Contents12 sections
This guide was first published in German on handgetestet.de.
Garden lighting rarely gets better with new lights and almost always with a smarter switch. If your string lights or spotlight already hang on an outdoor outlet, a weatherproof smart plug such as the Shelly Outdoor Plug S Gen3 is the shortest route: plug it in, create a schedule from sunset, no hub needed. Hardwired path lights, on the other hand, get an in-wall relay, and a qualified electrician installs it.
There is also a bad decision that stubbornly persists. A living room smart plug ends up in the garden outlet because it happens to be lying around. That works for a while. Until the first autumn rain.
First figure out how the light gets its power
The design of the existing light determines the device, not the other way around. Three cases cover almost every garden.
- Light with a plug on an outdoor outlet: an outdoor smart plug with at least IP44, meaning protection against splashing water from all sides, is enough here.
- Hardwired light, switched by a switch inside the house: then a relay belongs behind that switch or in a junction box.
- Light should only come on with motion: either a motion sensor with its own switching relay on the 230-volt supply or a battery-powered sensor that triggers networked lights.
The wireless connection is at least as important. Wi-Fi devices such as those from Shelly work without a hub but need a decent signal at the far end of the garden. Thread (Eve), Zigbee (Hue, Bosch) and Homematic IP’s 868 MHz wireless require a hub or border router, but often reach further. Matter is the common language that lets devices from different brands be integrated into Apple Home, Google Home or Alexa. Before buying, check whether the schedule runs on the device itself. If the internet goes down, the light then still stays on time.
230 volts in the garden: what you are allowed to do yourself
Anyone may plug in a smart plug. Things look different as soon as wires are connected. Under Section 13 of the German Low Voltage Connection Ordinance (Niederspannungsanschlussverordnung, NAV), work on the electrical installation behind the main service fuse may only be carried out by the grid operator or by an electrical contractor listed in its register of installers. Eve explicitly requires an authorized electrician for its Energy Outdoor outlet, and Bosch requires authorized qualified personnel for its in-wall relay.
While you are at it, it is worth a look in the fuse box. According to the German standard DIN VDE 0100-410 in its 2018 version, outlet circuits up to 32 amps need a residual current device (previously the limit was up to 20 amps), as the manufacturer Hager summarizes the standard. Older garden outlets do not always meet this.
And the light itself? For outdoor lighting, the environmental agency of the city of Nuremberg recommends warm white light around 2,700 kelvin, motion sensors at entrances and on paths, no illuminated trees and shrubs, and decorative lighting on a timer until 11 p.m. at the latest, because bright light attracts and exhausts nocturnal insects. This is exactly where smart control pays off. A „sunset to 11 p.m.“ schedule implements this recommendation without anyone having to think about it every evening.
Seven ways to controllable garden lighting
| Model | Design and protection | Wireless and hub | Best for |
|---|---|---|---|
| Shelly Outdoor Plug S Gen3 | Smart plug, IP44, 12 A / 2,500 W (resistive load) | Wi-Fi, Bluetooth, Matter; no hub needed | Outdoor outlet in place, string lights or spotlight with plug |
| Eve Energy Outdoor | Replacement outdoor outlet, IP44, 16 A / 3,680 W | Thread, Matter; Thread border router needed | Apple Home, replacing the outdoor outlet |
| Homematic IP Schalt-Mess-Kabel außen (HmIP-PSMCO) | Outdoor switching and metering cable, 3 m, IP44, up to 2.3 kW | 868 MHz, Access Point needed | Homematic households, distant outlets |
| Homematic IP Bewegungsmelder mit Schaltaktor außen (HmIP-SMO230) | Outdoor motion sensor with switch actuator, hardwired 230 V, IP44, 20 m / 180°, up to 1,150 W | 868 MHz | Replacing an old sensor at the entrance or driveway |
| Philips Hue Outdoor Bewegungsmelder | Outdoor motion sensor, battery 2 × AA, IP54, 0 to 10 m | Zigbee, Bluetooth; Matter via Bridge | Hue outdoor lights |
| Bosch Smart Home Licht-/Rollladensteuerung II | Light/shutter control, in-wall, two circuits up to 500 W each | Zigbee 3.0, Controller needed | Bosch system, garden lights on the existing switch |
| Shelly 1PM Gen4 | Installed in a box, 16 A, with energy metering | Wi-Fi, Bluetooth, Zigbee, Matter | Hardwired path lights without a hub |
Shelly Outdoor Plug S Gen3
The outdoor plug is protected to IP44 and, according to the manufacturer, designed for minus 25 to plus 51 degrees Celsius. It also runs purely locally on your own Wi-Fi; the Shelly cloud is optional. Once the location is stored, schedules understand sunrise and sunset with an offset, such as „sunset plus 30 minutes.“ The manual contains one restriction: transformers and chargers should not be plugged in directly. If you run a 12-volt garden lighting system with a plug-in transformer, clarify this beforehand.
