Black Friday Woche läuft bis 30.11.: our pick in each buying guide
Independent buying adviceEvery claim with a sourceNo paid verdictsIn 36 countries1,746 guides and reviews in German How we test
handgetestet

Storing your motorcycle for winter in 2026: breathable cover for indoors and outdoors, paddock stand, battery maintainer, tank and tires. With advice from the ADAC.

handgetestet editorial team · Updated November 17, 2026

Editorial selection based on research, not tested by us. Reasons and limitations are in the text.

Contents13 sections

This guide was first published in German on handgetestet.de.

A dense plastic tarp, a few euros at the hardware store, draped over the motorcycle in a damp garage: there is hardly a more expensive way to put a bike away for winter. Condensation collects underneath. In spring, bolts and spokes then show the first spots of rust. If you only buy two things, get a battery maintainer with a lithium program such as the CTEK CT5 Powersport and a breathable cover that suits where the bike is parked. Add a paddock stand if the bike has no center stand.

What really harms a motorcycle in winter

Cold? Rarely the problem. Moisture, a dead battery and tires carrying the load for months, on the other hand, definitely are. The ADAC (German automobile club) names a dry, well-ventilated and not too warm basement or garage as a good storage spot. Almost every purchase decision depends on where the bike is parked.

  • Garage or basement: A dust cover made of breathable fabric is enough. The ADAC explicitly advises against airtight tarps because condensation forms underneath.
  • Carport or yard: You need a waterproof outdoor cover that reaches down to the ground. The ADAC recommends taking it off and airing the bike on dry days.
  • If there is no center stand, a rear paddock stand takes the load off the tire and keeps the bike upright.
  • If the air in the garage stays damp all the time, no cover alone will help. In that case, a dehumidifier for basement and garage can do more than any tarp.

Battery: remove it, charge it fully, store it cool

Most springtime breakdowns start with the battery. The ADAC advises removing it, charging it fully and storing it at around 10 °C. When removing it, disconnect the negative terminal first and reconnect it last when reinstalling, so that a tool touching the frame cannot cause a short circuit. According to the ADAC, charge it at around 20 °C, but not in living rooms or bedrooms. If the battery stays in the motorcycle, the ignition must not be switched on while charging.

With chargers, big does not mean good. According to the ADAC, powerful car and hardware-store chargers can damage small motorcycle batteries. What you want is an automatic charger that can stay connected permanently and handles lithium batteries, if one is fitted. More powerful models for an additional car battery are in our guide to car battery chargers (in German).

Tank, carburetor and coolant

Full or empty? With the tank, that depends on the material. The ADAC recommends filling a steel tank to the brim if the motorcycle is on its center stand. Plastic tanks should be as empty as possible, because fuel components can diffuse through the wall. On carbureted bikes, close the fuel tap on the last ride or drain the float bowls. When in doubt, follow the vehicle manual.

According to the manufacturers, a fuel stabilizer is meant to slow down the aging of the fuel. The product is not a harmless care product: Liqui Moly labels its Motorbike Benzinstabilisator (motorbike fuel stabilizer) with the signal word „Gefahr“ („Danger“), among other things with the warning that swallowing it can be fatal. So wear gloves, store it out of reach of children and do not smoke while filling. Coolant is dealt with faster; usually a glance is enough. The ADAC advises checking the level and antifreeze concentration and replacing the fluid as specified by the manufacturer if necessary.

Tires: more air, less weight

To prevent flat spots, the ADAC recommends raising the tire pressure by about 0.5 bar above the operating pressure and taking the load off the wheels with a center stand or paddock stand. If that is not possible, push the bike a little every few weeks. For topping up in the garage, a cordless tire inflator (in German) is enough. In spring, lower the pressure back to the normal value.

Six helpers for the winter sleep

ModelJobKey specs (according to manufacturer or retailer)Best forOffer (affiliate link)
CTEK CT5 PowersportBattery12 V, programs Normal (lead-acid incl. AGM), Lithium (LiFePO4) and Recond, IP65 protection ratingAnyone whose battery spends the winter in the basementAvailable in Germany: Amazon.de
Oxford DormexIndoor coverBreathable membrane, protection against dust and sun, four sizes (S to XL)Garage, basement, underground parkingAvailable in Germany: Amazon.de
Oxford AquatexOutdoor coverPolyester with double PU coating, UV-resistant, lock eyelets, elastic hem and underbelly strapCarport, yard, open-air parking spotAvailable in Germany: Amazon.de
ConStands Classic UniversalRear paddock standRubber-coated L-shaped supports, width 27 to 36 cm, bobbin adapter sold separatelyBikes without a center stand with a double-sided swingarmAvailable in Germany: Amazon.de
Hi-Q Tools Montageständer II hintenRear paddock stand33 mm steel tube, width-adjustable, up to 300 kg, not for single-sided swingarmsIf you are looking for a simple rear-wheel liftAvailable in Germany: Amazon.de
Liqui Moly Motorbike BenzinstabilisatorTank250 ml, 5 ml per liter of fuel, then run the engine outdoors for about 10 minutesSteel tanks that spend the winter fullAvailable in Germany: Amazon.de
Want a second opinion before buying?Ask via WhatsApp

CTEK CT5 Powersport

The CT5 Powersport is designed for small 12 V starter batteries in motorcycles, scooters and quads. According to CTEK, it offers three programs, including one for lithium iron phosphate and one for reconditioning deeply discharged lead-acid batteries. During the winter break, what matters most is that it can stay connected permanently as a maintainer. If you want to charge a BMW with CAN bus through the onboard power socket, check compatibility beforehand; retailer information is contradictory on this point.

