Contents13 sections
This guide was first published in German on handgetestet.de.
You do not buy Homematic IP as a device but as a decision for a wireless system. The most important question therefore comes before the first thermostat: should the logic live in the cloud or in your own home? For getting started with heating, we consider the Starter Set Raumklima („room climate“) the most sensible purchase, because it brings thermostats, a wall thermostat and window contacts together right away. If you need rules without internet, plan on the Home Control Unit from the start.
This article explains the system. Our guide to smart home starter sets compares brands, the guide to smart home hubs covers cross-brand hubs, and the wired version for new builds is in the guide to Homematic IP Wired.
How does Homematic IP actually communicate?
On its own frequency. According to the user manual, the devices transmit in the 868 MHz band and thereby stay away from the crowded 2.4 GHz band used by Wi-Fi and Bluetooth. They do not speak Zigbee or Thread. Third-party wireless sensors therefore cannot simply be paired, and a Homematic IP thermostat will not register with any Zigbee hub.
Every command is acknowledged by the receiver, so the app knows the actual state, and according to the manufacturer, all radio packets are encrypted with AES-128. The often-quoted 400 meters apply to the Access Point in open terrain; according to ELV (German retailer), a radiator thermostat reaches 230 meters. That does not account for reinforced concrete ceilings. If the signal is not enough, mains-powered devices acting as relays or an additional Access Point help.
One quirk catches almost every newcomer: the duty cycle limit. By law, each device may only transmit for 1 percent of an hour, which is 36 seconds. According to eQ-3, that limit is usually not reached in everyday use, but it can be when pairing many devices in a row. A device then stays silent for up to one hour. That is not a defect.
Cloud or local: what happens when the internet goes down?
With the Access Point 2, programs and data live in the Homematic IP Cloud. According to the manufacturer, it is free of charge, runs on servers in Germany and requires no registration; apart from the IP address, nothing personal is recorded. If the connection drops, more keeps working than many people expect. Heating schedules keep running because they are stored in the devices, and so do direct links such as window contact and thermostat. According to the spec sheet, the alarm siren also sounds without the cloud.
Gone, on the other hand, are all if-then rules, the lockout, storm and heat protection of the shading, and voice control. In a house whose roller shutters depend on automations, that is a real difference. Light and shading groups keep working, which is why eQ-3 recommends groups instead of rules where both are possible.
The Home Control Unit turns this around. Rules and data live on the device, and in offline mode nothing goes to the cloud. Remote access, Alexa, Google Assistant and automatic updates are then no longer available, though, and it also needs internet for initial setup. Switching does not lock you out of anything: the app’s system transfer takes along devices, groups, automations and twelve months of measurement data. You then set up users and access rights again. The older CCU3 has been discontinued and is no longer a starting point.
Does Homematic IP support Matter?
That cannot be confirmed. In its FAQ, eQ-3 only writes that it is following the development of Matter and evaluating it on an ongoing basis. Neither the spec sheets of the hubs nor the Home Control Unit’s plugin list mention Matter; they list Philips Hue, EEBUS, MQTT and Modbus. According to the manufacturer, it does not offer integration with Apple HomeKit either. iPhone users therefore operate the system through its own app.
Where the system is strong and where it reaches its limits
Its strength is breadth under one roof. Heating, roller shutters, alarm, door lock and weather data run in one app, with no subscription for the basic functions and up to 15 users per installation. Many devices run on batteries that, according to the manual, last one to five years, which means rented apartments can be equipped without chiseling into walls.
The limits are just as clear. The Access Point tops out at 120 devices. If you want to integrate third-party devices beyond Philips Hue, you need the Home Control Unit and its plugins. Cameras run on Wi-Fi and report via the cloud: in September 2026, owners of the video doorbell and the battery-powered outdoor camera had to trigger a firmware update manually so that notifications kept arriving. And according to the spec sheet, voice control only arms the alarm, never disarms it. Sensible, but good to know.
