Black Friday Woche ab 19.11.: unsere Wahl je Ratgeber
Independent buying adviceEvery claim with a sourceNo paid verdictsIn 36 countries1,734 guides and reviews in German How we test
handgetestet
This page in 6 more languages

DeutschNederlandsFrançaisItalianoEspañolPolski

Smart Heating Control for Gas Boilers and Heat Pumps

Smart heating control for gas boilers and heat pumps: which gateway fits Vaillant, Viessmann, Buderus and Bosch, and when tado is the alternative.

handgetestet editorial team · Updated November 17, 2026
Contents11 sections

This guide was first published in German on handgetestet.de.

If you want to control your gas boiler or heat pump by app, look to the heating manufacturer first and only then to thermostat brands. The manufacturer’s gateway speaks the appliance’s language; a third-party thermostat often speaks only part of it. For a Vaillant system with a compatible controller, the myVAILLANT connect VR 940f is therefore our first choice. Viessmann, Buderus and Bosch have their own counterparts. And tado? It plays to its strengths where the boiler simply switches on and off or understands OpenTherm.

Why the boiler decides what goes in your cart

A heating system can talk to a controller in three ways. The simplest is a relay: the thermostat switches the boiler on or off, nothing more. OpenTherm works more finely; it is an open protocol through which the controller tells the boiler how hot the heating water should be. The burners then run more evenly. Manufacturers learn the most through their own bus. At Vaillant it is called eBUS, Bosch, Junkers and Buderus rely on EMS, and Viessmann connects older controls via the Optolink optical interface.

This leads to the typical bad buy. Someone buys a smart wall thermostat, connects it to a modulating boiler with a manufacturer bus, and finds that it can only switch on and off. Or it doesn’t fit at all. tado itself writes that the X series works with fewer modulating boilers than the older V3+ series and that a system that does not modulate via OpenTherm may not be compatible at all. A look at the rating plate and the boiler’s manual saves more money here than any energy-saving tip.

The manufacturers‘ gateways solve the problem differently. They connect to the bus or the control unit, read out error messages and, if you wish, let the heating contractor check in remotely. At Vaillant the whole thing is called myVAILLANT, at Viessmann ViCare, at Buderus MyBuderus, and at Bosch HomeCom Easy or EasyControl. That ties you to one brand. The German consumer advice center (Verbraucherzentrale) generally advises looking for open systems if you want to integrate devices from other providers later. For their current modules, Vaillant and Buderus name the EEBUS interface for this, and Vaillant additionally Apple HomeKit.

Plug it in yourself or call the heating contractor?

Nobody but a professional works on the gas line itself anyway. Under § 13 of the German Low Pressure Connection Ordinance (Niederdruckanschlussverordnung), work on the gas installation may only be carried out by the grid operator and registered installation companies. A gateway does not touch the gas line. But if you open the boiler housing to install it, you are dealing with mains voltage and control electronics.

The manufacturers draw the line differently. Vaillant only allows self-installation of the myVAILLANT connect on the newest appliances with a CIM connector; listed are the ecoTEC plus 1-5, ecoTEC exclusive 1-7 and the aroTHERM Split plus and aroTHERM plus x/8.1 heat pumps. For all other models, according to Vaillant, the heating contractor or customer service installs it, for example during servicing. Buderus’s MX400 plugs into a slot on the appliance or in the wall bracket, usually without opening the appliance. Bosch EasyControl requires a cable connection to the heating appliance, and for older Junkers appliances, according to Bosch, a qualified electrician may be needed. The Verbraucherzentrale puts it in general terms: wired systems belong in the hands of professionals.

Our advice is simple. Have the gateway installed at the next service visit. The appointment is coming anyway, and the technician can see right away whether the controller and software version are compatible. If you rent, talk to your landlord before anyone works on the boiler. More on this in our guide to smart home for renters (in German).

Five solutions for gas boilers and heat pumps

ModelCompatible according to manufacturer withConnection and appBest for
Vaillant myVAILLANT connect VR 940fVaillant with sensoCOMFORT, sensoDIRECT, sensoHOME or multiMATIC 700; not geoTHERM performWi-Fi, myVAILLANT, HomeKit, EEBUSVaillant boilers or aroTHERM from model year 2015/2016
Viessmann Vitoconnect OPTO2Viessmann with Vitotronic control and Optolink, including heat pumps with Vitotronic 200 WO1A to WO1CWi-Fi, ViCareOlder Viessmann systems without built-in Wi-Fi
Buderus MX400New EMS plus heat generators and all systems compatible with the MX300Wi-Fi or LAN cable, MyBuderus, EEBUSBuderus boilers and Logatherm heat pumps
Bosch EasyControl CT200Appliances with EMS 1.0 or 2.0 (Bosch, Junkers, Buderus, Nefit); OpenTherm and on/off only with an adapterCable to the heating appliance, Wi-Fi, EasyControl appBosch and Junkers gas boilers with room control
tado Smart Thermostat X Wired (2nd Gen.) Starter KitHeating systems with relay or modulating OpenThermThread and Matter, tado appBrand-independent solution if the boiler is not getting its own gateway

Vaillant myVAILLANT connect VR 940f

At Vaillant, the module has replaced the older sensoNET VR 921 and VR 920, which the manufacturer no longer offers. It requires one of the controllers sensoCOMFORT VRC 720, sensoDIRECT VRC 710, multiMATIC VRC 700 or sensoHOME VRT 380/2. According to Vaillant, the Wi-Fi at the installation location should deliver at least 16 Mbit, and there are no ongoing costs after installation. If the internet goes down, the system continues heating normally.

