Contents13 sections
This guide was first published in German on handgetestet.de.
The power is out and the fridge is full. In a situation like that, but also on a camping weekend or in a workshop without a hookup, the mid-range class is the right choice: around 1,000 Wh, a LiFePO4 battery and at least 1,500 W of continuous output. That runs the fridge, router and lights, and it also covers most tools. Among the units compared here, the strongest case in this class is for the EcoFlow DELTA 3 Plus: in spring 2025, the German automobile club ADAC gave it a grade of 2.1 (on the German scale, where 1 is best) and confirmed its continuous output.
If you only want to charge a phone, laptop and cooler, you need no more than a unit of around 300 Wh. A circular saw, a fan heater or several days of backup power call for the 2 kWh class.
Two numbers you must not confuse
Capacity in watt-hours (Wh) tells you how long the power lasts. Capacity divided by consumption gives a rough runtime in hours. Because of conversion losses, however, only about 80 to 85 percent actually arrives at the outlet.
Whether a device starts at all is determined by the continuous output in watts (W). An electric kettle often draws 2,000 W, a battery charger only 100 W. And the peak output printed in large type? It only helps briefly when motors and compressors start up. If you buy based on that figure, you will regret it later.
Battery, switchover time, solar: where the units differ
All seven models here use lithium iron phosphate (LiFePO4, or LFP for short). This chemistry is considered robust and long-lasting, and manufacturers state 3,000 to 4,000 charge cycles until capacity drops to 70 or 80 percent. So there is no trade-off to weigh on battery technology.
The UPS function is a different story. If the power station is connected to the grid, it takes over by itself during an outage, and the shorter the switchover time, the more likely the PC and router keep running without a restart. Under 10 milliseconds is good. At 20 milliseconds, a sensitive computer may restart. None of these units replaces a true online UPS for servers.
For the solar input, what counts is the maximum power in watts and the voltage range, and a high input rating only helps if a correspondingly large number of panels is connected.
Weight cannot be wished away. A 1 kWh unit weighs 11 to 17 kg, one with 2 kWh around 19 to 28 kg. Some models grow with extra batteries, others do not. Fast charging from the grid pays off when a power outage has been announced or when there is little time between two jobs.
Never feed the home grid through an outlet
A power station only powers what is plugged directly into its own outlets. Never connect it to the home grid with a plug to supply „the whole house.“ That is dangerous and may put people working on the grid at risk. A permanent connection to the home’s electrical system is a job for a licensed electrician, who installs a suitable transfer switch for it.
Seven power stations from 300 Wh to 2 kWh
| Model | Capacity / continuous output | Solar input / UPS | Best for |
|---|---|---|---|
| EcoFlow RIVER 3 Plus | 286 Wh / 600 W | 220 W / under 10 ms | Light camping, router backup power |
| EcoFlow DELTA 3 Plus | 1,024 Wh / 1,800 W | 1,000 W / under 10 ms | All-rounder with lots of solar |
| Anker SOLIX C1000 Gen 2 | 1,024 Wh / 2,000 W | 600 W / 10 ms | Workshop, fast charging |
| Jackery Explorer 1000 v2 | 1,070 Wh / 1,500 W | 400 W / up to 20 ms | Lightweight 1 kWh unit |
| Bluetti AC180 | 1,152 Wh / 1,800 W | 500 W / 20 ms | A bit more capacity |
| Anker SOLIX C2000 Gen 2 | 2,048 Wh / 2,400 W | 800 W / 10 ms | Backup power for several days |
| Bluetti AC200L | 2,048 Wh / 2,400 W | 1,200 W / 20 ms | Expandable up to 8 kWh |
All values according to manufacturer specs for the European 230 V version.
For the tent and the router: EcoFlow RIVER 3 Plus
According to EcoFlow, the RIVER 3 Plus weighs around 4.7 kg. It is designed for phones, laptops, cameras and lights. In X-Boost mode, devices up to 1,200 W also run, though at reduced power. With extra batteries, it grows to up to 858 Wh according to the manufacturer. As a buffer for a router or fiber modem, it is an inexpensive solution from the lower price segment.
For lots of sun: EcoFlow DELTA 3 Plus
Its most striking feature is two solar inputs with a combined maximum of 1,000 W. On the grid, the DELTA 3 Plus is said to be full in about 56 minutes at 1,500 W. Extra batteries expand it to up to 5 kWh, the USB-C ports deliver up to 140 W, and it weighs around 12.5 kg. If you work seriously with solar panels, you get the most balanced package here.
For the workshop: Anker SOLIX C1000 Gen 2
No other unit in the 1 kWh class here delivers more continuous output: 2,000 W, briefly 3,000 W. For tools in the workshop and garden, that is exactly what counts. According to Anker, in fast-charging mode it is full in 49 minutes at 1,600 W.
It cannot be expanded. Extra batteries do not fit.
For anyone who has to carry it: Jackery Explorer 1000 v2
At around 10.8 kg, the Explorer 1000 v2 is the lightest 1 kWh unit in the comparison. Its 1,500 W of continuous output is enough for a fridge, coffee maker or drill, and Jackery states 4,000 cycles to 70 percent remaining capacity. The 400 W solar input is on the tight side. For camping with one or two panels, it is enough. In spring 2025, the ADAC downgraded the Explorer 1000 v2 to „poor“ because its two DC inputs are not decoupled. So never charge it via solar and the vehicle socket at the same time, or the 12-volt vehicle electrical system may be damaged.