Eve Energy Outdoor
Here, Eve replaces the existing outdoor outlet completely, with a flap, IP44 and metering. Schedules run on the device, so also without a hub, iPhone or internet; Eve itself names sunset as a trigger. According to the manufacturer, consumption data only appears in Apple Home (via the Eve app) and SmartThings, not in Alexa or Google Home. For Apple households, the tidiest solution, but not one without an electrician.
Homematic IP Schalt-Mess-Kabel außen
A three-meter extension cable with IP44 that switches up to 2.3 kilowatts and measures consumption to within 0.01 watts. According to eQ-3, the wireless range in open terrain is typically 210 meters, which makes the difference for a pond pump or garden shed at the end of the property. Switching times can be fixed or based on sunrise and sunset. It does not work without a Homematic IP Access Point or hub.
Homematic IP Bewegungsmelder mit Schaltaktor außen
This outdoor motion sensor goes where a simple motion sensor often hangs today and switches the light via its own relay. It covers 20 meters at 180 degrees and switches up to 1,150 watts of resistive load. According to the manufacturer, the twilight sensor already responds at dusk and on overcast days. Since it is hardwired to the 230-volt supply, this is a job for a licensed contractor.
Philips Hue Outdoor Bewegungsmelder
The outdoor motion sensor runs on two AA batteries, is protected to IP54 and is rated for minus 20 to plus 45 degrees Celsius. With a detection range of 0 to 10 meters, it covers a front entrance; for a long driveway, that is tight. It also works without Wi-Fi, but Matter is only available via the Hue Bridge. It makes sense if Hue lights already hang outside. For a single spotlight on an outlet, it is the wrong approach.
Bosch Smart Home Licht-/Rollladensteuerung II
This light and shutter relay goes behind the existing switch and controls two independent circuits with up to 500 watts each. Bosch requires an in-wall box at least 50, preferably 60 millimeters deep. Time profiles and automations such as „on at sunset“ run via the Bosch Smart Home Controller, without which nothing works at all. For households that already rely on Bosch.
Shelly 1PM Gen4
The relay fits into standard switch and junction boxes, switches 16 amps and measures consumption. Out of the box, it speaks Matter; pressing the button five times switches it to Zigbee, and Wi-Fi and Bluetooth are on board anyway. Shelly requires a circuit breaker of no more than 16 amps (B or C characteristic). It is built for the box in the house, not for a spot in the flower bed.
Which solution suits which garden
- String lights or spotlight with a plug, no smart home system: Shelly Outdoor Plug S Gen3. Schedule from sunset, switch-off at 11 p.m., done.
- Apple Home with a HomePod or Apple TV and a new outdoor outlet due anyway: Eve Energy Outdoor, installed by an electrician.
- Homematic IP in the house: the switching and metering cable for plug-in lights, the motion sensor with switch actuator for the front door.
