Contents12 sections
This guide was first published in German on handgetestet.de.
A living room, a TV, a turntable on the shelf and a phone full of playlists. If you’re looking for a stereo amplifier for all that, you’ll usually look at the watts first, and that’s the wrong place. What matters is which sources need to connect to the unit. For TV, vinyl and streaming at once, the Marantz Stereo 70s brings all three paths in one housing, according to the manufacturer. The WiiM Amp Pro costs less, but there you’ll have to do without a turntable input and AirPlay.
A list on paper before you start
What should supply the music, and where are the speakers? Write it down. The right class of device follows almost automatically.
The first fork in the road is integrated amplifier or plain streamer. An integrated amplifier drives passive speakers directly. A streamer like the Bluesound Node or the WiiM Ultra only supplies the signal and needs an existing amplifier or active speakers. If a good amplifier is already in the rack, the streamer is the cheaper route.
Then the TV. Via HDMI ARC or eARC, its sound reaches the system, and the TV remote usually controls the volume too. For stereo, ARC is enough; eARC has more bandwidth and matters mainly for multichannel sound. Without HDMI, only the optical input remains. Volume control via the TV then often doesn’t work.
- Phono input: A turntable without a built-in preamp needs one. MM is common, MC much rarer. There’s more detail in our article on turntables (in German).
- AirPlay 2: If you stream from an iPhone, this point belongs on the list. For the WiiM Amp Pro and WiiM Ultra, the manufacturer states explicitly that they don’t receive AirPlay.
- Subwoofer output: Small bookshelf speakers sound fuller with a subwoofer. Not every unit has an output for one.
What the wattage doesn’t tell you
Power figures are hard to compare because every manufacturer measures under different conditions. For the PMA-900HNE, for example, Denon states 50 watts per channel into 8 ohms across the full audible range, but 85 watts into 4 ohms at 1 kHz with more distortion. Both are true. Only the first figure is comparable.
The impedance of your speakers is on the rating plate or in the data sheet. 8 ohms is easy to drive; 4 ohms demands more current from the amplifier, so check whether the manufacturer explicitly approves your impedance. In a living room with bookshelf or floor-standing speakers of normal sensitivity, 50 to 80 watts into 8 ohms is generally enough. More power mainly means headroom. It doesn’t make everyday listening louder.
Seven units for different living rooms
| Model | Type and power (manufacturer figure) | TV and phono | Best for |
|---|---|---|---|
| Marantz Stereo 70s | integrated amplifier, 75 W into 8 ohms | 6 HDMI inputs, eARC; MM phono | TV, vinyl and streaming in one unit |
| WiiM Amp Pro | integrated amplifier, 60 W into 8 ohms, 120 W into 4 ohms | HDMI ARC; no phono | small budget, compact system |
| Denon PMA-900HNE | integrated amplifier, 50 W into 8 ohms | no HDMI; MM and MC phono | record collectors with a classic setup |
| Yamaha R-N600A | network receiver, 80 W into 8 ohms | no HDMI; MM phono | music first, with tuner and MusicCast |
| Cambridge Audio Evo 150 SE | integrated amplifier, 150 W into 8 ohms | HDMI ARC; MM phono | demanding speakers, many inputs |
| Bluesound Node (N132) | streamer without power amp | HDMI eARC; no phono | upgrading an existing system, with AirPlay |
| WiiM Ultra | streamer and preamp without power amp | HDMI ARC; MM and MC phono | streamer with a turntable connection |
Marantz Stereo 70s
Six HDMI inputs, eARC, an MM phono input and two subwoofer outputs: that’s how the Stereo 70s stereo receiver is equipped. According to Marantz, it delivers 75 watts per channel into 8 ohms. Streaming runs via HEOS and AirPlay 2, and Bluetooth is on board. If a game console, TV and turntable all hang off one unit, this one involves the fewest compromises. It is, however, larger and more expensive than the compact units.
WiiM Amp Pro
Small, inexpensive, with HDMI ARC. According to the manufacturer, the WiiM Amp Pro delivers 60 watts into 8 ohms and 120 watts into 4 ohms, and a subwoofer output with adjustable crossover and RoomFit room correction are included. There’s no phono input, and WiiM itself states that the unit doesn’t receive AirPlay. For Android users with Spotify or TIDAL, that may not matter. In an iPhone household, it weighs heavily.
Denon PMA-900HNE
A classic integrated amplifier with a phono input for MM and MC cartridges, plus HEOS, AirPlay 2 and Bluetooth. On the digital side, there are three optical inputs and one coaxial. HDMI is missing, and according to the data sheet, so is a subwoofer output. If the TV is to connect to the system too, you’re better off looking at another unit.
Yamaha R-N600A
Yamaha’s manual lists 80 watts per channel into 8 ohms for the network receiver, plus an MM phono input, two optical and two coaxial inputs and a subwoofer output. Streaming runs via MusicCast and AirPlay 2. It has no HDMI. Here the music comes first; the TV at most connects occasionally via the optical input.
