Contents10 sections
This guide was first published in German on handgetestet.de.
Parquet, laminate, expensive carpet: an office chair caster traces the same path every day. Most people only put down a chair mat once the track is already there. For hard floors, our suggestion is the polycarbonate ULTIMAT II in 116 × 150 centimeters, because it lies flat, is suitable for underfloor heating and is large enough for the rolling area. The thin FORTIFLEX is enough if price matters most and the chair hardly moves.
Before the mat: check the casters
Before you spend any money, turn the chair over. The DGUV Grundsatz 315-411 (a principle of the German Social Accident Insurance) puts it briefly: hard casters for soft floors, soft casters for hard floors. Correctly fitted casters minimize wear on floor coverings. So hard casters on parquet are a mismatch, and a new set of casters is often the first sensible step. According to the principle, chair casters should be replaceable without tools or with simple aids.
The mat is then the second layer of protection. According to Floortex, it distributes the pressure of the casters and catches the dirt that shoes bring in. That is also necessary if the floor is delicate or if you rent and don’t want to explain the marks when you move out. A chair manufacturer such as hjh itself recommends a mat for delicate floor coverings, even when hard-floor casters are fitted.
Size: measure the rolling area, not the chair
This is where the typical mistake happens. Floortex advises measuring the outermost points the chair reaches while you work and buying accordingly. According to hjh, the base of common office chairs measures between 59 and 74 centimeters. On a mat 90 centimeters deep, that leaves little room for movement before a caster slides over the edge. And that is exactly what shouldn’t happen, because then the chair sits at an angle and the edge suffers.
For the typical desk, 116 × 150 centimeters is the more sensible size. If you shuttle between two surfaces at a corner desk, you need more. Floortex makes XXL sizes for this, but they call for a separate inquiry about dimensions and backing. If the mat doesn’t reach under the edge of the desk, you roll up onto it every time you pull in. So the mat has to lie partly under the desk.
You shouldn’t cut it to size yourself, says Floortex: that can damage the mat, and it can crack.
Four materials, four sets of properties
Polycarbonate is the rigid, clear material. Floortex describes it as color-stable, dimensionally stable and odor-neutral and recommends it for frequent use. According to the manufacturer, the mats roll out flat immediately after unpacking. They are suitable for underfloor heating.
Vinyl, meaning PVC, is softer. Floortex offers it as a less expensive alternative and cites a formulation without intentionally added orthophthalates. The manufacturer’s notes, however, state that PVC is not suitable for underfloor heating, and that after unrolling the mat needs at least 72 hours in a warm environment before it lies flat. Putting books on the corners helps. We deliberately left vinyl out of the table below: with underfloor heating it is ruled out, and at our partner the comparable vinyl mat was recently even priced above the ULTIMAT II.
Recycled PET is used in the PUNOMAT, polypropylene in the FORTIFLEX. The seller lists both as suitable for underfloor heating. They are thinner than polycarbonate; the FORTIFLEX measures only about one millimeter.
Five mats compared
hjh is the house brand of buerostuhl24 (German retailer), the retailer behind our links. The ULTIMAT II comes from Floortex, the PUNOMAT from Kottig. Thicknesses according to hjh, where stated.
| Model | Size | Material and thickness | Floor | Best for |
|---|---|---|---|---|
| ULTIMAT II Hartböden 116 x 150 | 116 × 150 cm | Polycarbonate, 1.9 mm | Parquet, laminate, cork, tiles | Everyday workstation |
| ULTIMAT II Hartböden 120 x 90 | 120 × 90 cm | Polycarbonate, 1.9 mm | Parquet, laminate, cork, tiles | Small desks, little rolling area |
| ULTIMAT II Teppichböden | 116 × 150 cm | Polycarbonate, anchor studs | Carpet up to 12 mm pile | Carpeted offices |
| PUNOMAT | 120 × 90 cm | PET, 1.8 mm, grip layer | Hard floors, including lacquered | Recycled material |
| FORTIFLEX | 120 × 90 cm | Polypropylene, 1 mm | Parquet, laminate, tiles | Little movement |
ULTIMAT II for hard floors
Polycarbonate at 1.9 millimeters, highly transparent, according to the seller suitable for underfloor heating, with a finely textured top side. The smooth side faces down. On very smooth, polished floors it can slip; there, Floortex recommends mats with a non-slip backing. For small desks, the same mat comes in 120 × 90 centimeters, but then you should measure the rolling area beforehand.
