Contents15 sections
This guide was first published in German on handgetestet.de.
Green water in June rarely has to do with too little filtration. Usually the cause is a UV-C bulb that is too small, a hose that is too thin, or a filter rated for a pond without fish. For a garden pond with a few goldfish up to about 2,500 liters, we consider the Oase FiltoClear Set 5000 the solid choice, because Oase openly states the limit with fish stocking and the filter, UV-C and pump are properly matched to one another. If you have more water, or only a small liner pond without fish, you will find more suitable devices below.
How much power the pump needs and how to read the maximum head correctly is covered in our guide to pond pumps and pond filters (in German). This one is about the canister itself: what happens inside the pressure filter, why the figures on the box are so far apart, and which details decide between hassle and peace of mind in the second summer.
What actually happens in that gray canister
The pump pushes pond water into a closed container. There, it flows through foam sponges that hold back suspended particles. Bacteria settle on the same sponges and convert ammonium via nitrite into nitrate. Oase describes this in great detail in the FiltoClear manual: the coarse-pored sponge with 10 ppi lets a lot of water through, while the fine one with 30 ppi slows the flow and provides space for bacteria that break down nitrate further. After that, the water flows past a UV-C bulb in a quartz glass tube. Suspended algae die off, and the water turns clear.
Two things surprise many buyers. According to Oase, the bacteria only start working at a water temperature of 10 degrees. And it takes weeks for the sponges to be fully colonized; T.I.P. states five to six in its manual. So if you install a new filter in April and are disappointed after ten days, you have not done anything wrong. You were just too early.
Why „up to 10,000 liters“ means little
First calculate your volume: length times width times average depth. A pond measuring 3 by 2 meters with an average depth of 60 centimeters holds 3.6 cubic meters, or 3,600 liters. Take this figure to the manufacturer specifications, and that is exactly where things get confusing.
Oase gives two figures for the FiltoClear 5000: 5,000 liters without fish, 2,500 liters with fish. Heissner likewise halves the figure for the HLF4000-00, from 4,000 to 2,000 liters. For koi, Oase gives only 5,000 of 19,000 liters for the FiltoClear 19000, just over a quarter. T.I.P. simply writes „up to 5,000 liters“ for the TFP 5000 UV 9 and adds in the manual that many fish, few plants and a lot of sun can significantly reduce the effectively cleaned volume. By how much, it does not say.
Our advice: compare only the figures with fish stocking. Where a manufacturer does not give one, deduct half yourself. A pond in full sun without shade from water lilies justifies going one size up.
UV-C: watts, bypass and a bulb that ages
The UV-C output shows how seriously a manufacturer takes clarification. Oase uses an 18-watt bulb in the FiltoClear 5000, Heissner 7 watts in the HLF4000-00 for almost the same volume, and T.I.P. exactly 9 watts in the TFP 5000 UV 9. More watts alone do not make clear water, because what matters is how long the water flows past the bulb. Oase therefore directs only about 70 percent of the water through the UV-C chamber; the rest flows through a bypass. That way, the exposure remains sufficient even at a high flow rate.
The bulb loses effectiveness over time, even if it still lights up. Oase specifies 8,000 hours for the 18-watt bulb, i.e. one pond season. T.I.P. reckons with around 4,000 hours and advises replacing it after one season from March to October at the latest. So plan on a replacement bulb every spring. If the quartz glass is scratched or clouded, according to Oase it should be replaced as well.
A detail you will not find in any advertising: if you add starter bacteria or pond treatments, switch off the UV-C temporarily. Oase specifies 24 hours after adding bacteria, and T.I.P. generally recommends switching it off during water treatment. Otherwise, the bulb irradiates exactly what you have just added.
Backwashing without opening the lid
Filter cleaning used to mean: lid off, sponges out, black hands. Today, all the devices in our table have a backwash function. On the FiltoClear, you turn a valve to the cleaning position and pull the handle several times. That compresses the sponges, and the dirty water drains through a separate outlet. T.I.P. works with a selector switch and a crank, and Heissner calls its system Easy Clean.
The dirty water is rich in nutrients. Oase suggests directing it through a hose into a flower bed, such as the raised bed next to the pond. The cap on the dirty water hose is important: if the outlet is left open, according to Oase the pond can drain without you noticing. On the TFP 10000 and 15000, you move the drain hose to a different connection for this. A thorough cleaning twice a year is still a must, says T.I.P., and with pond water rather than tap water so that the bacteria survive.
