Contents11 sections
This guide was first published in German on handgetestet.de.
A phone mount on a bike rarely fails because of its holding power. Usually it does not fit the handlebar, requires a case you do not want, or sits right where the bell and light already are. For bikes and e-bikes, a caseless mount such as the Topeak Omni RideCase II is enough in most cases. On a motorcycle with a large-displacement engine, things look different: there, a vibration damper is a must, otherwise an iPhone puts its camera at risk.
What engine vibrations do to a phone camera
Apple explains the problem in a dedicated support article. Optical image stabilization works with a gyroscope that detects movement and moves the lens to compensate. Closed-loop autofocus uses magnetic sensors to measure how gravity and vibration act on the lens. Stabilization is built into every iPhone from the iPhone 7 onward, and this type of autofocus from the XS onward. High vibration amplitudes within certain frequency ranges can impair these systems.
Apple therefore advises against attaching an iPhone to motorcycles with high-power, large-displacement engines. According to Apple, mopeds, scooters and electric drives produce weaker vibrations. There, too, the manufacturer recommends a vibration-dampening mount and advises against regular use on long rides. The article does not mention bicycles.
A damper is not an insurance policy. It absorbs high-frequency vibrations, but it does not turn a twin-cylinder into an electric motor. If you commute every day on a big adventure bike, you are better off with a permanently installed navigation unit or an older second phone on the handlebar.
Measure the handlebar first, then choose the locking system
The diameter is what decides. Common sizes are 22.2 mm, 25.4 mm, 31.8 mm and, on newer mountain bikes, 35 mm. Measure with calipers exactly where the clamp will sit, because next to the stem the handlebar is often thicker than at the grips. On a motorcycle, very thick handlebars get tight. 1000PS describes how the handlebar of the BMW R 1300 GS, for example, pushes clamps to their limits, and not just from one manufacturer.
There are three principles for quick-release systems. Quad Lock and SP Connect use a twist: place the case, turn, click into place. Peak Design relies on magnets plus mechanical hooks. Topeak holds the phone with silicone straps at the corners and needs no dedicated case at all. The first two approaches hold more securely but tie you to the system’s cases or a stick-on adapter. If you replace your phone every two years, you buy a new case every time.
Charging is rarely an issue on a bike, but on a motorcycle it almost always is when navigating for several hours. SP Connect offers an Anti Vibration Module with charging, and Peak Design a motorcycle mount with Qi2. Thin cases help with wireless charging. If you need a cable connection, check whether the mount leaves the port free.
What the German road traffic regulations allow
Section 23 (1a) of the German Road Traffic Regulations (StVO) applies to anyone operating a vehicle, cyclists included. A phone may only be used while riding if it is neither picked up nor held to do so. In addition, it must be operated by voice control, or a glance at the display may only be brief. The mount is therefore the prerequisite, not a free pass. Enter destinations before you set off.
Five mounts for bikes and motorcycles
| Model | Mounting and lock | Damping and charging | Best for |
|---|---|---|---|
| Topeak Omni RideCase II | Silicone straps at the corners, stem mount, phones up to 16 × 7.8 × 0.8 cm | no damping of its own | City bike, e-bike, no special case |
| Quad Lock Out Front Mount Pro | Aluminum arm in front of the handlebar, twist lock with case or adapter | Damper only for the motorcycle mounts | Mountain bike, sporty rides |
| SP Connect SPC+ with Anti Vibration Module | Twist lock, case with magnetic ring, mounts for bike and motorcycle | Damper module as an accessory, also with charging | if you ride bike and motorcycle with one case |
| Peak Design Out Front Bike Mount V2 | Aluminum, SlimLink combining magnet and mechanism, in front of the handlebar | rigid, no damping | Road bike, gravel bike, filming the ride |
| Peak Design Motorcycle Bar Mount | Handlebar clamp with rubber inserts, SlimLink, push-button release | Damper behind the magnetic plate, Qi2 as a variant | Motorcycle with a large engine, wireless charging |
Topeak Omni RideCase II
The simplest solution. According to Topeak, the silicone and plastic cradle holds smartphones up to 16 × 7.8 × 0.8 cm, so large models up to 6.9 inches as well, and rotates for portrait or landscape. It attaches to the included stem mount via the QuickClick system. BIKE Magazin praises the low weight of 55 g but notes that the hook-and-loop strap can slip on very smooth surfaces. That is enough for the commute. For root-covered trails, we would choose a locking mount.
Quad Lock Out Front Mount Pro
The aluminum arm puts the phone in front of the handlebar, and it locks with an eighth turn in two stages. In BIKE Magazin’s comparison, the Quad Lock set held most securely, though installation with an Allen key takes a bit more effort. road.cc weighed the first Pro version at 79 g, twice as much as the standard mount, and measured a maximum handlebar diameter of 31.8 mm. With a 35 mm handlebar, check the specification of the current version. For motorcycles, Quad Lock offers its own vibration damper that screws in between the mount and the head.
SP Connect SPC+ with Anti Vibration Module
SP Connect has revised its system into SPC+. According to Macwelt, the iPhone case now has a magnetic ring and is MagSafe-compatible, but the lock no longer fits the old SPC. The mountain bike mount in the test fit handlebars of 25.4, 31.8 and 35 mm, and the head rotates for portrait and landscape. For motorcycles there are two damper modules: a slim one and a large one with a power supply. That way a single case moves from the road bike to the motorcycle, and that is its real strength.
