Black Friday Woche ab 19.11.: unsere Wahl je Ratgeber
Independent buying adviceEvery claim with a sourceNo paid verdictsIn 36 countries1,734 guides and reviews in German How we test
handgetestet

Deutsch

Outdoor Cable Connectors 2026: Gel Joint, Gel Box, Buried Cable

Outdoor cable connectors: gel joint, gel box or IP68 T-connector, what NYY buried cables need, what DIN EN 50393 tests and when a qualified electrician has to do the job.

handgetestet editorial team · Updated November 17, 2026
Heidemann ISO FLEX gel joint with connecting terminalImage: ELV (Pressebild)
Contents12 sections

This guide was first published in German on handgetestet.de.

Electrical tape and a terminal strip last exactly one summer in a flower bed. If you connect a cable in the garden, in the ground or in a damp room, you need a connection that is permanently sealed against water. For 230-volt buried cables, we consider a prefilled gel joint such as the Heidemann ISO FLEX Gelmuffe M (gel cable joint) the cleanest solution; for individual wires in a junction box, a small gel box is enough.

Clarify first: who is allowed to do this?

This question comes first. Under Section 13 of the German Low Voltage Connection Ordinance (Niederspannungsanschlussverordnung), only the grid operator or a company entered in an installer register may install, extend or modify an electrical system behind the main service fuse. A new buried cable to the garden shed falls under this. Pure maintenance is exempt, with the exception of the section between the main service fuse and the meter. Heidemann also states in the instructions for the Gelmuffe that the product is intended exclusively for installation by a qualified electrician. Our reading: with 230 volts in the ground, the electrician does the work; you can prepare the trench, the protective conduit and the materials. How garden lighting with 12 or 24 volts behind a plug-in transformer differs from this is explained in our guide to mains-powered garden lighting.

Cable and protection rating go together

A cable such as NYY-J belongs in the ground. In its data sheet, Helukabel describes it as a cable for ground, water and open air where no mechanical damage is to be expected. According to the data sheet, it is laid at temperatures from minus 5 degrees, and the bending radius for multi-core cables is at least twelve times the outer diameter. The connection has to withstand the same as the cable. A test mark helps here: joints according to DIN EN 50393 are tested for watertightness under water and current-carrying capacity. IP68 alone only says that something may be permanently submerged, under the conditions the manufacturer specifies.

Seven connectors compared

ModelDesignConductors and cablesUse
Heidemann ISO FLEX Gelmuffe MPrefilled gel joint, terminal block 5 × 2.5 mm²NYM/NYY 3–5 × 1.5 to 2.5 mm², branch 3–5 × 1.5 mm², 0.6/1 kV, DIN EN 50393Connecting or branching buried cables
Heidemann ISO FLEX Gelbox mit 2 VerbindungsklemmenGel box 40 × 40 × 22 mm, IP68Individual wires 0.2 to 2.5 mm², 450 V, 32 AWires in a junction box or light base
Heidemann ISO FLEX Gel-SetTwo-component gel 190 ml, junction box, terminal blockNYM/NYY up to 5 × 4 mm²Branch with several cables
Heidemann ISO FLEX Kabelverbinder T-Stück IP68Plug-in T-connector, 3-pole0.75 to 1.5 mm², 450 V, 17.5 ABranching a string of lights
Heidemann ISO FLEX Reparaturset WAGO-Durchgangsverbinder6 connectors, 3 heat-shrink tubes with adhesive0.75 to 4 mm² solidRepairing a single wire
WAGO Gelbox 207-1432Gel box size 2, without terminalsWAGO terminals series 221 up to 6 mm²Anyone already working with WAGO 221
Raytech Super Clik 1Prefilled gel joint with terminalsMulti-core cables up to 5 cores, 0.6/1 kV, EN 50393Buried cables, alternative to the Heidemann joint

Heidemann ISO FLEX Gelmuffe M

Our main recommendation for the buried cable to the flower bed or the pump. The joint comes prefilled with a terminal block and two cable ties for strain relief. According to the instructions, a maximum of 20 millimeters of sheath may be removed on each side, and the exposed area between the sheaths must not exceed 50 millimeters. Gel escaping when you close it is normal. After that, according to Heidemann, the connection is considered watertight and tread-resistant. Limit: 2.5 mm² main cable. Thicker supply cables need a different size.

Heidemann ISO FLEX Gelbox mit 2 Verbindungsklemmen

The Gelbox mit 2 Verbindungsklemmen (gel box with two connecting terminals) is the inexpensive solution for individual wires, for example in the damp base of a path light. According to ELV (German retailer), it is watertight down to 1.5 meters, 450 volts, 32 amps. The retailer’s description says nothing about burying it in the ground. For the ground, the joint is therefore the safer choice.

