Contents8 sections
This guide was first published in German on handgetestet.de.
With a heat pump or a wallbox, a household’s electricity consumption rises significantly. That makes the price per kilowatt hour all the more important, and not just your supplier’s energy rate, but also the grid fee that is built into every kilowatt hour and varies by grid area. Since 2024, there has been a dedicated lever for this. If you register your heat pump or wallbox with the grid operator as a controllable consumption device, you pay significantly lower grid fees. On top of that comes choosing the right tariff, with or without a separate meter.
What “controllable” means
Under Section 14a of the German Energy Industry Act (Energiewirtschaftsgesetz, EnWG), private wallboxes, heat pumps including their heating element, air conditioners and battery storage systems count as controllable consumption devices if they are connected to the grid with more than 4.2 kilowatts. For systems that have gone into operation since January 1, 2024, these rules apply automatically. According to the Bundesnetzagentur (German Federal Network Agency), older systems without an agreed control arrangement remain permanently excluded but may switch voluntarily. The grid operator may not refuse this switch. That is clearly regulated. Existing systems that had already agreed to a control arrangement will be transferred to the new rules by the end of 2028.
In return, the grid operator may temporarily throttle the power draw to 4.2 kilowatts in the event of an imminent overload. It may not switch the device off. Ever. So the heat pump keeps heating and the car keeps charging, just more slowly. According to the Bundesnetzagentur, it may only do this when the grid is acutely at risk. As a transitional measure, preventive control of up to two hours a day is also permitted, for a maximum of 24 months. During that time, an electric car should as a rule still be able to recharge about 50 kilometers of range in two hours.
Three modules for lower grid fees
The Bundesnetzagentur has set out three variants, the so-called modules. If you make no choice, Module 1 applies automatically.
| Module | How it works | Requirement | Best for |
|---|---|---|---|
| Module 1: flat-rate grid fee reduction | fixed discount per year, according to the Bundesnetzagentur 110 to 190 euros depending on the grid area (as of 2023) | no additional requirement | Default if there is no separate meter |
| Module 2: energy rate discount with a separate meter | grid fee energy rate lowered by 60 percent | separate meter, no base charge for it | Heat pumps with high consumption |
| Module 3: time-variable grid fee | three price levels over the course of the day | only in addition to Module 1, smart metering system | Anyone who can charge or heat flexibly |
Module 1 and Module 2 are mutually exclusive. Which one pays off depends on consumption. For an electric car using 2,500 kilowatt hours a year, Module 1 lowers the grid fee by 50 to 95 percent according to the Bundesnetzagentur, without any second meter. The flat rate applies per connection, not per device. The agency considers Module 2 particularly suitable for heat pumps. Switching between Module 1 and 2 is possible, but not retroactively. Modules 2 and 3 cannot be combined. Do the math with the figures from your grid operator’s price sheet, which must list all modules.
Who gets the reduction
You are not billed directly. The grid operator bills your electricity supplier, and the supplier shows the reduction on your bill. According to the Bundesnetzagentur, passing it on is not mandatory; it depends on the supply contract. Check this before signing. If your supplier does not pass on the discount, switching may make sense.
Which electricity tariff fits
With a separate meter for the heat pump, you can take out a dedicated heat pump tariff, separate from your household electricity. Without a separate meter, everything runs through one contract, and then a good household tariff is what matters most. If you have a smart metering system, a dynamic tariff is also an option. Since January 1, 2025, Section 41a EnWG has required every electricity supplier to offer such a tariff to customers with a smart metering system. With a wallbox and a heat pump, a lot of consumption can be shifted to the cheaper hours, and that is exactly what these tariffs are designed for.
How to register your system
- Choose the control method: directly at the device or via an energy management system.
- Notify the grid operator of commissioning in advance (Section 19 (2) of the German Low Voltage Connection Ordinance, Niederspannungsanschlussverordnung).
- Commission the metering point operator or grid operator to install a smart metering system and control unit. According to the Bundesnetzagentur, placing the order is already enough for the reduced grid fee, even if installation comes later.
- Compare the modules in the grid operator’s price sheet and choose the right one. If you make no choice, Module 1 applies.