Peak Design Out Front Bike Mount V2
Peak Design machines the mount from anodized aluminum and holds the phone with SlimLink, a combination of magnet and mechanical lock. According to the manufacturer, the new version fits more handlebar sizes. The phone can be flipped up to film while riding. You need a Peak Design case or a stick-on adapter plate. On road and gravel bikes, it looks very clean.
Peak Design Motorcycle Bar Mount
The motorcycle mount comes without charging and as a variant with Qi2. According to motorradonline, a vibration damper sits directly behind the magnetic plate; in the test, the iPhone survived intact and only rattled on very rough terrain. 1000PS rode the charging mount for around 4,000 km with an Android phone and 1,000 km with an iPhone, without any damage to the image stabilization. The testers do issue a warning, though: the magnets hold the phone even when the hooks have not yet engaged. So give it a quick tug after inserting it.
As an inexpensive addition, ROCKBROS offers a silicone mount. According to the retailer, it rotates 360 degrees and is intended for motorcycles and bicycles. The product name does not mention a vibration damper, so for large motorcycle engines, what Apple writes above still applies. We have no independent tests, including on holding power. We see it more as a simple solution for a second bike.
How we would decide
- Commuting by bike or e-bike, frequently changing phones: Topeak Omni RideCase II.
- Mountain bike and gravel: Quad Lock Out Front Mount Pro, measure the handlebar first.
- Bike and motorcycle with the same case: SP Connect SPC+, with the Anti Vibration Module on the motorcycle.
- Road or gravel bike, occasional filming: Peak Design Out Front Bike Mount V2.
- Large motorcycle engine and hours of navigation: Peak Design Motorcycle Bar Mount with Qi2 or SP Connect with charging module.
- Scooters and e-mopeds: a damper here too, as Apple recommends.
If you also need your phone in the car, you will find suitable solutions in our guide to car phone mounts. If the phone should not do the navigating on your bike at all, a dedicated bike GPS (in German) is worth a look. And on a motorcycle, directions are better in your ear than on the display; more on that in our guide to motorcycle intercoms (in German). If you would rather have a dedicated device on the handlebar, you will find it in our guide to motorcycle GPS units (in German).
Frequently asked questions
Do motorcycle vibrations damage a phone camera?
According to Apple, high vibration amplitudes can impair optical image stabilization and closed-loop autofocus. Apple advises against attaching an iPhone to motorcycles with large-displacement engines. For mopeds and scooters, too, the manufacturer recommends a vibration-dampening mount.
What handlebar diameter does my bike have?
Common sizes are 22.2 mm, 25.4 mm, 31.8 mm and, on newer mountain bikes, 35 mm. Measure with calipers exactly where the clamp will sit, because next to the stem the handlebar is often thicker than at the grips.
What quick-release systems are there for phone mounts?
Quad Lock and SP Connect use a twist lock, Peak Design uses magnets plus mechanical hooks, and Topeak uses silicone straps without a dedicated case. The first systems hold more securely but tie you to their own cases or a stick-on adapter. If you switch phones often, you buy a new case every time.
Can you use your phone on a bike while riding?
Section 23 (1a) of the German Road Traffic Regulations (StVO) also applies to cyclists. The phone may be neither picked up nor held, and it must be operated by voice or with only a brief glance at the display. The mount is the prerequisite, not a free pass; enter destinations before you set off.
Which mount works for both bike and motorcycle?
SP Connect SPC+, because the same case moves from the road bike to the motorcycle. The mountain bike mount fit handlebars of 25.4, 31.8 and 35 mm. For motorcycles there are two damper modules, one of them with a power supply for long navigation sessions.
What should you watch out for with magnetic mounts on a motorcycle?
The magnets hold the phone even when the hooks have not yet engaged. The testers at 1000PS point this out for the Peak Design Motorcycle Bar Mount. So after inserting the phone, give it a quick tug to check that it is really locked.
Sources
- Apple Support: Vibrations and iPhone cameras
- Section 23 StVO, German Federal Office of Justice
- Topeak: Omni RideCase II
- Peak Design: Out Front Bike Mount V2
- Peak Design: Motorcycle Bar Mount
- BIKE Magazin: Smartphone mounts tested
- road.cc: Quad Lock Out Front Mount Pro
- Macwelt: SP Connect SPC+ tested
- motorradonline: Peak Design on the motorcycle
- 1000PS: Peak Design motorcycle mounts tested
- Scenic: Quad Lock Vibration Dampener
- ROCKBROS: retailer information on the silicone mount
Where to buy
- Topeak Omni RideCase IICheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Quad Lock Out Front Mount ProCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- SP Connect SPC+ mit Anti Vibration ModuleCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- SP Connect SPC+ Moto BundleCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Peak Design Out Front Bike Mount V2Check price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Peak Design Motorcycle Bar MountCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- Quad Lock Vibrationsdämpfer MotorradCheck price at Amazon.deCheck price at Amazon.co.ukCheck price at Amazon.nlCheck price at Amazon.com.beCheck price at Amazon.frCheck price at Amazon.itCheck price at Amazon.esCheck price at Amazon.plCheck price at Amazon.seAvailable in Germany: Amazon.de
- ROCKBROS Handyhalterung aus Silikon 360° Drehbar für Motorrad & Fahrrad - SchwarzView at ROCKBROSAvailable in Germany: ROCKBROS