Heidemann ISO FLEX Gel-Set

A junction box with twelve entries is filled with two-component gel after wiring. At 20 degrees, curing takes about 50 minutes according to the instructions; in the cold, it takes longer. The gel can be removed again later. For a distribution point with three or four cables, this is a better fit than several joints. Store the pouch dry and frost-free.

Heidemann ISO FLEX Kabelverbinder T-Stück IP68

The Kabelverbinder T-Stück (T-connector) is pluggable, 97 millimeters long, for conductors up to 1.5 mm² and, according to ELV, rated from minus 40 to plus 85 degrees. Handy for a string of garden lights. For 2.5 mm² buried cables, it is too small.

Heidemann ISO FLEX Reparaturset WAGO-Durchgangsverbinder

Six WAGO inline connectors and three heat-shrink tubes with inner adhesive that shrink from 9.5 to 3 millimeters at 110 degrees and above. This Reparaturset (repair kit) is meant for a gnawed wire, not for an entire buried cable. Stripping and clean shrinking are easier with tools from our guide to crimping and wire stripping pliers.

WAGO Gelbox 207-1432

If you already work with WAGO lever connectors of the 221 series, you put the finished connection into this box. WAGO describes it as ready to use immediately, re-accessible and silicone-free; according to WAGO, IPX8 applies to the complete system of box and WAGO terminal. Terminals are not included. As areas of use, WAGO names bathrooms, irrigation systems, swimming pool areas and parking lot lighting, but not the ground.

Raytech Super Clik 1

The alternative on Amazon. Raytech describes the Super Clik joints as prefilled, for straight connections and branches on cables with 0.6/1 kV and up to five cores, tested to EN 50393 with a water column, also usable under water and re-openable. One drawback: the manufacturer’s website is only available in Italian and English.

Our pick by situation

  • Extending an NYY buried cable 3 × 1.5 to 5 × 2.5 mm²: Heidemann Gelmuffe M or Raytech Super Clik 1.
  • Several cables at one point: Gel-Set with junction box.
  • Wires in a damp junction box: Gelbox; with WAGO 221 terminals, the WAGO Gelbox.
  • String of lights up to 1.5 mm²: T-Stück.

One detail is often forgotten. Where a cable leads into a surface-mounted box outdoors, the entry does the sealing, not the gel. Spelsberg specifies the KVR M25-MGM cable gland for unprotected outdoor areas with IP68 and a sealing range of 9 to 16 millimeters, UV-resistant. Before any work: disconnect the power and verify that it is dead, with a two-pole tester from our multimeter guide and insulated tools from our guide to VDE-rated tools.

How the buried cable becomes an outlet by the flower bed is shown in our guide to the garden outlet post.

If you need power at several spots in the garden, our review of the MONZANA Gartensteckdose covers an outlet post for a ground spike or a board.

Frequently asked questions

Can I connect a buried cable myself?

A new buried cable to the garden shed falls under Section 13 of the German Low Voltage Connection Ordinance (Niederspannungsanschlussverordnung); responsibility lies with the grid operator or registered installers. Heidemann intends the Gelmuffe exclusively for installation by a qualified electrician. You can prepare the trench, the protective conduit and the materials.

What is the difference between a gel joint and a gel box?

The gel joint connects or branches entire multi-core buried cables and, in Heidemann's case, is tested to DIN EN 50393. A gel box only takes individual wires, for example in the damp base of a path light. The retailer's description of the Heidemann Gelbox says nothing about burying it in the ground.

Is IP68 enough for a connection in the ground?

IP68 only says that something may be permanently submerged, under the conditions specified by the manufacturer. DIN EN 50393 is more meaningful: joints according to this standard are tested for watertightness under water and current-carrying capacity. The connection has to withstand the same as the cable.

Which cables fit the Gelmuffe M?

According to Heidemann, NYM or NYY cables with 3 to 5 cores of 1.5 to 2.5 mm²; thicker supply cables need a different size. A maximum of 20 millimeters of sheath may be removed on each side, and the exposed area between the sheaths must not exceed 50 millimeters.

How do I connect several cables at one point?

The Heidemann Gel-Set is the right fit for that: a junction box with twelve entries is filled with two-component gel after wiring. At 20 degrees, it cures in about 50 minutes according to the instructions; in the cold, it takes longer. The gel can be removed again later.

How do I seal the cable entry into an outdoor box?

There, the entry does the sealing, not the gel. Spelsberg specifies the KVR M25-MGM cable gland for unprotected outdoor areas with IP68 and a sealing range of 9 to 16 millimeters, UV-resistant. Before any work: disconnect the power and verify that it is dead.

Sources

Where to buy

Shop in:

Sale, delivery, warranty and product safety are the sole responsibility of the respective retailer and manufacturer. All information without guarantee; prices and availability may change.

Links marked as affiliate links earn us a small commission if you buy through them. The price stays the same for you, and our verdict stays independent. As an Amazon Associate we earn from qualifying purchases.