Contents14 sections
This guide was first published in German on handgetestet.de.
Lawn edging is usually bought too shallow. If you really want to keep grass roots out of the bed, you need a profile that sits deep enough in the ground and still does not get in the way at the top. For most gardens, galvanized steel 12.5 cm high is therefore the sensible choice, for example the bellissa Rasenkante Metall 12,5. Plastic on a roll is enough for straight beds with little pressure. If you use a robot mower, you plan the edging differently: flush with the ground.
How deep does lawn edging need to go into the ground?
At least 8 cm. That is the figure bellissa gives for an effective root barrier. With 12.5 cm high edging, that leaves a good 4 cm that can be visible. It does not need to be more. Less also works if you set the edging almost flush and want to mow over it.
When calculating length, use the usable length, not the figure on the package. A 118 cm bellissa element yields 115 cm once connected. Over 20 meters of bed edge, that adds up to one extra element. In soft, loose soil, the manufacturer also recommends ground anchors, roughly every 60 cm.
Metal, plastic or stone?
Steel is thin, malleable and sturdy. The bellissa edgings are made of 0.65 mm sheet steel, hot-dip galvanized to ISO 1461, with a beaded, meaning folded-over, top edge that according to the manufacturer makes the profile torsion-resistant. Thanks to the perforated side, angles of up to 90 degrees can be set. Cutting an element with tin snips damages the zinc coating; bellissa advises treating the cut with zinc spray.
Plastic comes on a roll or in short pieces and follows every curve. Gardena states that its lawn edging is resistant to rain and UV radiation. bellissa, which sells both materials, is more reserved about plastic: heat, UV and water wear the material down, and it can splinter when mowed over uneven ground. The manufacturer estimates its service life at five years at most. That is a manufacturer’s statement, but a remarkably candid one.
Stone is the heaviest solution. A row of paving or edging stones set in concrete needs a dug trench and a load-bearing base, so it is more of a weekend project than an afternoon job. Its advantage shows mainly with a robot mower.
What changes with a robot mower?
Almost everything. The robot only mows up to its boundary wire, and how close that wire may lie to the edging depends on the edging’s height. The quick guide for the STIHL iMow RMI 5 names two cases. If the lawn borders a drivable surface with a step of less than 1 cm to the turf, the wire may lie directly at the edge. For an obstacle higher than 1 cm, a distance of 28 cm is required. The strip in between is then left to the trimmer; see our guide to hedge trimmers and grass trimmers (in German).
A mowing strip for robots therefore lies flat, with a running surface the wheel rolls over. bellissa states explicitly that the boundary wire does not belong under the metal edging and refers to the manual of the respective device for the distances. The values differ from manufacturer to manufacturer. If you have not chosen yet, you will find models without a wire in our buying advice on robot mowers without a boundary wire (in German).
Seven lawn edgings side by side
| Model | Material and thickness | Height and length | Best for |
|---|---|---|---|
| bellissa Rasenkante Metall 12,5 | Hot-dip galvanized steel, 0.65 mm | 12.5 cm, 118 cm (115 cm usable) | Bed edges with a root barrier |
| bellissa Rasenkante anthrazit 19,5 | Galvanized and powder-coated steel, 0.65 mm | 19.5 cm, 118 cm (115 cm usable) | Height differences, gravel, dark look |
| bellissa Rasenkante Corten 20 | Corten steel, 0.65 mm | 20 cm, 118 cm (115 cm usable) | Rust look in natural gardens |
| bellissa Rasenkante Comfort 9 L | Galvanized steel, 0.65 mm, 4 cm mowing strip | 9 cm, 118 cm (114 cm usable) | Mowing with a lawn mower without touch-up work |
| bellissa Mähkante L verzinkt | Hot-dip galvanized steel, 1.2 mm | 12 cm, 80 cm, 6.5 cm wide | Gardens with a robot mower |
| Gardena Raseneinfassung 15 cm | Plastic, roll | 15 cm, 9 m | Long, straight edges with little load |
| bellissa Rasenkante Comfort Kunststoff 11 | Plastic, 2.5 mm | 11 cm, 50 cm | Tight curves around trees and islands |
bellissa Rasenkante Metall 12,5
This is the edging we would start with in an ordinary garden. Hot-dip galvanized sheet steel, a beaded top edge and a patented connector whose pin you bend over with a screwdriver. At 12.5 cm high, it is enough for the 8 cm root barrier and still leaves some leeway at the top. bellissa offers a five-year warranty.
bellissa Rasenkante anthrazit 19,5
The same principle, but taller and additionally powder-coated. You need the 19.5 cm if you want to bridge a difference in height, for example between the lawn and a slightly raised bed or a gravel area. For a level edge, it is too tall. Seven extra centimeters of steel in the ground achieve nothing there.
bellissa Rasenkante Corten 20
Corten steel is a matter of taste. The steel arrives bare and only forms its rust layer outdoors; according to bellissa, the first patina appears after up to three months and the final one after two to three years. The manufacturer recommends installing it in late fall so the protective layer can develop over the winter.
bellissa Rasenkante Comfort 9 L
Here, a 4 cm wide mowing strip runs along the top. bellissa describes the profile as drivable with a lawn mower from inside and outside. That saves trimming the edge with shears. In return, the profile is only 9 cm high, so the root barrier is shallower than with the 12.5 cm edging.
bellissa Mähkante L verzinkt
Built for robot mowers. At 1.2 mm, the steel is almost twice as thick as on the other bellissa edgings, and the running surface is 6.5 cm wide. Two elements overlap by at least 3 cm and together yield 147.5 to 155 cm, depending on the angle. Lay the boundary wire according to your robot’s manual, but not under the metal.
