 | 7.3 cm | no | 7.8 cm | very tight spots, vacuuming only |
DEEBOT T50 PRO OMNI Gen3
The 81 millimeters are stated consistently in both the shop and the manual. The dock empties the robot, washes the pads at 75 °C and dries them with 45 °C warm air. There is quite a lot against it, though. Ecovacs excludes carpets with fibers longer than 10 millimeters, according to the data sheet it only climbs thresholds up to 20 millimeters, and the dock with its base measures 53.3 centimeters in height and 47.7 in depth. Also, a camera drives under your bed, and you have to be comfortable with that. The 25,000 Pa is a manufacturer figure and says little about carpet.
Roborock Saros 20 Neo
At 7.95 centimeters, the lowest mopping robot in this comparison. Its lead over the T50, however, is 1.5 millimeters. With our margin, that only makes a difference if you measure between 8.45 and 8.6 centimeters. Roborock gives the height in its model overview. There is nothing there about tanks or dock dimensions, so check those before buying.
eufy Omni C20
Eufy confirms 328 × 334 × 85 millimeters in a dedicated dimensions note and asks you there to check your furniture height beforehand. At 33 × 28.9 centimeters, the dock is narrow. With 7,000 Pa and 6 newtons of pressure, though, the C20 plays in a lighter class, and the pads only air-dry. In humid rooms, eufy recommends 5 to 6 hours of drying time.
Roborock Saros 20 Flow Complete
If you want a mopping roller, this is the lowest stated height: 8.98 centimeters, or 5 millimeters less than the T90 MAX. Roborock also lists 36,000 Pa and self-cleaning with water pressure. Here, too, the key specs are limited to the model overview, and tanks and dock dimensions are missing there.
DEEBOT T90 MAX OMNI
If you have 10 centimeters of clearance, you do not have to settle for pads. The T90 MAX comes with a 27-centimeter roller and, at 58.1 dB in the data sheet, is just under 5 dB quieter than the T50. According to Ecovacs, it detects obstacles from 2 centimeters. There is no warm wash water, and the bags are an ongoing cost.
eufy C10
It does not get any lower in this comparison. The manufacturer’s page lists 7.3 centimeters, a listing on Amazon 7.2; go with the higher figure. The C10 does not mop, vacuums with 4,000 Pa according to eufy and navigates with a point laser and infrared, which is simpler than the other robots here. That is enough for the strip under the cabinet, but only partly as the sole robot for hard floors.
It still doesn’t fit: three ways out
Ecovacs names three solutions in its manual, and they apply to every brand. First, raise the furniture. Taller feet are often the simpler answer for a sofa, and with a solid wood bed, the frame height belongs on your list before you buy. Second, block off the underside so the robot does not drive in at all. Third, a no-go zone in the app. Set it up before the first mapping run and supervise the first cleaning, as the manufacturer also recommends.
A box spring bed with low feet often remains a case for the no-go zone. Measuring again does no harm, though. How well the individual mopping systems work apart from their height is covered in our guide to robot vacuums with mopping (in German).
How we would decide by the ruler
- Under 7.8 cm: no robot for that spot; raise the furniture or vacuum by hand.
- 7.8 to 8.4 cm: eufy C10, if vacuuming is enough.
- 8.45 to 8.59 cm: Roborock Saros 20 Neo, if the key specs from the model overview are enough for you.
- 8.6 to 9.4 cm: DEEBOT T50 PRO OMNI Gen3. In small apartments with little floor space, the eufy Omni C20 from 9 cm.
- 9.5 to 9.9 cm: Roborock Saros 20 Flow Complete for anyone who insists on a roller.
- From 10 cm: DEEBOT T90 MAX OMNI. Height is then no longer an issue; decide based on floor type and mopping system.
Frequently asked questions
How do I measure the clearance under a sofa and bed correctly?
At several points, because it usually gets tight further back at a crossbar, a center leg or sagging fabric. A quicker method is a stack of cardboard at the height of the robot you want, pushed all the way across underneath. For a sofa, measure it with someone sitting on it; under a bed, measure from the top of the carpet pile.
How much space does a robot vacuum need above its height?
No manufacturer states a safety margin. Ecovacs writes that the robot may get stuck if the clearance roughly equals its height. Our rule of thumb is 5 millimeters above the manufacturer's figure; that is not a value from any standard.
Why are some robot vacuums taller than others?
Often because of the round laser turret on top. Roborock lists 119 millimeters for the Qrevo Curv 2 Flow. On the T50, according to Ecovacs, the laser module sits inside the housing, hence the 81 millimeters. Also watch out for terms such as clearance height that are not explained.
What do you give up with a low-profile robot vacuum?
According to the data sheet, the T50 carries 70 milliliters of water on board, the taller T90 MAX 110. The T50's pads lift by 9 millimeters on carpet, the roller of the T90 MAX by 15. If you buy low-profile just for one sofa, you may be making compromises across the whole household.
Is there a low-profile robot vacuum with a mopping roller?
At 8.98 centimeters, the Roborock Saros 20 Flow Complete has the lowest stated height for a roller model in this comparison; you should have 9.5 centimeters of clearance. Tank and dock dimensions are missing from Roborock's model overview, so check them before buying.
What can I do if the robot vacuum does not fit under the furniture?
Ecovacs names three options: raise the furniture on taller feet, block off the underside, or set a no-go zone in the app. Set the no-go zone before the first mapping run and supervise the first cleaning. A box spring bed with low feet often remains a case for this.
Sources
- Ecovacs: DEEBOT T50 PRO OMNI Gen3
- Ecovacs: T50 Gen3 user manual
- Ecovacs: DEEBOT T90 MAX OMNI
- Ecovacs: DEEBOT mini 2
- Roborock: robot vacuum model overview
- Roborock: Qrevo Curv 2 Flow
- eufy: dimensions of the Omni C20 and dock
- eufy: Omni C20
- eufy: C10
- Kärcher: RVC 3 Comfort Extra
Where to buy
- DEEBOT T50 PRO OMNI Gen3View at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- Roborock Saros 20 NeoView at CoolblueAvailable in Germany: CoolblueCheck price at Amazon.deAvailable in Germany: Amazon.de
- eufy Omni C20View at CoolblueAvailable in Germany: CoolblueCheck price at Amazon.deAvailable in Germany: Amazon.de
- Roborock Saros 20 Flow CompleteCheck price at Amazon.deAvailable in Germany: Amazon.de
- DEEBOT T90 MAX OMNIView at EcovacsAvailable in Germany: EcovacsCheck price at Amazon.deAvailable in Germany: Amazon.de
- eufy C10Check price at Amazon.deAvailable in Germany: Amazon.de