ULTIMAT II for carpeted floors
The studs grip the pile, for low- to medium-pile carpet up to twelve millimeters. Measure the pile height, and according to Floortex, including the underlay. If the limit is exceeded, the mat can slip or lie unevenly, and rolling becomes tiresome. According to the seller, the anchor studs are meant to reduce slipping, but they cannot rule it out entirely.
PUNOMAT and FORTIFLEX
The PUNOMAT has a non-slip grip layer and, according to the seller, is intended for all hard floors, including lacquered or glazed ones. It is also said to cover spots that are already damaged or worn, which can be handy in a rented office in particular. According to hjh, the FORTIFLEX is free of plasticizers and comes in two sizes; it is said to be impact-, tear- and break-resistant, and at 1.6 kilos it is light enough to carry on your own. Both are milky, so the floor only shows through faintly. For everyday chair use, the thickness alone speaks for polycarbonate.
Care and two warnings
Lay it on a clean, dry surface. Sand under the mat grinds down the floor, and moisture is the second danger: Floortex warns of mold when a wet mat sits on the floor and of newly laid or glued floors that are still giving off fumes. Wait until everything is dry, and if in doubt, ask your flooring supplier. Clean with mild soapy water, not with solvents or bleach. The usual mats don’t have beveled edges, so step over them consciously, especially in walkways.
The quick decision
Parquet or laminate: ULTIMAT II Hartböden (hard floors) in 116 × 150 centimeters. Carpet: ULTIMAT II Teppichböden (carpeted floors). A rarely used second workspace: FORTIFLEX. Suitable chairs with the right casters are in the guide to the ergonomic office chair, and if you stand a lot, take a look at the guide to the sit-stand stool (in German).
Frequently asked questions
Do I need a floor protection mat under my office chair?
The casters come first. The DGUV Principle 315-411 (German Social Accident Insurance) specifies hard casters for soft floors and soft casters for hard floors; often a new set of casters is the first step. The mat is the second layer of protection, useful for delicate floors or in a rental apartment.
What size should a chair mat be?
Measure the rolling area, not the chair. According to hjh, the base of common office chairs measures between 59 and 74 centimeters, which leaves little room for movement on a mat 90 centimeters deep. For the typical desk, 116 × 150 centimeters is the more sensible size.
What is the difference between polycarbonate and vinyl?
Polycarbonate is rigid, clear and, according to Floortex, rolls out flat immediately; underfloor heating is not a problem. Vinyl is softer, according to the manufacturer's notes is not suitable for underfloor heating, and needs at least 72 hours in a warm environment after unrolling before it lies flat.
Which chair mat is suitable for carpet?
The ULTIMAT II for carpeted floors grips low- to medium-pile carpet up to twelve millimeters with its studs. According to Floortex, measure the pile height including the underlay. If the limit is exceeded, the mat can slip or lie unevenly, and rolling becomes tiresome.
Can I cut a chair mat to size?
Floortex advises against it, because it can damage the mat and the mat can crack. It is better to choose the right size from the start; for corner desks, Floortex makes XXL sizes on request.
What should I keep in mind when laying the mat?
Lay it only on a clean, dry surface, because sand underneath grinds down the floor. Floortex warns of mold under a wet mat and of newly laid floors that are still giving off fumes. Clean it with mild soapy water, not with solvents or bleach.
Sources
- DGUV Grundsatz 315-411: Quality criteria for office workstations
- Floortex: Chair mats by floor type and frequently asked questions
- Floortex: Mat materials
- Floortex: FAQ (in English)
- Floortex: Mat sizes (in English)
- hjh OFFICE: ULTIMAT II for hard floors
- hjh OFFICE: ULTIMAT II for carpeted floors
- hjh OFFICE: FORTIFLEX
- hjh OFFICE: PUNOMAT
Where to buy
- ULTIMAT II Hartböden 116 x 150View at buerostuhl24Available in Germany: buerostuhl24
- ULTIMAT II Hartböden 120 x 90View at buerostuhl24Available in Germany: buerostuhl24
- ULTIMAT II TeppichbödenView at buerostuhl24Available in Germany: buerostuhl24
- PUNOMATView at buerostuhl24Available in Germany: buerostuhl24
- FORTIFLEXView at buerostuhl24Available in Germany: buerostuhl24

