Black Friday Woche ab 19.11.: unsere Wahl je Ratgeber
Independent buying adviceEvery claim with a sourceNo paid verdictsIn 36 countries1,734 guides and reviews in German How we test
handgetestet
This page in 6 more languages

DeutschNederlandsFrançaisItalianoEspañolPolski

Infrared Heaters in the Bathroom: Zones, Mirrors, Towels

Infrared heating in the bathroom: which protection rating is allowed where, how many watts a bathroom needs, what heated mirrors can do and when towels become a risk.

handgetestet editorial team · Updated November 17, 2026
Contents12 sections

This guide was first published in German on handgetestet.de.

Before you start thinking about a mirror or a panel, measure the distance to the shower. That measurement determines where an infrared heater may be mounted in a bathroom. The protection rating alone does not settle it, because in the innermost zone the device also needs the manufacturer’s approval and a fixed connection installed by a qualified electrician. As short bursts of extra warmth in the morning and evening, infrared makes sense in the bathroom; as the only heating, only in a well-insulated room. We are not naming a clear favorite here: we have no independent measurements of heated mirrors, and the data comes from the manufacturers.

Where in the bathroom can the device be mounted?

The German standard DIN VDE 0100-701 divides rooms with a bathtub or shower into zones. Its current edition dates from June 2025; the freely available technical explanations from BauNetz Wissen and the German trade journal »de« describe the 2008 edition. They are fine for the basics, but in individual cases the new version applies:

  • Zone 0 is the inside of the bathtub or shower tray. A heater is out of the question here. The 2025 edition introduces this zone for showers without a tray as well.
  • Zone 1 extends above the bathtub or shower tray up to a height of 2.25 meters or, if the fixed water outlet is higher, up to that point. To the side, it ends at the edge of the tub.
  • Zone 2 adjoins it with a width of 60 centimeters. Permanently installed appliances need at least IPX4 here, and 230-volt sockets are not permitted.
  • For a shower without a tray, zone 1 covers a radius of 1.20 meters. It is measured horizontally from the center of the fixed water outlet, meaning the shower head, even if it swivels. A longer shower hose does not increase the distance; a wall limits it.

The last point is the trap. In a small bathroom with a walk-in shower, the opposite wall quickly falls within the 1.20 meters. The technical explanations differ on which protection rating applies there. BauNetz Wissen names IPX5. In its explanation based on the 2008 standard text, the journal »de« names at least IPX4, and as early as 1998 the trade journal SBZ described IPX4 in homes for the previous version, with IPX5 only where water jets are to be expected, such as with a massage shower. We therefore assume IPX4 as the standard value.

Even with IP44, that does not settle the matter. According to »de«, devices are only permitted in zone 1 if the manufacturer approves them for this zone and they are stationary and permanently connected. The list for the 2008 edition names fans, water heaters, towel dryers and whirlpool equipment, but no heating panels. According to DIN, the 2025 edition permits additional devices, explicitly including infrared heaters. Whether a heated mirror or panel falls under this is something for the manufacturer’s approval and a qualified electrician to clarify. We know of no such approval for the four devices below, and „suitable for bathrooms“ on the box is no substitute for one. So plan for them outside zone 1.

The plug matters too. Könighaus states in its instructions that installation or use in wet rooms must always be carried out by a specialist company in accordance with VDE 0100 Part 701. The device should not hang near a bathtub or shower, and switches and controls must be placed so that no one can reach them from the tub or shower.

How much power a bathroom really needs

More than a living room of the same size. In a 2022 master’s thesis at TU Graz in Austria, calculated with one supplier’s design software, a 7.5-square-meter bathroom comes to 276 watts when well insulated, 690 watts with medium insulation and 829 watts when poorly insulated. That is 37, 92 and 110 watts per square meter.

So in a medium-insulated bathroom of this size, a 450-watt mirror covers only about two thirds of the demand. As a supplement to a radiator, that is enough. As the only heating, it is not. The manufacturers‘ room-size figures sound more generous: Könighaus names five to twelve square meters for 450 watts. In the bathroom, the lower number applies.

Extra warmth costs little, continuous use a lot

The ADAC (German automobile club) gives an average electricity price of 37 cents per kilowatt hour for 2026, which makes it easy to convert any running time. If a 500-watt device runs for one hour on 180 days, that comes to 90 kilowatt hours a year. If 690 watts heat the same bathroom eight hours a day, that becomes 994 kilowatt hours at full load, eleven times as much. Both are assumptions; the calculation only shows the gap. That is why a thermostat or timer belongs with it.

And how quickly does it get warm? In its instructions, Könighaus speaks of five to ten minutes until the heater has warmed up. In the TU Graz laboratory, a panel from the P series, a different line from the same manufacturer, took 51 minutes to reach its final temperature. You feel the radiation early; the room follows later. So do not switch it on only once you are already standing in the bathroom.

Mirror, panel or towel rail?

A heated mirror saves wall space and, according to the manufacturers, does not fog up while heating. It still gets hot, though. Könighaus states 75 to 125 degrees Celsius for its mirror heater; the Energie Agentur Steiermark, an Austrian energy agency, names around 110 degrees as the upper limit for wall mounting and recommends safety glass for mirror fronts. With children in the house, that is a real argument against mounting it within reach. If you are just looking for a bright mirror, you will find the less expensive solution in the guide to bathroom mirrors.