Gardena Raseneinfassung 15 cm
A 9 m plastic roll in an earth tone that Gardena describes as resistant to rain and UV. For long, straight edges without much load, it is quick to install: we would cut a slot with a spade and stand the roll in it. Gardena offers a five-year warranty if the product is registered within three months. The same roll is also available 9 cm high; we would only choose that one if there is hardly any root pressure.
bellissa Rasenkante Comfort Kunststoff 11
Short 50 cm pieces of 2.5 mm thick plastic that, according to the manufacturer, can be shaped to any radius and are designed as a drivable mowing strip. A serrated bottom edge anchors the profile in the ground. For tree rings and round islands, this is easier to handle than any sheet steel.
Can you do it without tools?
Not quite. With bellissa, a screwdriver is enough for the connection, but the ground has to be cut open first with a lawn edger or a marked spade. After that, you drive the edging in evenly with a rubber mallet and a piece of wood laid on top, as the manufacturer describes it. Then mow the lawn in front of it short enough for the line to stay visible; which mower is suitable for that is covered in our cordless lawn mower guide.
How we would decide
- Ordinary bed edge, mowing with a push mower: bellissa Rasenkante Metall 12,5, set a good 8 cm deep.
- Never trim the edge again: bellissa Comfort 9 L with a drivable mowing strip.
- Robot mower in the garden: bellissa Mähkante L, or a flush row of stones with a step of less than 1 cm.
- Height difference or gravel path: the anthracite 19.5 cm edging.
- Tight curves, little load: the Gardena roll or the short plastic Comfort pieces.
How close robot mowers get to the edge is covered in the guide Robot mowers and lawn edging.
Frequently asked questions
How deep does lawn edging need to go into the ground?
At least 8 cm; bellissa gives this figure for an effective root barrier. With 12.5 cm high edging, a good 4 cm remain visible. When calculating length, use the usable length: a 118 cm element yields 115 cm once connected. In loose soil, the manufacturer recommends ground anchors about every 60 cm.
Metal or plastic lawn edging?
Steel is thin, malleable and sturdy; bellissa's is hot-dip galvanized with a beaded top edge. Plastic follows every curve, but according to bellissa, heat, UV and water wear it down, and it can splinter when mowed. The manufacturer estimates its service life at five years at most.
Which lawn edging works with a robot mower?
A flat mowing strip with a running surface the wheel rolls over, such as the bellissa Mähkante L, 6.5 cm wide. With the STIHL iMow RMI 5, the wire may lie directly at the edge if the step is less than 1 cm; for higher obstacles, a distance of 28 cm is required. The wire does not belong under the metal edging.
Is there lawn edging you can mow over?
The bellissa Comfort 9 L has a 4 cm wide mowing strip on top that, according to the manufacturer, a lawn mower can drive over from inside and outside. That saves trimming the edge with shears. In return, the profile is only 9 cm high, so the root barrier is shallower.
What should you keep in mind when shortening metal edging?
Cutting an element with tin snips damages the zinc coating. bellissa advises treating the cut with zinc spray. With Corten steel, rust is intended; according to the manufacturer, the first patina appears after up to three months.
How do you install lawn edging?
First cut into the ground with a lawn edger or a marked spade. Then drive the edging in evenly with a rubber mallet and a piece of wood laid on top, as bellissa describes it. A screwdriver is enough for the connector.
Sources
- bellissa: Rasenkante Metall 12,5
- bellissa: Rasenkante anthrazit 19,5
- bellissa: Rasenkante Corten 20
- bellissa: Rasenkante Comfort 9 L
- bellissa: Mähkante L verzinkt
- bellissa: Rasenkante Comfort 11
- bellissa: Lawn edging, material and installation
- Gardena: Raseneinfassung, 15 cm high
- Gardena: Raseneinfassung, 9 cm high
- STIHL: iMow RMI 5, quick guide (PDF)
Where to buy
- bellissa Rasenkante Metall 12,5 verzinktCheck price at Amazon.deAvailable in Germany: Amazon.de
- bellissa Rasenkante anthrazit 19,5Check price at Amazon.deAvailable in Germany: Amazon.de
- bellissa Rasenkante Corten 20Check price at Amazon.deAvailable in Germany: Amazon.de
- bellissa Rasenkante Comfort 9 LCheck price at Amazon.deAvailable in Germany: Amazon.de
- bellissa Mähkante Mähroboter verzinktCheck price at Amazon.deAvailable in Germany: Amazon.de
- Gardena Raseneinfassung 15 cmCheck price at Amazon.deAvailable in Germany: Amazon.de
- bellissa Rasenkante Comfort Kunststoff 11Check price at Amazon.deAvailable in Germany: Amazon.de
