Contents11 sections
This guide was first published in German on handgetestet.de.
A wall scanner shows you where something is in the wall. It does not tell you where nothing is. For shelves, lamps and a TV wall mount in masonry or drywall, we recommend a solid metal and wire detector such as the Bosch Professional GMS 120-27; if underfloor heating, plastic pipes or thick concrete are involved, you need a radar device such as the Bosch D-tect 200 C.
In between lies a lot of technology that looks the same on the packaging. So let’s start with the principle.
Coil, sensor or radar: what the device can actually see
Five of the six devices here are of the conventional kind. Their data sheets list three things they find: metal, live wires and wood or metal studs behind drywall. The manufacturers promise no more than that. A plastic water pipe does not appear on any of these lists, and only Laserliner gives any figure at all for wires without voltage.
Radar works differently. Bosch uses this technology in the D-tect 200 C and explicitly lists plastic pipes, both empty and filled with water, as well as wood as detectable, plus wires without voltage. Of the six devices in this guide, it is the only one with this technology.
When comparing, look at the depth specification per material, not the biggest number on the box. For the GMS 120-27, the figures are 120 mm for copper but only 50 mm for a live wire and 30 mm for wooden beams. For safe drilling, the smallest of these values is what counts.
Why a green light is not a go-ahead
The manufacturers say so themselves in their manuals. In the manual for the D-tect 200 C, Bosch writes that, for technical reasons, the device cannot provide complete certainty; before drilling, you should also consult building plans or photos from the construction phase and shut off electricity, gas and water. Zircon puts it even more bluntly in the manual for the A250c: never assume that there is no live wire in the wall.
The reasons are listed right alongside. According to Bosch, wires without voltage are shown either as metal or not at all, and the D-tect 200 C does not detect stranded copper wire. Three-phase wires may not appear as “live.” Above 50% humidity, voltage detection is limited. For its device, Zircon names wires in concrete, in metal conduit, behind plywood or metal paneling, and damp walls as cases in which current cannot be detected.
What does that mean in practice? An outlet circuit with nothing plugged in still carries voltage. The section between a switch and a ceiling lamp that is turned off, on the other hand, does not. Bosch advises switching on appliances on the wire you are looking for, because it is then easier to locate.
The second safeguard is looking at the wall itself. The German standard DIN 18015-3 sets installation zones for concealed wiring in homes. As described in the German trade journal “de,” the horizontal zones lie 15 to 45 cm below the ceiling and 15 to 45 cm above the finished floor, plus 100 to 130 cm high in rooms with work surfaces. Vertical zones run 10 to 30 cm beside doors, windows and wall corners. If an outlet or switch sits outside these bands, the wire may run vertically to it from the nearest horizontal zone. So directly above and below every box is off-limits.
One catch remains. The standard describes how wires should run, not how they actually run in a house from 1965 after three renovations. That is exactly where a wall scanner helps, as a second opinion.
Six wall scanners compared
| Model | Principle | Depth according to manufacturer | Best for |
|---|---|---|---|
| Bosch Professional GMS 120-27 | Metal, voltage, wood | Copper 120 mm, steel 100 mm, live wire 50 mm, wood 30 mm | Everyday use in masonry and drywall |
| Bosch Professional D-tect 200 C | Radar | up to 200 mm in dry concrete, otherwise 60 to 80 mm, wood 38 mm | Underfloor heating, plastic pipes, concrete |
| Laserliner MultiScanner Plus | Metal, voltage, studs | Steel 120 mm, non-ferrous metal 100 mm, live wire 40 mm, studs 20 mm | Checking drilling depth above rebar |
| Bosch UniversalDetect | Metal, voltage, wood | Metal 100 mm, live wire 50 mm, wood 25 mm | Occasional drilling with guided operation |
| Zircon MultiScanner A250c | Studs, metal, voltage | Studs 19/38 mm, steel 75 mm, copper 38 mm, live wire 50 mm | Drywall with wood or metal studs |
| Stanley FatMax S300 | Studs, metal, voltage | Studs 38 mm, metal 76 mm, live wire 51 mm | Simple stud finding in drywall |
Bosch Professional GMS 120-27
This compact device from the blue professional line works without radar and, according to the manufacturer, finds copper to 120 mm, steel to 100 mm, live wires to 50 mm and wooden beams in drywall to 30 mm. The housing is protected against dust and splashing water under IP54, and the weight is around 0.29 kg. It runs on two AA batteries or, in one variant, on a lithium battery with USB-C. A marking hole shows the spot. For anchor holes in masonry and drywall, we consider this the sensible basic kit.
Bosch Professional D-tect 200 C
A wall scanner with radar. According to Bosch, it sees up to 200 mm deep into dry concrete, up to 80 mm in other wall types and up to 60 mm in young concrete, and it distinguishes between magnetic and non-magnetic metal, wires, plastic pipes and wood. There are dedicated wall programs for concrete, hollow brick, drywall and radiant heating; scan images can be saved via USB-C or microSD.