Cambridge Audio Evo 150 SE
The SE version replaces the Evo 150 and, according to Cambridge Audio, gets revised Hypex power amplifiers, rated at 150 watts into 8 ohms. There are plenty of inputs: HDMI ARC, MM phono, optical, coaxial, RCA, balanced XLR and USB. Streaming runs via Chromecast, AirPlay 2, Spotify Connect and Roon Ready. This is the most expensive solution here. With ordinary bookshelf speakers, a good part of it goes unused.
Bluesound Node (N132)
No power amp. The Node brings streaming and HDMI eARC to an amplifier that can’t do either. According to Bluesound, it supports AirPlay 2, Spotify Connect, TIDAL Connect, Qobuz Connect and Roon Ready, plus headphone and subwoofer outputs. If several rooms need music, you’ll find suitable additions among the multiroom speakers.
WiiM Ultra
A streamer with a preamp and touchscreen, plus a phono input for MM and MC that can be switched via the app. According to the manufacturer, stereo PCM and Dolby Digital arrive via HDMI ARC. AirPlay is missing here too. Connected to an old amplifier without a phono stage, the Ultra is a compact solution.
Back to the living room: which unit goes where?
If TV, turntable and streaming all need to connect to a single unit, we land on the Marantz Stereo 70s. With little space, a small budget and no turntable, the WiiM Amp Pro is enough, provided you can live without AirPlay. The Denon PMA-900HNE is built for a turntable with an MC cartridge and no TV next to it; the Yamaha R-N600A is for music first with solid features.
Power-hungry speakers and many sources speak for the Cambridge Audio Evo 150 SE. If a good amplifier is already there and only streaming is missing, the Bluesound Node is enough; if you also need phono, the WiiM Ultra.
If it’s only about better TV sound and you don’t want to set up pairs of speakers, a soundbar is often the better solution. Our soundbar guide (in German) gives you the overview.
Frequently asked questions
How many watts does a stereo amplifier need for a living room?
With bookshelf or floor-standing speakers of normal sensitivity, 50 to 80 watts into 8 ohms is generally enough. More power mainly means headroom; it doesn't make everyday listening louder. Only figures measured under the same conditions can be compared, for example into 8 ohms across the full audible range.
Amplifier or streamer: which do I need?
An integrated amplifier drives passive speakers directly. A streamer like the Bluesound Node or the WiiM Ultra only supplies the signal and needs an existing amplifier or active speakers. If a good amplifier is already in the rack, the streamer is the cheaper route.
Is HDMI ARC enough for connecting the TV to an amplifier?
For stereo, yes. Via ARC or eARC, the TV sound reaches the system, and the TV remote usually controls the volume too. eARC has more bandwidth and matters mainly for multichannel sound. Without HDMI, only the optical input remains, and then volume control via the TV often doesn't work.
Which amplifier suits a turntable with a moving-coil cartridge?
The Denon PMA-900HNE has a phono input for MM and MC, plus HEOS, AirPlay 2 and Bluetooth. It lacks HDMI, though. If you already have an amplifier without a phono stage, the WiiM Ultra, a streamer with a preamp, brings an input for MM and MC.
Can I stream from an iPhone to the WiiM Amp Pro?
Not via AirPlay. WiiM itself states that the Amp Pro and the Ultra don't receive AirPlay. For Android users with Spotify or TIDAL, that may not matter; in an iPhone household, it weighs heavily. AirPlay 2 is available on the Marantz Stereo 70s, Denon PMA-900HNE, Yamaha R-N600A and Bluesound Node, among others.
Sources
- Marantz: Stereo 70s
- WiiM: Amp Pro
- WiiM: Ultra
- WiiM help: inputs of the WiiM Ultra
- Denon: PMA-900HNE
- Yamaha: R-N600A, technical data
- Cambridge Audio: Evo 150 SE
- Cambridge Audio: difference between Evo 150 and Evo 150 SE
- Bluesound: Node
Where to buy
- Marantz Stereo 70sCheck price at Amazon.deAvailable in Germany: Amazon.deView at CoolblueAvailable in Germany: Coolblue
- WiiM Amp ProCheck price at Amazon.deAvailable in Germany: Amazon.de
- Denon PMA-900HNECheck price at Amazon.deAvailable in Germany: Amazon.deView at CoolblueAvailable in Germany: Coolblue
- Yamaha R-N600ACheck price at Amazon.deAvailable in Germany: Amazon.de
- Cambridge Audio Evo 150 SECheck price at Amazon.deAvailable in Germany: Amazon.de
- Bluesound Node N132Check price at Amazon.deAvailable in Germany: Amazon.de
- WiiM UltraView at CoolblueAvailable in Germany: CoolblueCheck price at Amazon.deAvailable in Germany: Amazon.de