The hose slows things down more than you think
An underestimated point. For the FiltoClear, Oase recommends hoses with 50 millimeters to keep pressure losses low; the hose connectors fit 38 and 50 millimeters. The manual of the matching pump also states that the hose on the suction side must never be thinner than on the pressure side and that you should trim the stepped hose connector to fit. Many sets come with a 19-millimeter hose in the box. That is enough for small pumps, as the T.I.P. performance curve shows: the TFP 5000 UV 9 delivers 1,300 liters per hour at a height of 30 centimeters, but only 400 at 1.5 meters.
Between the pump and the filter, you need a pressure hose rated for at least the pump’s maximum pressure, firmly secured with hose clamps. Spiral hoses for ponds in several diameters are also available from ELV (German retailer).
Where should the filter go?
This is where the manuals differ significantly. Oase allows the FiltoClear to stand right at the edge of a normal garden pond; at a swimming pond, the manufacturer requires a distance of 2 meters. T.I.P. generally requires 2 meters from the bank for its pressure filters. Both can be partially buried, the FiltoClear 5000 up to a depth of 12 centimeters, the T.I.P. filters up to the clamp closures. On the FiltoClear, the return line may be no more than 2 meters above the lid; on the T.I.P., only 1 meter. So a small stream works, but a waterfall on a slope does not.
Electricity at the pond is not a DIY tinkering project. Oase specifies a residual current device rated at no more than 30 milliamperes and leaves permanent outdoor installation to a qualified electrician. Neither the filter nor the pump can handle a dimmer. If you are laying cables anyway, plan the pond lighting (in German) at the same time. In the fall, the filter is taken out of operation once the water temperature drops below 8 degrees; store the lid, UV-C unit and sponges in a frost-free place.
Six pressure filters side by side
| Model | Pond without / with fish | UV-C | Best for |
|---|---|---|---|
| Oase FiltoClear Set 5000 OC | 5,000 / 2,500 l | 18 W | Goldfish pond up to 2,500 l, set with pump |
| Oase FiltoClear 13000 | 13,000 / 7,000 l | 24 W | Medium-sized fish ponds, pump sold separately |
| Oase FiltoClear 19000 | 19,000 / 10,000 l (koi 5,000 l) | 42 W | Small koi pond |
| Heissner FPU20000-00 | 20,000 / 10,000 l (koi 5,000 l) | 24 W | Large pond, complete set |
| Heissner HLF4000-00 | 4,000 / 2,000 l | 7 W | Small pond with a few fish |
| T.I.P. TFP 5000 UV 9 | up to 5,000 l (no figure given with fish) | 9 W | Liner pond without fish, tight budget |
Oase FiltoClear Set 5000 OC
The set combines the pressure filter with the AquaMax Eco Premium 5000 pump. According to Oase, the pump draws 10 to 35 watts and delivers a maximum of 5,000 liters per hour with a maximum head of 3.5 meters; the filter needs a flow rate of at least 2,500 liters. The pump can be controlled via an OASE Control unit, which is available as an accessory; without it, the pump always runs at full power. According to the data sheet, the warranty is 2 plus 1 years on the filter and 3 plus 2 on the pump. The downside: a cleaning rotor for the quartz glass is missing in this size, and the set costs significantly more than simple complete sets.
Oase FiltoClear 13000
Same technology, taller container, one more sponge and 24 watts of UV-C. Here, Oase requires a flow rate of at least 4,500 liters and recommends the AquaMax Eco Premium 9000. For ponds with fish up to 7,000 liters, this is the right size if you already own a powerful pump.
Oase FiltoClear 19000
From this size up, a rotor driven by the water flow sits above the quartz glass and keeps the glass clean continuously. The bulb has 42 watts. Oase gives koi up to 5,000 liters of pond volume as the limit. According to the manual, the filter weighs 47 kilograms when full, and the base should be able to support that.