- Hardwired path lights on the light switch: Shelly 1PM Gen4 without a hub, or in the Bosch system the Licht-/Rollladensteuerung II. A licensed contractor installs either one.
- Hue lights outside: the outdoor motion sensor, but only where ten meters is enough.
Further reading: which lights can be networked themselves is covered in our guide to smart outdoor lighting. Sensors for indoors and outdoors are compared in the guide to smart motion sensors (in German), and indoor smart plugs in the one on the smart plug (in German).
The foundation for a dimmable system is laid in the guide 24-volt garden lighting.
If you switch garden lights via an outdoor outlet, our review of the Meross Matter outdoor smart plug covers a model with two sockets.
Frequently asked questions
Can I use a regular smart plug in the garden?
Outdoors, a smart plug needs at least IP44, meaning protection against splashing water from all sides. A leftover living room plug in the garden outlet only works for a while, until the first autumn rain.
Which wireless system is suitable for garden lighting?
Wi-Fi devices such as those from Shelly work without a hub but need good coverage at the far end of the garden. Thread, Zigbee and Homematic IP's wireless system require a hub or border router, but often reach further. Matter connects devices from different brands with Apple Home, Google Home or Alexa.
Can I wire a relay for outdoor lighting myself?
No. Under Section 13 of the German Low Voltage Connection Ordinance (NAV), work behind the main service fuse may only be carried out by the grid operator or a registered electrical contractor. Eve and Bosch explicitly require qualified personnel for their devices. Anyone, on the other hand, may plug in a smart plug.
How long should garden lights stay on in the evening?
The Nuremberg environmental agency recommends warm white light around 2,700 kelvin, motion sensors on paths and decorative lighting on a timer until 11 p.m. at the latest, because bright light attracts nocturnal insects. A schedule from sunset to 11 p.m. puts this into practice without any daily effort.
What happens to the schedule if the internet goes down?
If the schedule runs on the device itself, the light still switches on time. This should be checked before buying. According to the manufacturer, schedules on the Eve Energy Outdoor also run without a hub, iPhone or internet.
How do you control hardwired path lights smartly?
A relay goes behind the existing switch or into a junction box. The Shelly 1PM Gen4 works without a hub; in the Bosch system, the Licht-/Rollladensteuerung II (light/shutter control II) with controller does the job. A licensed contractor installs either one.
Sources
- Shelly: Outdoor Plug S Gen3, technical data and safety information
- Shelly: Schedules with sunrise and sunset
- Shelly: 1PM Gen4, technical data
- Eve: Eve Energy Outdoor
- Homematic IP: Outdoor switching and metering cable
- Homematic IP: Outdoor motion sensor with switch actuator
- Philips Hue: Outdoor Motion Sensor
- Bosch Smart Home: Light/shutter control II
- Section 13 of the German Low Voltage Connection Ordinance (NAV)
- Hager: Explanations of the German standard DIN VDE 0100-410
- Nuremberg environmental agency: Light pollution
Where to buy
- Shelly Outdoor Plug S Gen3Check price at Amazon.deAvailable in Germany: Amazon.de
- Eve Energy OutdoorCheck price at Amazon.deAvailable in Germany: Amazon.de
- Homematic IP Schalt-Mess-Kabel außen HmIP-PSMCOCheck price at Amazon.deAvailable in Germany: Amazon.de
- Homematic IP Bewegungsmelder mit Schaltaktor außen HmIP-SMO230View at ELVAvailable in Germany: ELVCheck price at Amazon.deAvailable in Germany: Amazon.de
- Philips Hue Outdoor BewegungsmelderCheck price at Amazon.deAvailable in Germany: Amazon.de
- Bosch Smart Home Licht-/Rollladensteuerung IICheck price at Amazon.deAvailable in Germany: Amazon.de
- Shelly 1PM Gen4Check price at Amazon.deAvailable in Germany: Amazon.de