Viessmann Vitoconnect OPTO2

The box hangs on the wall and connects by cable to the Optolink interface of the Vitotronic. For Vitodens 1xx-W and 050-W with OpenTherm, built after October 2017, there is the OT2 variant. According to Viessmann, new Viessmann appliances with built-in Wi-Fi do not need a Vitoconnect at all. Check this before buying, or you will end up with a box in the basement that has nothing to do.

Buderus MX400

The LAN and wireless module goes online via Wi-Fi or, alternatively, via a network cable, which is handy in basements the router signal does not reach. According to Buderus, the EEBUS interface allows heat pumps to be connected to a smart meter gateway, which plays a role for subsidies and for § 14a of the German Energy Industry Act (Energiewirtschaftsgesetz). Setup runs through the MyBuderus app.

Bosch EasyControl CT200

A room controller on the wall instead of a box in the basement. Bosch describes it as a modulating thermostat, and exactly one fits each heating appliance. You control individual rooms with smart radiator thermostats from the same family. Bosch does not include heat pumps in the list, and the manufacturer limits support for the product family to the end of 2032.

tado Smart Thermostat X Wired (2nd Gen.)

On sale since September 2026, only 17.8 mm thin, it replaces the existing room thermostat on the wall. According to tado, a built-in rechargeable battery lasts up to a year and is charged via USB-C. The X series devices communicate via Thread, so you need a Thread border router, such as the Bridge X from the Starter Kit. The X series cannot be combined with older tado devices from the V3+ series. How the thermostat is connected in an apartment or house is explained in our guide to smart room thermostats.

What does it really save?

Less than the advertising suggests. The Verbraucherzentrale cites two to eight percent of heating costs for automatic setback during absence, depending on previous habits, and explicitly views manufacturer claims of maximum savings critically. co2online puts each degree less of room temperature at around six percent of heating energy. tado advertises an average of 22 percent among its customers. That is a manufacturer claim, not an independent measurement.

The real benefit lies elsewhere. An error message lands on your phone instead of only being noticed during a cold shower, and the heating contractor can fine-tune settings remotely if you allow it. If you want to connect the whole house, you will find the starting point in our guide to smart home starter kits.

How we would decide

  • Vaillant system with a compatible controller: myVAILLANT connect VR 940f, installed by the heating contractor on older appliances.
  • Viessmann without built-in Wi-Fi: Vitoconnect OPTO2, or the OT2 variant for OpenTherm Vitodens units.
  • Buderus with EMS plus, especially with heat pumps: MX400.
  • Bosch or Junkers with EMS and a wish for a controller on the wall: EasyControl CT200, as long as support until 2032 is enough for you.
  • Third-party boiler with relay or OpenTherm and interest in Matter: tado X Wired. For modulating boilers with a manufacturer bus, better go with the manufacturer’s gateway.

And if the heating system is more than ten years old? Then ask the heating contractor first whether any gateway fits at all. Sometimes a new controller is the real step.

Besides consumption, the tariff determines your heating costs. What matters with price guarantees, bonuses and cancellation is explained in our guide switching gas providers.

How to make the boiler’s actual consumption visible is shown in our guide reading your gas meter (in German). What helps during a power outage is covered in our guide heating during a power outage (in German).

Frequently asked questions

Does every smart thermostat fit my gas boiler?

No. A heating system talks to its controller via a relay, via OpenTherm or via the manufacturer's own bus. A third-party thermostat on a modulating boiler with a manufacturer bus may only be able to switch it on and off, or may not fit at all. The boiler's rating plate and manual will tell you in advance.

What is OpenTherm?

An open protocol through which the controller tells the boiler how hot the heating water should be, instead of just switching it on and off. The burners then run more evenly. tado writes that a system that does not modulate via OpenTherm may not be compatible with the X series.

Can I install the boiler gateway myself?

That depends on the manufacturer. Vaillant only allows self-installation on the newest appliances with a CIM connector; otherwise a heating contractor installs it. Buderus's MX400 usually plugs in without opening the appliance. Our advice: have the gateway installed at the next service visit; renters should talk to their landlord first.

How much does smart heating control save?

Less than the advertising suggests. The German consumer advice center (Verbraucherzentrale) cites two to eight percent of heating costs for automatic setback during absence, depending on previous habits. According to co2online, each degree less saves around six percent of heating energy. Higher advertised figures are manufacturer claims, not independent measurements.

Does the system keep heating if the internet goes down?

With myVAILLANT connect, yes; according to Vaillant, the system then continues heating normally. The module needs at least 16 Mbit Wi-Fi at the installation location and incurs no ongoing costs after installation.

Do I need the Vitoconnect with a new Viessmann heating system?

According to Viessmann, new Viessmann appliances with built-in Wi-Fi do not need a Vitoconnect at all. The OPTO2 box is intended for older systems with Vitotronic control and Optolink. Check this before buying, or you will end up with a box in the basement that has nothing to do.

Sources

Where to buy

Shop in:

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.