Towels are where things go wrong most often. Hung over a panel, they can cause heat to build up: Könighaus prohibits any covering during operation and requires 50 centimeters of clearance at the front and 20 centimeters at the sides, top and bottom. A matching holder is not available for everything. At Könighaus, it only fits the mirror heater and the glass series; at Vasner, only the Citara models with 700, 900 and 1,100 watts. Vasner also writes that the rail is meant for drying and that dry towels should be removed because they block the radiation. If warm towels are at the top of your list, a heated towel rail (in German) is the more honest choice.

Four bathroom devices compared

ModelTypePower and dimensionsProtection ratingTowel holder
Könighaus Spiegel Infrarotheizung 450 Watt ThermostatMirror450 W, 60 × 100 × 1 cmIP44as an accessory
VASNER Citara M 900 WattMetal900 W, 60 × 120 × 2.5 cmIP44as an accessory
VASNER Citara M 300 WattMetal300 W, 60 × 40 × 2.5 cmIP44does not fit
Bosch Heat Infrared 4000 P 300 WattMetal300 W, 59.2 × 59.2 × 3.3 cmIP44not specified

Könighaus Spiegel Infrarotheizung 450 Watt Thermostat

Very slim at one centimeter deep according to the manufacturer, with slightly tinted glass. The thermostat is a must here, because when permanently mounted the device may only run with a controller. Könighaus itself adds a restriction: only for well-insulated rooms or occasional use. Whether the front is made of safety glass is not clear from the product page.

VASNER Citara M 900 Watt

For the larger bathroom that has to manage without other heating. With medium insulation at 92 watts per square meter, 900 watts is mathematically enough for just under ten square meters. Vasner states IP44 for both plug-in and hardwired connection, plus a ten-year warranty. According to the manufacturer, the metal front gets up to about 110 degrees warm. The controller is sold separately; suggestions are in the guide to smart controls for electric heaters (in German).

VASNER Citara M 300 Watt

The small 60 by 40 centimeter format fits next to the door in a guest toilet. In Graz, a three-square-meter toilet with medium insulation came to 262 watts. The towel rails cannot be mounted on this size.

Bosch Heat Infrared 4000 P 300 Watt

Square, weighing 5.5 kilograms, IP44, and according to Bosch designed for walls and ceilings and for rooms of five square meters or more. In a cramped bathroom, the ceiling is an advantage because no wall space is lost. In that case, check especially carefully that the spot is outside zone 1.

Damp walls: what infrared does not solve

According to the Energie Agentur Steiermark, poor planning or an unsuitable building can lead to mold in cold corners. Panels therefore belong on or near the exterior wall, aimed specifically at the cold spot. Ventilating remains a must. A thermo-hygrometer shows whether the humidity drops again after showering. The basics of choosing between electric heaters are in the overview of infrared heaters and fan heaters (in German).

Which device for which bathroom?

  • Radiator present, mirror fogs up, wall well insulated: Könighaus with 450 watts, provided the distance to the shower is right.
  • Bathroom without other heating, well insulated: Vasner with 900 watts plus a thermostat.
  • Guest toilet: Vasner or Bosch with 300 watts.
  • Wall within 1.20 meters of the shower head: none of the four devices, as long as neither a manufacturer’s approval nor a qualified electrician confirms the location.

Frequently asked questions

Where can an infrared heater be mounted in a bathroom?

Outside zone 1, which extends above the bathtub or shower tray up to 2.25 meters and, for showers without a tray, 1.20 meters around the shower head. A device there needs the manufacturer's approval and a fixed connection. We know of no such approval for the four devices compared, and IP44 alone is not enough.

Is an infrared heater enough as the only heating in a bathroom?

Only in a well-insulated room. According to a master's thesis at TU Graz, a 7.5-square-meter bathroom needs 276 watts when well insulated, 690 watts with medium insulation and 829 watts when poorly insulated. A 450-watt mirror covers only about two thirds in the medium case; as a supplement to a radiator, that is enough.

What does an infrared heater in the bathroom cost to run?

If a 500-watt device runs for one hour on 180 days, that comes to 90 kilowatt hours a year. If 690 watts heat the same bathroom eight hours a day, that becomes 994 kilowatt hours at full load, eleven times as much. That is why a thermostat or timer belongs with it.

How hot does a heated mirror get?

Könighaus states 75 to 125 degrees Celsius for its mirror heater; the Energie Agentur Steiermark (Austrian energy agency) names around 110 degrees as the upper limit for wall mounting and recommends safety glass for mirror fronts. With children in the house, that argues against mounting it within reach.

Can you hang towels over an infrared heater?

Not directly over it, as heat can build up. Könighaus prohibits any covering during operation and requires 50 centimeters of clearance at the front. Matching holders are only available for certain models, and Vasner advises removing dry towels because they block the radiation. For warm towels, a heated towel rail is the more honest choice.

Does an infrared heater help against mold in the bathroom?

Not by itself. According to the Energie Agentur Steiermark, poor planning can lead to mold in cold corners. Panels therefore belong on or near the exterior wall, aimed specifically at the cold spot. Ventilating remains a must, and a thermo-hygrometer shows whether the humidity drops again after showering.

Sources

Where to buy

Shop in:

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.