Six sets, four ways into the system
| Set | Hub | Contents according to ELV | Starting point |
|---|---|---|---|
| Homematic IP Starter Set Raumklima | Access Point 2 | 4 radiator thermostats basic, wall thermostat, 2 window contacts | heating a whole apartment |
| Homematic IP Starter Set Heizen pure HmIP-SK28 | Access Point 2 | 2 radiator thermostats pure | trying out two rooms |
| Homematic IP Starter Set Rollladensteuerung HmIP-SK29 | Access Point 2 | 2 roller shutter actuators, 2 rocker switches | shading, neutral wire required |
| Homematic IP Set Sicherheit mit Außensirene | Access Point | Motion detector, window contact, alarm siren indoor and outdoor | alarm |
| Homematic IP Set Zutritt mit Keypad | Access Point 2 | Door lock drive, keypad | access with a code |
| Homematic IP Set Heizen Easy mit Home Control Unit | Home Control Unit | 4 radiator thermostats pure | heating with local logic |
Homematic IP Starter Set Raumklima
Four thermostats cover four radiators, and the two optical window contacts lower the temperature during ventilation more precisely than the thermostat’s own detection alone. The wall thermostat also measures humidity. If you want to save, put the advertised figure into perspective: the 33 percent is the manufacturer’s upper limit, not a promise. Drawbacks: the basic thermostats are operated with buttons, and with more than two windows, contacts are missing. Our guide to radiator thermostats (in German) shows the differences between thermostats.
Homematic IP Starter Set Heizen pure HmIP-SK28
The small way in („Heizen“ means heating): two thermostats with an e-paper display that, according to ELV, run for about three years on two AA cells, plus adapters for Danfoss valves. Up to three heating schedules with 13 changes per day each are possible. Entirely sufficient for two rooms, and you can buy contacts later as needed.
Homematic IP Starter Set Rollladensteuerung HmIP-SK29
The actuators of this roller shutter control set sit in the flush-mounted wall box and switch tubular motors up to 500 VA. Raising the shutters according to the sun’s position is part of the set; a neutral wire is mandatory. Installation must be done only by a qualified electrician in accordance with VDE 0100, the German electrical installation standard, as the instructions require. So check for the neutral wire before ordering. More on the technology is in the guide to smart roller shutter control (in German).
Homematic IP Set Sicherheit mit Außensirene
This security set is the Starter Set Alarm with an additional solar siren for outdoors, which according to the manufacturer reaches 100 dB and is buffered by three NiMH rechargeable batteries. The alarm is triggered via the direct connection between the devices even without the cloud, even if someone destroys the Access Point. The set still contains the older HmIP-HAP Access Point. The spec sheet does not list VdS approval; what that means is explained in the guide to alarm systems.
Homematic IP Set Zutritt mit Keypad
In this access set, the drive sits on the inside of the lock cylinder, with no drilling required. Standard cylinders must protrude 8 to 15 millimeters for this and have an emergency and hazard function; from the outside, the key remains usable. The keypad opens with a code. The slim Pro version HmIP-DLP with tamper sensors is also available as a set, but according to ELV the key then has to be shortened. General information on retrofitting is in the guide to smart locks.
Homematic IP Set Heizen Easy mit Home Control Unit
If you want rules without the cloud, this package spares you the detour via the Access Point. For four radiators, the hub is generously sized. Here you are paying for headroom: 350 devices, 120 of them wireless, plugins and energy data. The added value only shows once you really want automations running in the house.
So where should you start?
- Heating costs in view, several rooms: Starter Set Raumklima.
- Just two rooms for now: Starter Set Heizen pure.
- Roller shutters with a neutral wire in the wall box: Starter Set Rollladensteuerung, installed by a qualified electrician.
- Alarm without a subscription: Set Sicherheit mit Außensirene.
- Front door with a code: Set Zutritt mit Keypad, measure the cylinder first.
- No data in the cloud: Set Heizen Easy mit Home Control Unit, but without remote access in offline mode.