Heissner FPU20000-00
A complete set with an adjustable pump that, according to Heissner, delivers 4,900 liters per hour at 40 watts and handles debris up to 6 millimeters, plus 24 watts of UV-C and 4 meters of 25-millimeter hose. We consider the figure of 10,000 liters with fish at under 5,000 liters of pump output to be tightly calculated. If you push it to the full liter figure, you should buy a thicker hose as well.
Heissner HLF4000-00
Small and complete: a pump with 2,200 liters per hour and 25 watts, 7 watts of UV-C, a 19-millimeter hose. For a pond with a few fish up to 2,000 liters, that is enough. The weak bulb is the compromise; in sunny locations, the water can still turn green in high summer.
T.I.P. TFP 5000 UV 9
The affordable solution for a pond without fish. According to T.I.P., the pump delivers no more than 1,500 liters per hour, the container holds 8 liters, and three filter mats are included. T.I.P. guarantees spare parts for up to ten years after purchase. For fish, we would go one size up.
How we would decide
- Goldfish up to 2,500 liters, filter and pump from a single source: Oase FiltoClear Set 5000 OC.
- Fish pond up to 7,000 liters with an existing pump: Oase FiltoClear 13000.
- Small koi pond: Oase FiltoClear 19000 with cleaning rotor.
- Large pond without koi, everything in one box: Heissner FPU20000-00, ideally with a thicker hose.
- Mini pond without fish: T.I.P. TFP 5000 UV 9 or Heissner HLF4000-00.
Frequently asked questions
Which pressure filter is enough for my pond?
First calculate the volume: length times width times average depth, so 3,600 liters for 3 by 2 meters and 60 centimeters. Then compare only the figures with fish stocking. Oase specifies 5,000 liters without fish and 2,500 liters with fish for the FiltoClear 5000. If the figure is missing, deduct half.
Why is my pond water still green despite a new filter?
Usually it was just too early. According to Oase, the bacteria only start working at a water temperature of 10 degrees, and according to T.I.P., it takes five to six weeks for the sponges to be colonized. Other common causes are a UV-C bulb that is too small or a hose that is too thin.
How often does the UV-C bulb need replacing?
Every spring, even if it still lights up, because it loses effectiveness over time. Oase specifies 8,000 hours for the 18-watt bulb, i.e. one pond season, and T.I.P. around 4,000 hours. According to Oase, scratched or clouded quartz glass should also be replaced.
Which hose do I need for the pond filter?
For the FiltoClear, Oase recommends 50 millimeters to keep pressure losses low. Many sets come with a 19-millimeter hose in the box, which is only enough for small pumps. On the suction side, the hose must never be thinner than on the pressure side, and it should be secured with hose clamps.
How close to the pond can the pressure filter stand?
Oase allows the FiltoClear to stand right at the edge of a normal garden pond; at a swimming pond, the manufacturer requires a distance of 2 meters. T.I.P. generally requires 2 meters from the bank for its pressure filters. For the power supply, Oase specifies a residual current device rated at no more than 30 milliamperes.
What should I do with the dirty water when backwashing?
It is rich in nutrients; Oase suggests directing it into a flower bed through a hose. Pay attention to the cap on the dirty water hose, otherwise, according to Oase, the pond can drain without you noticing. A thorough cleaning twice a year with pond water is still a must.
Sources
- ELV: Oase FiltoClear Set 5000 OC
- Oase: data sheet FiltoClear Set 5000
- Oase: operating instructions FiltoClear 5000 to 31000
- Oase: operating instructions AquaMax Eco Premium
- Heissner: pressure filter set FPU20000-00
- Heissner: pressure filter set HLF4000-00
- T.I.P.: pond pressure filter TFP 5000 UV 9
- T.I.P.: operating instructions TFP 5000, 10000, 15000
Where to buy
- Oase FiltoClear Set 5000 OCView at ELVAvailable in Germany: ELVCheck price at Amazon.deAvailable in Germany: Amazon.de
- Oase FiltoClear 13000Check price at Amazon.deAvailable in Germany: Amazon.de
- Oase FiltoClear 19000Check price at Amazon.deAvailable in Germany: Amazon.de
- Heissner FPU20000-00Check price at Amazon.deAvailable in Germany: Amazon.de
- Heissner HLF4000-00Check price at Amazon.deAvailable in Germany: Amazon.de
- T.I.P. TFP 5000 UV 9Check price at Amazon.deAvailable in Germany: Amazon.de