Oxford Dormex

Indoors only. Oxford describes the Dormex as having a breathable membrane through which air constantly circulates, and cites protection against dust and sun. It is not intended for an outdoor parking spot. Four sizes between 203 and 277 cm in length are available, so measure your own bike including its cases before ordering.

Oxford Aquatex

The Aquatex, on the other hand, belongs outdoors. Oxford cites double-stitched, UV-resistant polyester with a double PU coating and eyelets that a chain lock can be threaded through. However, buyers report thin material and tears after a few months outdoors. For a whole season under the open sky, it is more of a bare minimum. Never pull it over a still-hot exhaust; the manufacturer points this out as well.

ConStands Classic Universal

Behind ConStands is the mail-order retailer Motea. Its Classic Universal lifts the rear wheel using rubber-coated L-shaped supports on the swingarm, which can be adjusted between 27 and 36 cm. If your swingarm has bobbins, you need matching supports, which are sold separately. On Amazon.de, it is also available in model-specific versions. A few buyers had to straighten the supports.

Hi-Q Tools Montageständer II hinten

According to the listing, the orange rear stand (the name translates as „paddock stand II, rear“) from Hi-Q Tools is designed for motorcycles up to 300 kg, is width-adjustable and made of plastic-coated steel tube. It is not suitable for single-sided swingarms. Those need a dedicated single-sided stand with a model-specific locating pin. Price-wise, it sits just below the ConStands. Technically, both do the same job.

Liqui Moly Motorbike Benzinstabilisator

According to Liqui Moly, the dosage is 5 ml per liter of fuel. Before the break, the stabilizer is added to the tank and the engine run for about ten minutes so that it also reaches the lines and the injection system. Do this outdoors, never in a closed garage or basement: combustion engines emit carbon monoxide. For carburetors, the manufacturer also advises draining the float bowls. For a plastic tank that is supposed to spend the winter empty anyway, the product is unnecessary.

How we would shop

  • Garage, bike with center stand: CTEK CT5 Powersport and Oxford Dormex. That is enough.
  • Garage, no center stand: Add the ConStands Classic Universal or the Hi-Q Tools Montageständer II, depending on swingarm and mounting points.
  • If the bike stands outside under the carport, take the Oxford Aquatex instead of the Dormex and air it out on dry days. The battery still belongs in the basement.
  • If a steel tank stays full, the Liqui Moly Motorbike Benzinstabilisator goes in with the last tankful.

If you need to save money, do it on the stabilizer. Skimping on the charger will come back to bite you by the first start attempt in April at the latest.

Frequently asked questions

What harms a motorcycle most in winter?

Rarely the cold, but rather moisture, a dead battery and tires carrying the load for months. The ADAC (German automobile club) names a dry, well-ventilated and not too warm basement or garage as a good storage spot. The ADAC advises against airtight tarps because condensation forms underneath.

Should you remove the motorcycle battery in winter?

The ADAC advises removing it, charging it fully and storing it at around 10 °C. When removing it, disconnect the negative terminal first and reconnect it last when reinstalling. Charge it at around 20 °C, not in living rooms or bedrooms. If the battery stays in the motorcycle, the ignition must not be switched on while charging.

Which charger for the motorcycle battery?

What you want is an automatic charger that can stay connected permanently and handles lithium batteries, if one is fitted. According to the ADAC, powerful car and hardware-store chargers can damage small motorcycle batteries. The CTEK CT5 Powersport offers programs for lead-acid including AGM, lithium and reconditioning.

Store over winter with a full or empty tank?

That depends on the material. The ADAC recommends filling a steel tank to the brim if the motorcycle is on its center stand. Plastic tanks should be as empty as possible, because fuel components can diffuse through the wall. When in doubt, follow the vehicle manual.

How do you prevent flat spots on motorcycle tires?

The ADAC recommends raising the tire pressure by about 0.5 bar above the operating pressure and taking the load off the wheels with a center stand or paddock stand. If that is not possible, push the bike a little every few weeks. In spring, lower the pressure back to the normal value.

Is a fuel stabilizer dangerous?

It is not a harmless care product. Liqui Moly labels its Motorbike Benzinstabilisator with the signal word "Danger," among other things because swallowing it can be fatal. So wear gloves, store it out of reach of children and do not smoke while filling. For a plastic tank that spends the winter empty, the product is unnecessary.

Sources

Where to buy

Shop in:

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.

Still undecided?

Keep comparing at your own pace – every article in this category is checked monthly for new and discontinued models.

Share this guide