- Check your electricity bill to see whether the supplier shows the reduction.
As the operator, you bear the costs of the metering and control technology. Since 2024, the Bundesnetzagentur no longer requires a separate metering point. For Module 2, you still need one. Running the numbers pays off.
Mistakes that cost money
First: replacing the heat pump and thinking the old status remains. According to the Bundesnetzagentur, a new device, even the same model, loses grandfathered status. An expensive mistake. Second: counting on the module choice when selling the house. It does not transfer. The new operator falls back to Module 1. Third: forgetting the photovoltaics. They are not counted toward the 4.2 kilowatts and are not switched off.
Frequently asked questions
Can the grid operator refuse my new heat pump?
No. According to the Bundesnetzagentur, it may not refuse or delay the connection by pointing to a local overload.
Does my battery storage count?
Yes, if its charging can affect the power drawn from the grid, even if it only stores solar power today.
Does this also apply to small devices?
No. New systems up to 4.2 kilowatts are not covered. Several heat pumps or air conditioners are added together, however.
Will I find out when my device was throttled?
Since March 1, 2025, grid operators have had to publish their control interventions on a joint platform.
No wallbox yet? Our guide to the wallbox and the one on charging cables for electric cars will help you buy. How to avoid traps with bonuses and price guarantees is explained in the guide Switching electricity providers.
What the new digital meter costs and when it is mandatory is explained in the guide Smart meter.
If you can schedule your heat pump or electric car, you should also take a look at the dynamic electricity tariff (in German).
How fans on regular radiators can make a lower flow temperature possible is described in the guide to the radiator fan.
In rented buildings or condominium associations, separate rules apply; see Charging an electric car in an apartment building.
Frequently asked questions
What does controllable consumption device mean for heat pumps and wallboxes?
Under Section 14a EnWG, this includes private wallboxes, heat pumps including their heating element, air conditioners and battery storage systems if they are connected to the grid with more than 4.2 kilowatts. For systems from January 1, 2024, this applies automatically. In the event of an imminent overload, the grid operator may throttle them to 4.2 kilowatts, but never switch them off.
Which module for lower grid fees is right for me?
Module 1 grants a fixed discount per year and does not need an additional meter; it applies automatically if you make no choice. Module 2 lowers the grid fee energy rate by 60 percent but requires a separate meter. Module 3 with time-variable grid fees is only available in addition to Module 1 and with a smart metering system.
Is registering worthwhile for an electric car?
For an electric car using 2,500 kilowatt hours a year, Module 1 lowers the grid fee by 50 to 95 percent according to the Bundesnetzagentur, without any second meter. When throttled, an electric car should as a rule still be able to recharge about 50 kilometers of range in two hours.
Do I get the grid fee reduction automatically?
Not necessarily. The grid operator bills your electricity supplier, and the supplier shows the reduction. According to the Bundesnetzagentur, passing it on is not mandatory; it depends on the supply contract. If your supplier does not pass on the discount, switching may make sense.
Which electricity tariff suits a heat pump?
With a separate meter, you can take out a dedicated heat pump tariff, separate from your household electricity. Without a separate meter, what matters most is a good household tariff. With a smart metering system, a dynamic tariff is an option, which every electricity supplier has had to offer since January 1, 2025.
Which mistakes cost money with heat pumps and wallboxes?
According to the Bundesnetzagentur, a new device, even the same model, loses grandfathered status. When a house is sold, the module choice does not transfer, and the new operator falls back to Module 1. Photovoltaics are not counted toward the 4.2 kilowatts and are not switched off.
Sources
- Bundesnetzagentur: Integration of controllable consumption devices under Section 14a EnWG
- Bundesnetzagentur: Determination of November 27, 2023
- Section 41a EnWG: dynamic electricity tariffs
Where to buy
- Modul 1: pauschale Netzentgelt-ErmäßigungView at CHECK24Available in Germany: CHECK24
- Modul 2: Arbeitspreis-Rabatt mit eigenem ZählerView at CHECK24Available in Germany: CHECK24
- Modul 3: zeitvariables NetzentgeltView at CHECK24Available in Germany: CHECK24