Bosch is open about its limits. In drywall mode, it does not detect empty plastic pipes, and filled pipes look like wooden beams there. Fresh concrete takes months to become dry enough for a clean measurement. At around 0.7 kg, the D-tect 200 C is a tool for renovators and tradespeople who regularly drill into floors with heating loops or into concrete ceilings. For hanging a picture in the living room, it is overkill.
Laserliner MultiScanner Plus
Its strength is metal in solid walls. According to the data sheet, it detects magnetic metal to 12 cm and non-magnetic metal to 10 cm under stone, concrete, screed, wood and ceramic, shows the depth in metal mode and tells you whether the metal is magnetic. If you are drilling into a concrete ceiling and want to know how much room is left before the rebar, you get a number here. Wires, on the other hand, it finds only to 4 cm, studs to 2 cm. According to Laserliner, the built-in battery lasts about three hours.
Bosch UniversalDetect
This device from the green DIY line guides you through the measurement with animated step-by-step instructions and shows finds through a traffic-light system of LEDs. Bosch specifies 100 mm for metal, 50 mm for live wires and 25 mm for wood; it calibrates itself and runs on four AAA batteries. A good fit for anyone who drills twice a year and has no patience for menus.
Zircon MultiScanner A250c
The focus is on stud walls. The A250c finds the center and edges of wood and metal studs to 19 mm, and to 38 mm in DeepScan mode. According to the data sheet, it detects iron to 75 mm, copper to 38 mm and live wires to 50 mm. The display changes color depending on the mode and flashes red as soon as it notices voltage while in another mode. It is not designed for solid walls: according to the manual, it may not detect live wires in concrete.
Stanley FatMax S300
A simple stud finder with a backlit display. Stanley specifies 38 mm for wood and metal studs, 76 mm in deep metal mode and 51 mm for live wires. The manufacturer mentions no depth display or material differentiation. That is enough for drywall in new buildings; for older buildings with thick plaster, we would reach for one of the Bosch devices.
Which device suits which wall
- Masonry or drywall, putting in the occasional anchor: Bosch Professional GMS 120-27, with good metal range and a splash-proof housing.
- Underfloor heating, plastic pipes, concrete ceilings: Bosch Professional D-tect 200 C, because only radar sees non-metallic pipes at all.
- Knowing the drilling depth above rebar or copper pipe: Laserliner MultiScanner Plus with depth display in metal mode.
- Lightweight drywall with stud framing: Zircon MultiScanner A250c or Stanley FatMax S300.
- Operation as simple as possible: Bosch UniversalDetect.
Whatever the device, the same sequence applies. First look at the installation zones, then scan at several heights and across the suspected wire, then mark. And when in doubt, switch off the circuit breaker. Which drill bit and which machine suit the surface is covered in our guide to rotary hammers; a good anchor set for concrete, brick and drywall (in German) provides the right hold.
Frequently asked questions
Can a wall scanner also find plastic water pipes?
Conventional devices cannot. Their data sheets list metal, live wires and studs behind drywall. Of the six devices, only the Bosch D-tect 200 C with radar detects plastic pipes, both empty and filled with water. According to Bosch, even it does not detect empty plastic pipes in drywall mode.
Is a green light on a wire detector a go-ahead to drill?
No. Bosch writes that, for technical reasons, the device cannot provide complete certainty, and Zircon advises never to assume that there is no live wire in the wall. Wires without voltage show up as metal or not at all, and damp walls and concrete make detection even harder.
What should I look for in a wall scanner's depth specification?
The depth per material, not the biggest number on the box. For the GMS 120-27, the figures are 120 mm for copper but only 50 mm for a live wire and 30 mm for wooden beams. For safe drilling, the smallest of these values is what counts.
Where do electrical wires run in the wall?
The German standard DIN 18015-3 sets installation zones: horizontally 15 to 45 cm below the ceiling and above the floor, vertically 10 to 30 cm beside doors, windows and corners. Directly above and below every outlet box is off-limits. In older houses, however, wires may run differently.
Which wall scanner is suitable for drywall?
For stud walls, the Zircon MultiScanner A250c, which finds the center and edges of wood and metal studs, or the simple Stanley FatMax S300 are good fits. The Zircon is not designed for solid walls. For older buildings with thick plaster, the Bosch devices are the better choice.
Sources
- Bosch Professional: GMS 120-27, technical specifications
- Bosch Professional: D-tect 200 C, technical specifications
- Bosch: D-tect 200 C operating instructions (PDF, in English)
- Bosch: UniversalDetect, technical specifications
- Laserliner: MultiScanner Plus 080.967A data sheet (PDF)
- Zircon: MultiScanner A250c data sheet (PDF)
- Zircon: MultiScanner A250c instructions (PDF)
- Stanley: FatMax Stud Sensor FMHT0-77407
- German trade journal “de”: DIN 18015-3, wire routing and installation zones (PDF, German)
Where to buy
- Bosch Professional GMS 120-27Check price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Bosch Professional D-tect 200 CCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Laserliner MultiScanner PlusCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Bosch UniversalDetectCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Zircon MultiScanner A250cCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Stanley FatMax S300Check price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