For a little more reserve: Bluetti AC180
1,152 Wh, a little more than the other units in the 1 kWh class. In Power Lifting mode, heating appliances such as kettles or hair dryers up to 2,700 W run at reduced power. According to Bluetti, it charges from the grid at 1,440 W in 1.3 to 1.8 hours. Then again, nobody likes carrying around 16 to 17 kg very far.
For several days off the grid: Anker SOLIX C2000 Gen 2
2,048 Wh, 2,400 W of continuous output. According to Anker, grid and solar together charge the C2000 Gen 2 fully in 58 minutes, and with an extra battery it reaches about 4 kWh. For this size, around 18.9 kg is a reasonable figure.
For later expansion: Bluetti AC200L
Up to 8,192 Wh is possible with extra batteries, according to Bluetti, and that is exactly why you buy the AC200L. The solar input handles up to 1,200 W at a maximum of 145 V, which also makes it suitable for longer panel strings. In return, you are hauling around 28 kg. Hardly anyone takes it to the campsite. In the house or the workshop, it is in the right place.
Which type are you?
If you camp light and also want to back up your router, go with the EcoFlow RIVER 3 Plus. For a motorhome with solar, the DELTA 3 Plus is the recommendation; the ADAC gave it a grade of 2.1 in spring 2025. In the workshop and garden, the high continuous output of the Anker SOLIX C1000 Gen 2 tips the balance. If your PC and router need to survive a power outage, choose a model with a switchover time of 10 ms at most, such as the DELTA 3 Plus or the Anker SOLIX C1000 Gen 2. For backup power at home over several days, the Anker SOLIX C2000 Gen 2 is the right fit. If you want to expand later, the Bluetti AC200L is the better starting point.
How much capacity you need for a power outage is calculated in our guide backup power with a power station (in German), and the right size for the tent in our guide power stations for camping (in German).
Whether an extra battery or a larger unit makes more sense is covered in our guide power stations with extra batteries (in German).
Sorted by size: our guide to the large power station from 3 kWh is aimed at the home, the one on the small power station up to 300 Wh (in German) at travelers.
What distinguishes LFP and NMC cells is explained in our guide LiFePO4 power stations; charge level and storage in our guide storing a power station.
If you already lean toward a brand: our overview of all Jackery models sorts the Explorer units by use, and there are direct comparisons of Jackery and EcoFlow, Jackery and Bluetti (in German), and Jackery and Anker Solix (in German).
Frequently asked questions
What is the difference between capacity and continuous output?
Capacity in watt-hours tells you how long the power lasts: capacity divided by consumption gives a rough runtime, though because of conversion losses only about 80 to 85 percent actually arrives. Continuous output in watts determines whether a device starts at all. Peak output only helps briefly when motors start up.
Can a power station keep a PC running during a power outage?
With a UPS function, it takes over by itself when the grid fails. The shorter the switchover time, the more likely the PC and router keep running without a restart: under 10 milliseconds is good, while at 20 milliseconds a sensitive computer may restart. None of these units replaces a true online UPS for servers.
Can you feed a power station into the home grid through an outlet?
No. That is dangerous and can endanger people working on the grid. A power station only powers what is plugged directly into its own outlets. A permanent connection to the home's electrical system is a job for a licensed electrician, who installs a suitable transfer switch for it.
How long does a LiFePO4 battery last?
All seven models in the comparison use lithium iron phosphate, which is considered robust and long-lasting. Manufacturers state 3,000 to 4,000 charge cycles until capacity drops to 70 or 80 percent. So in this selection, there is no trade-off to weigh on battery technology.
Which power station suits a workshop?
In the workshop and garden, continuous output is the deciding factor. In the 1 kWh class, the Anker SOLIX C1000 Gen 2 delivers 2,000 W, briefly 3,000 W, and according to Anker is fully charged in 49 minutes in fast-charging mode. However, it cannot be expanded; extra batteries do not fit.
What should you watch out for with the Jackery Explorer 1000 v2?
At around 10.8 kg, it is the lightest 1 kWh unit in the comparison. In spring 2025, the ADAC downgraded it to "poor" because its two DC inputs are not decoupled. So never charge it via solar and the vehicle socket at the same time, or the 12-volt vehicle electrical system may be damaged.
Sources
- EcoFlow: RIVER 3 Plus
- EcoFlow: DELTA 3 series
- Anker SOLIX: C1000 Gen 2
- Anker SOLIX: C2000 Gen 2
- Jackery: Explorer 1000 v2
- Bluetti: AC180
- Bluetti: AC200L
- ADAC: Portable power stations tested (spring 2025)
Where to buy
- EcoFlow RIVER 3 PlusCheck price at Amazon.deAvailable in Germany: Amazon.de
- EcoFlow DELTA 3 PlusCheck price at Amazon.deAvailable in Germany: Amazon.de
- Anker SOLIX C1000 Gen 2Check price at Amazon.deAvailable in Germany: Amazon.de
- Jackery Explorer 1000 v2View at JackeryAvailable in Germany: Jackery
- Bluetti AC180Check price at Amazon.deAvailable in Germany: Amazon.de
- Anker SOLIX C2000 Gen 2Check price at Amazon.deAvailable in Germany: Amazon.de
- Bluetti AC200LCheck price at Amazon.deAvailable in Germany: Amazon.de