The guide Choosing a Homematic hub (in German) compares the Access Point 2, Home Control Unit and CCU3.
Three dedicated guides compare the sets in detail: heating sets (in German), shading sets and door lock drive and access.
Frequently asked questions
What frequency does Homematic IP use?
According to the user manual, the 868 MHz band, well away from the 2.4 GHz band used by Wi-Fi and Bluetooth. The devices do not speak Zigbee or Thread, so third-party wireless sensors cannot simply be paired. Every command is acknowledged by the receiver, and according to the manufacturer, the radio packets are encrypted with AES-128.
What works with Homematic IP without internet?
With the Access Point 2, heating schedules and direct links such as window contact and thermostat keep running, and so does the alarm siren. If-then rules, lockout, storm and heat protection, and voice control drop out. That is why eQ-3 recommends groups instead of rules where both are possible. The Home Control Unit keeps rules local.
Does Homematic IP support Matter or Apple HomeKit?
Matter cannot be confirmed. eQ-3 only writes that it is following the development and evaluating it on an ongoing basis; neither the spec sheets nor the plugin list mention Matter. According to the manufacturer, it does not offer integration with Apple HomeKit. iPhone users operate the system through its own app.
Why does a Homematic IP device suddenly stop responding?
Often it is the duty cycle limit. By law, each device may only transmit for 1 percent of an hour, which is 36 seconds. According to eQ-3, that limit is usually not reached in everyday use, but it can be when pairing many devices in a row. The device then stays silent for up to one hour; that is not a defect.
Which Homematic IP set is right for getting started?
For several rooms with an eye on heating costs, the Starter Set Raumklima fits; for two rooms, the Starter Set Heizen pure. The Starter Set Rollladensteuerung controls roller shutters where a neutral wire is present, installed by a qualified electrician. If you want no data in the cloud, take the Set Heizen Easy with Home Control Unit.
Where does Homematic IP reach its limits?
The Access Point tops out at 120 devices. Third-party devices beyond Philips Hue need the Home Control Unit and its plugins. Cameras run on Wi-Fi and report via the cloud. According to the spec sheet, voice control only arms the alarm, never disarms it.
Sources
- Homematic IP: Comparison of the hubs (PDF)
- Homematic IP: User manual (PDF)
- Homematic IP: FAQ
- Homematic IP: Home Control Unit
- Homematic IP: Plugins
- Homematic IP: System transfer to the Home Control Unit
- Homematic IP: Firmware notice for the video doorbell and battery-powered outdoor camera
- Spec sheet radiator thermostat basic (PDF)
- Spec sheet Starter Set Alarm (PDF)
- Spec sheet outdoor alarm siren (PDF)
- Instructions roller shutter actuator for branded switches (PDF)
- ELV: Starter Set Raumklima (retailer information)
- ELV: Starter Set Heizen pure (retailer information)
- ELV: Starter Set Rollladensteuerung (retailer information)
- ELV: Set Sicherheit mit Außensirene (retailer information)
- ELV: Set Zutritt (retailer information)
- ELV: Set Heizen Easy (retailer information)
Where to buy
- Homematic IP Starter Set RaumklimaView at ELVAvailable in Germany: ELVCheck price at Amazon.deAvailable in Germany: Amazon.de
- Homematic IP Starter Set Heizen pure HmIP-SK28View at ELVAvailable in Germany: ELVCheck price at Amazon.deAvailable in Germany: Amazon.de
- Homematic IP Starter Set Rollladensteuerung HmIP-SK29View at ELVAvailable in Germany: ELVCheck price at Amazon.deAvailable in Germany: Amazon.de
- Homematic IP Set Sicherheit mit AußensireneView at ELVAvailable in Germany: ELV
- Homematic IP Set Zutritt mit KeypadView at ELVAvailable in Germany: ELVCheck price at Amazon.deAvailable in Germany: Amazon.de
- Homematic IP Set Heizen Easy mit Home Control UnitView at ELVAvailable in Germany: ELV
